The amount of heat in kJ required to convert 0.7 gal of liquid water to steam equal… ?
Q: In cation exchange chromatography,
A: Any positively charged ions that come into contact with the resin will be exchanged with other…
Q: As the temperature decreases, what happens to the volume?
A: As we increase the temperature of the system, more energy is supplied to the atoms. So, at higher…
Q: What conditions are defined as STP?
A: Standard Temperature and Pressure (STP) is a standard reference point of temperature and pressure.
Q: At high concentration which oxides are poisonous?
A: The major contributors of the air pollution are nitrogen oxides. They have role in the formation of…
Q: Why is it necessary to specify the temperaturewhen making a table listing ∆G values?
A: ∆G is defined the change of Gibbs (free) energy for a system; ∆G° is the Gibbs energy change for a…
Q: A quantity of gas in a piston cylinder had a volume of 0.539 m^3 and a pressure of 200 Pa. the…
A: According to the question, A quantity of gas in a piston-cylinder had a volume of 0.539 m^3 and a…
Q: A 10.00 mg sample of technetium-93 (92.91024898 u) is used to heat 125.4 g o
A:
Q: Why oil gets hot faster than the water?
A: Lipids are macromolecules that help in the structure and function of the living body. They are not…
Q: Which of the following reagents can be used in the reaction in the photo? A.) pyridinium…
A: The oxidation of secondary alcohol to ketones is an important oxidation reaction in organic…
Q: How can the temperature of steam be raised above 100°C? Whichinstrument is based on this technique…
A: Steam is generated after the water boils. At normal atmospheric pressure, water boils at 100°C, and…
Q: How many kilojoules are released by freezing 2.5 mol of H2O?
A: Enthalpy of freezing (∆Hfree) is used to calculate energy needed to release when liquid becomes…
Q: Combustion of a fuel sample in a bomb calorimeter increases the temperature of the entire system by…
A: Given: Mass of water (m1 )=1700 gIncrease in temperature(∆T1)=5.10°CMass of water(m2)=2200Increase…
Q: Two air flows are combined to a single flow. One flow is 1 m3/s at 20oC and the other is 2 m3/s at…
A: The ideal gases follow PV=nRT. Here, ‘n’ is the number of moles of particles of a gas. The pressure…
Q: Which are the two forces that make up the electrochemical?
A: The active transport of ions across the cell membrane causes an electrical gradient to build across…
Q: What are the Basic Principles of Electricity?
A: electricity is the flow of electrons.
Q: The vapour pressure of water at blood temperature is 47 Torr. What is the partial pressure of dry…
A: Vapour pressure is a measure of the tendency of a material to change into the gaseous or vapour…
Q: How many kilocalories are needed to vaporize 5.8 mol of Br2?
A: Bromine is a dark reddish-brown fuming liquid with a pungent odor. Denser than water and soluble in…
Q: Where in the periodic table are the best reducing agents found? The best oxidizing agents?
A: The reducing agents are the elements that reduces other elements and in the process, gets oxidized.…
Q: How many moles of chlorine gas at 120. °C and 33.3 atm would occupy a vessel of 39.0 L?
A: The ideal gas law is the equation of state of a hypothetical ideal gas. It is a good approximation…
Q: What two quantities are being compared in the graph?
A: HIV or the human immunodeficiency viruses is a type of Lentivirus (a subgroup of the retrovirus,…
Q: Why do containers of water, milk, soda, or other liquids sometimes burst when frozen?
A: A solid state is the state in which matter maintains fixed volume and shape. In this state, matter…
Q: How many moles of tungsten(VI) oxide and hydrogen were required to produce the 5.00 g of tungsten?
A: Stoichiometry is a section of chemistry that involves using relationships between reactants and/or…
Q: If the cells of your body oxidize 1 mole of glucose, by how much would the temperature of your body…
A: Specific heat capacity is defined as the amount of energy required to raise the temperature of 1 kg…
Q: An aqueous solution containing 30mol% NaCl is used to produce NaOH by electrolysis. At the anode,…
A: Aqueous solution containing 30 ml % NaCl is used to produce NaDH by electrolysis A+ anodal - CL2 gas…
Q: Why is 350°C water emitted from a black smoker not boiling?
A: Black smokers are one of the types of hydrothermal vents that are found in deep sea beds and appear…
Q: Can you explain on your own words why the thermometer should not be shaken rigorously to lower the…
A: Glass thermometer containing mercury that helps to record the body temperature.
Q: Would it be possible to skate on “dry ice,” that is, solid CO2?
A: Dry ice is the solid form of carbon dioxide and is used primarily as a cooling agent, but is also…
Q: When 5.58 g of a solid mixture composed of NH4CI and CaCl2 was dissolved in 100.0 mL of water, the…
A: 2 questions are asked. According to guidelines, will answer the 1st question only. 100 ml water…
Q: Calculate the heat energy released when 25.7 g of liquid mercury at 25.00 °C is converted to solid…
A: Mercury is the metal that is present in its liquid form.
Q: How many liters of dry hydrogen gas, measured at 798 mmHg and 21C, will be released by the…
A: When change in pressure, volume and temperature occurs than the combined gas law is used. Combined…
Q: Trans-oleic acid (18:1,D9) has a melting temperature of (44.5C) and cis-oleic acid (18:1,D9) has a…
A: A cis arrangement implies that when there is a double bond, the neighboring carbon atoms are on the…
Q: Which has greater entropy, liquid water at 0°C or ice at 0°C?
A: The measurement of the thermal energy of the particular structure with temperature when there is no…
Q: Hot air at 50 C does not cause a lethal burn on our skin, but water with the same temperature is…
A: yes its true that Hot air even at 50C can not burn our skin, but water with same temperature can…
Q: If 5.0 g of calcium hydroxide are needed, how many moles of magnesium hydroxide would be produced?…
A: 1.27 Moles of Mg(OH)2 are produced from 1 mole of Ca(OH)2.
Q: Describe the Bohr effect.
A: According to Bohr Effect the affinity of hemoglobin for dioxygen decreases with decrease in pH
Q: What three elements are required to start and sustain a fire?
A: For a chemical reaction to carry out, we need chemical compounds, atoms, or some molecules to react…
Q: When I was a little kid, I tired to hard boiled an egg in a microwave. The egg was fresh out the…
A: Given that T1= 276K T2 = 345 K P1=1atm P2 =?
Q: If Hydrogen Peroxide (H2O2) is added to each of the following items, which of the items will have…
A: Exergonic reaction occurs spontaneously and no requirement of outside energy to initiate the…
Q: hydrogen at 101 kpa each day . If each days supply of hydrogen were kept at a pressure of 366 kpa,…
A: The relationship for Boyle's Law can be expressed as follows: P1V1 = P2V2, where P1 and V1 are the…
Q: A helium gas cylinder of the sort used to fill balloons has a volume of 0.180 m3 and a pressure of…
A: The ideal gas law is equation of state of a hypothetical ideal gas where the Pressure, Volume,…
Q: How many kilojoules are released by the combustion of 17.0 g of C8H18?
A: Carbon is the key element fount in all organic molecules. carbon have 4 valency. Based on the carbon…
Q: How can the temperature of steam be raised above 1008C? Which instrument is based on this technique…
A: Heat is one of the antimicrobial agents.
Q: Why are most spontaneous reactions exothermic?
A: A spontaneous process is the time-evolution of a system in which it releases free energy and it…
Q: How much heat would be required to convert 7.47 mol of a pure substance from a liquid at 40.0°C to a…
A: The heat is a form of energy. The heat of vaporization is defined as the amount of heat needed to…
Q: What volume in liters would 20.0 moles of sulfur dioxide occupy at 75.3 °C with a pressure of 2.40…
A: Moles of sulfur dioxide (n) = 20 moles Temperature (T) = 75.3 + 273 = 348.3 K Pressure (P) = 2.40…
Step by step
Solved in 2 steps
- How is Kw defined, and what is its numerical value at 25 °C (298 K)?What is the equivalent of 7 ppb in µg sol/L?Two solutions, 250.0 mL of 1.00 M CaCl2(aq) and 250.0 mL of 1.00 M K2SO4(aq), are combined, and the temperature decreased by 2.40 degrees C. Determine qrxn per mole of CaSO4(s) formed in the reaction. A) +12.0 kJ/mol B) -12.0 kJ/mol C) +6.00 kJ/mol D) -6.00 kJ/mol
- If you measured the rate of reaction at 20°C to be 1.11 x 10-5 M/s when using 0.080 M I1- and 0.040 M S2O82-. Approximately how long will the reaction take if you were to increase the temperature to 30 °C?For the following reaction, 4.91 grams of water are mixed with excess chlorine gas. The reaction yields 12.5 grams of hydrochloric acid.chlorine (g) + water (l) hydrochloric acid (aq) + chloric acid (HClO3) (aq) What is the theoretical yield of hydrochloric acid ? grams What is the percent yield of hydrochloric acid ? %A quantity of gas in a piston cylinder had a volume of 0.539 m^3 and a pressure of 200 Pa. the piston compresses the gas to 0.222 m^3 in an isothermal (constant-temperature) process. What is the final pressure of the gas?
- In converting ice (-25°C) weighing 200g to Steam (150°C), solve for the energy required to do so.For ferrocene (C10H10Fe) the enthalpy of sublimation is 73.2 kJ/mol and the entropy of sublimation is 243 J/mol.K. What is the sublimation temperature of ferrocene in degrees Celsius?Solution A is 20 degrees celsius, Solution B is 80 degrees celsius (both are the same kind of solution). The goal is to make a 50 degree celsius solution; How much of solution A do you need (starting with 100g of solution B)? (cp=4.184 J/g C)
- How many milliliters of 0.0050 N KOH are required to neutralize 25 mL of 0.0050 N H2SO4? To neutralize 25 mL of 0.0050 M H2SO4?A 1.23 g sample of acetic acid (HC2H3O2) was burned in excess oxygen in a bomb calorimeter. The calorimeter, which alone had a heat capacity of 2.67 kJ/°C, CONTAINED 745 G OF WATER. The temperature of the calorimeter and its contents increased from 23.77 °C to 27.95 °C. What is ΔH (in kJ) for the combustion of 1.00 mol of acetic acid is 60 g/mol.Sugar solution is being heated to 83 o C in a jacketed pan made from stainless steel, 1.6 mm thick. Heat is supplied by condensing steam at 200 kPa gauge in the jacket. Calculate the rate of heat transfer if the surface heat transfer coefficients for condensing steam and sugar solution are 12000 J/m2-s-oC and 3000 J/m2-s-oC, respectively. Thermal conductivity for the stainless steel is 21 J/m-s-oC and the surface area of the pan is 1.4 m 2 .