system. R(s) Y (s) 160 s+32 K2 Find the condition for K, and K2, which makes the system stable using the Routh-Hurwit criterion. The transfer function of the given block diagram is: 160K1 T(s): s2 + (32 + 160K, K2)s +160K,

system. R(s) Y (s) 160 s+32 K2 Find the condition for K, and K2, which makes the system stable using the Routh-Hurwit criterion. The transfer function of the given block diagram is: 160K1 T(s): s2 + (32 + 160K, K2)s +160K,

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q7. What are the applications of fuel cell?

A: A fuel cell uses the chemical energy of hydrogen or another fuel to cleanly and efficiently produce…

Q: Safrole is contained in oil of sassafras and was once used to flavor root beer. A 2.39-mg sample of…

A: Given Data: Mass = 2.39 * 10-3 g Melting point = 25.70 C Kf, = 8.00°C/m. Freezing point = 26.84°C…

Q: a. Determine the ampacity of four heat resistant conductors up to 90 C of #10 gauge copper installed…

A: Solution of question (a): Given information, Size of conductor is 10 AWG (we have taken American…

Q: Q2/Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 6A, 25A, and…

Q: A J- type thermocouple is used to measure the temperature in a heating process. The length of the…

A: Given Data:

Q: If the area of cross section of a conductor is increasing, then the resistance of the conductor…

A: If the area of the cross section of a conductor is increase then resistance?

Q: brucestiu ns. metal outer casing power cable acoustic insulator backing block sidi ni edgaa.edt.di…

A: ULTRASOUND PROBE AN ULTRASOUND PROBE, ALSO KNOWN AS A TRANSDUCER, IS AN ESSENTIAL COMPONENT OF AN…

Q: Write about two points about Renewable energy sources

A: According to the question we have to discuss about Renewable energy sources.

Q: The resistance of the filed coils with copper conductors of a dynamo is 120 2 at 25°C. After working…

A: We known that resistance is changed as the temperature is changed so that value of resistance is…

Q: need the answer as soon as possible

Q: Q.26: If the voltage applied to the circuit shown is: eT=50+40sin 1000t+30sin2000t+20sin3000t Volt,…

A: In the given circuit, a source of multiple frequency components is present. We are going to use the…

Q: Significant history on the discoveries and technological development nd progress in the…

A: Electricity It is the flow of charge inside a conductor.

Q: Lecture One Electrical Circuits I Asst.Lect.Faten Imad Ali Example 4 A copper conductor has its…

Q: 25) Which of the following statement is false about uniform electric fields? a. The electric field…

A: Gauss's Law-It states that the total electric field through any closed surface is equal to the total…

Q: The resistance of a coil is 140 Q and its inductance 0.85 H. Determine the current, the p.f. and the…

A: Given: R=140 Ω, L=0.85 HVS=120 V, 60 Hz Required: 1. Current 2. Power factor 3. Circuit Impedance

Q: Take a graph sheet and divide it into 4 equal parts. Mark origin at the center of the graph sheet.…

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for…

Q: What is the derated ampacity of (7) - 10 AWG THHN copper conductors in a raceway? Select one: a. 20…

A: In this question we need to find a derated ampacity of (7) - 10 AWG THHN copper conductors in a…

Q: Problem 3 The pressures PA and Pa in the differential manometer gage are 154.415 kPag and 150 kPag…

Q: 22. Draw the image charges in that situation. L *10 Conductor

A: Solution:Given Data:Find :=>here Draw Image Charges for given Diagram at angle 60 degree.

Q: The equation Jn=qnµ„E (A/cm²) represents.

Q: a) Explain the importance of thermal management of electronics devices.

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: The following table lists Townsend's first and second ionization coefficients for various gas types.…

A: The given table of Townsend's first and second ionization coefficients for various gas types is…

Q: Take a graph sheet and divide it into 4 equal parts. Mark origin at the center of the graph sheet.…

A: According to the question, for the given data as shown below We need to plot the V-I…

Q: q3. sketch the RC circuit for discharging process

A: The explanation is as follows.

Q: Eend inducteniee perkm par phace

A: In this question, We need to determine the inductance of the given system. We know Inductance L…

Q: How can you measure the temperature of an object using the Calendar-Griffith's bridge, Explain in…

A: Calendar-Griffith's bridge- It is one type of potentiometer used to calculate the voltage difference…

Q: , Design and draw the ladder diagram for a toaster running on 120 Vac. When the toast is pushed down…

A: It is asked to design and draw the ladder diagram for a toaster running on 120 Vac.When the toast is…

Q: The voltage supplied to the positive electrode of a spark plug is 12.6V Select one: O True False

A: The flash attachment is an apparently straightforward gadget, despite the fact that it is entrusted…

Q: 1-AQ/ 10. A wire 50.0 m long and 2.00 mm in diameter is connected Tto a source with a potential…

A: (10) sol:- length l=50.0 m diameter, d= 2.00 mm= 2*10-3 m So radius r=d/2 = 1*10-3 m potential…

Q: A detector with a rise time of 3 nS. is connected to a 5 foot long length of RG-58 coaxial cable…

A: Given: A detector with a rise time of 3 nS. is connected to a 5-foot long length of RG-58 coaxial…

Q: which one of the following is The rate at which solar energy arrives at the top of the atmosphere a.…

A: Given: Question on what is the rate at which the solar energy arrives at the top of atmosphere?…

Q: Q. No. 03 A watershed of (50+Roll No) km² has two different soil types and land uses. 70 % of the…

A: Given Roll no. = 0586 The total area is, A=50+Roll no.=50+586=536 km2 CN1 = 81 has 70% area. A1=70%…

Q: A protective conductor connecting exposed conductive parts of equipment to the main earthing…

A: In earthing a conductor is used to connect the exposed conductive parts(metallic parts) of various…

Q: EXP;AIN THE FOLLOWING WITH EQUATION 1) RESISTANCE 2) SENSITIVITY 3) RELATION BETWEEN RESISTANCE…

A: (1) Resistance :- It is a measure of the opposition to the flow of current in an electrical…

Q: A 2-wire D.C. Ring distributor is 150m long and is fed at 400 V at point A. At point B, 75m from A,…

Q: For the Maxwell A.C bridge,determine the value of the Resistance r of the coil when R1 and R2 are…

A: Resistance r of the coil is calculated as shown

Q: Assume the BJT operate in active region. The current in the figure is as follows: 1₁ = 9 mA. 1₂ =…

A: BJT (Bipolar Junction Transistor) Three semiconductor areas that form two junctions make up a…

Q: lo vd1 1₂ ******* 1. With the figure above derive the value of vd-vd1. Answer:

Q: Of the three conductors, you used in this experiment (tubular resistor and two lamps) and based on…

A: Resistor tubes of a cemented (FU) or cemented design make up tubular resistors (FZ). The built…

Q: D1 R2 1.5kO D2 V1 =12 V R4 2000 R3 4700 R1 D3 1kO

A: We need to find current through diodes . First we will check which diode will be on or off.then we…

Q: 1. Using the partial chromatogram below: a. determine the resolution between the two solute bands.…

A: 1) a. Resolution between these chromatographic peak is calculated as, RAB=trB-trA0.5ωB-ωA

Question

ASAP

onsider the following control system.
R(s)
Y (s)
160
s+32
K2 -
Find the condition for K, and K2, which makes the system stable using the Routh-Hurwitz
a)
criterion. The transfer function of the given block diagram is:
160K,
T(s):
s2 + (32 + 160K, K2)s + 160K,

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

question:
4. A copper wire has a length of 3500 ft and having an area of 144 cm squared. Find the resistance of the copper conductor at a temperature of 43ºC. 5. The power taken by a resistive coil made of copper wire is 1200W at 120V and 15 °C. Calculate the power consumed by the coil when connected at 250V and 110°C. The temperature coefficient at 27 °C is 0.00393 °C-1.
Graph: Take a graph sheet and divide it into 4 equal parts. Mark origin at the center of the graph sheet. Now mark +ve X-axis as Vf, -ve X-axis as Vr, +ve Y-axis as Ifand –ve Y-axis as Ir. Mark the readings tabulated for Si forward biased condition in first Quadrant and Si reverse biased condition in third Quadrant.
https://docs.google.com/forms/d/e/1FAlpQLScF2Wzu92iVI-tEM2nxdhqXrGdR460G4 O Recommendation Q5 All the following rods have uniform positive charge Q, the value of the electric field is estimated at the center (origin) of each. Which one of the * ?following is correct نقطة واحدة (a) (b) (d) (c) AR. 48
14 The ac bridge of Figure 48 nulls with R₁ = 1 kN, R₂ = 2 kn, R3 = 100 2, and L3 = 250 mH. a. Find the values of R, and L₁. b. If the circuit is excited by a 5-V rms, 1-kHz oscillator, find the offset voltage for L₁ = 510 mH. c. What are the amplitudes of the in-phase and quadrature (90°) components of the offset voltage? FIGURE 48 ac bridge for Problem 14. Ro D
Aa BM
Aluminum coil has a resistance of 8.216 ohms at 70-degree Celsius and 9.615 ohms at 130-degree Celsius. Find the resistance at 30-degree Celsius and the temperature coefficient of resistance at 70- degree Celsius.
The derated ampacity of (8) - 12 AWG THHN current carrying copper conductors in a raceway? A. 20 ampsB. 21 ampsC. 24 ampsD. 30 amps
Homework -j2 1 For the ect. shown, ee determine the branch + j2 voltagen ad currents and the power delivered by the souree using mech aualysis. -j1 * All resietomce and reactance values are in Ohms. HW
Electrical Engineering - High voltage system EENG451 Please solve the question quickly
an iron can weighing 50 grams absorbs 256.0 J of heat and warms by 11.4 degrees C. What is the specific heat of the iron can? (Formula: Q(heat)=mCpdetlaT)
lon 3 An open circuit is occurred when: out of Select one: a. A pair of terminals not connerted by h nenteEny kind Le a break exists in a complete conducting path. uestion b. All of the given answers C.The current between the two terminais is aeo althouon there may be a nonzero voltage between the terminals