Suppose you are designing a sliding window protocol for a1-Mbps point-to-point link to the stationary satellite revolvingaround the Earth at an altitude of 3 × 104 km. Assuming that eachframe carries 1 KB of data, what is the minimum number of bitsyou need for the sequence number in the following cases?Assume the speed of light is 3 × 108 m/s.(a) RWS=1(b) RWS=SWS

Bandwidth = 1Mbps = 106 b/sec Each frame carries 1KB data = L = 213b (Propagation time) tp =…

Suppose you are designing a sliding window protocol for a 1-Mbps point-to-point link to the stationary satellite revolving around the Earth at an altitude of 3 x 104 km. Assuming that each frame carries 1 KB of data, what is the minimum number of bits you need for the sequence number in the following cases? Assume the speed of light is 3 × 108 m/s. (a) RWS=1 (b) RWS=SWS

Suppose you are designing a sliding window protocol for a 1-Mbps point-to-point link to the stationary satellite revolving around the Earth at an altitude of 3 x 104 km. Assuming that each frame carries 1 KB of data, what is the minimum number of bits you need for the sequence number in the following cases? Assume the speed of light is 3 × 108 m/s. (a) RWS=1 (b) RWS=SWS

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Computer Science A Go-Back-N (GBN) ARQ scheme has been designed with window-size W = 10 such that it is fully efficient when there are no errors on the channel. Assume that frame size is 20000 bits and the overhead bits are negligible. What is the bit probability error (as seen at Layer 2) that makes the Go-Back-N ARQ 50% efficient?
The Amplitude Modulation (AM) is a technique used in communication for transmitting information via radio carrier wave. AM works by varying the amplitude of the transmitted signal in relation to the information being sent. The equations of the carrier signal, the original signal to send, and the modulated signal combining the two signals are respectively: VI-V sin (2nfet) V2=Vm sin (2πfmt) V3-V sin (2nfet)+V sin (2nft)* sin (2nft) Supposing that V-Vm-1, fc-20, fm 1. Write a MATLAB program that plots the three signals with single call, the graphs must be contain (desired title, axis labels, annotations, with symbols for color, style, and marker) for each graph. Use the step 0.0025 for the time.
Unless specified otherwise, use the free space propagation speed of light 3x108 m/s to calculate the propagation delay. For numerical calculations, the results must show the appropriate unit. Show a complete solution for each problem3. Consider a digital multimedia transmission system. Separate audio and video coders are used to encode these signals. Audio and video bits are packed in packets together and transmitted over a transmission link. Each packet is 2,000 bytes long, which includes a 48-byte header. The system generates one packet every 40 ms. Calculate the following values:a. The minimum data transmission rate required to support the above system.b. The minimum signal-to-noise ratio (SNR) in dB required to transmit the above audio and video information. Assume a 400-kHz transmission channel bandwidth is used.c. The end-to-end packet delay over a 50-km link, using answer in Part a).
Suppose there is a b+n (Sum of first and last digit of your Reg#) Mbps microwave link between a geostationary satellite and its base station on Earth. Every minute the satellite takes a digital photo and sends it to the base station. Assume a propagation speed of 2.4*108 meters/sec. 1. What is the propagation delay of the link? 2. What is the bandwidth-delay product?
Given a home wireless IEEE 802.11AC Wi-Fi channel with a bandwidth of 80 MHz, a) Apply the real time streaming transmission of a video that samples at 40 frames/second and each frame has a resolution of 800x600 pixels. Each pixel has its colour presented in 16 bits. Calculate the required transmission rate. b) If the Wi-Fi Channel is very noisy with an acceptable Signal-to-Noise Ratio of 10dB, does the video streaming in part (a) still possible without any distortion? (provide workings)
I A channel has a frequency range between 3 KHz and 14 KHz. The SNR in this channel is 25 dB. Find the maximum Bit rate of the channel and the Signal levels. [3 marks] For a bit stream "0 1 1 0 0 1 0 1", sketch the waveforms for (i) NRZ-I - (Assume the initial level at time zero is Low) (ii) NRZ-L - (assume 0 as High and 1 as Low) (iii) RZ Encoding – (Assume the initial level at time zero is Low) [3 marks]
Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay. The data frames carry a useful payload of size 12,000 bits. Assume that both ACK and data frames have 320 bits of header information, and that ACK frames carry no data. What is the effective data throughput When using Stop and Wait?
What is the bandwidth of a signal that ranges from 2 MHz to 7MHZ? * 14 MHz 9 MHz 4 MHz 5 MHz Consider a noiseless channel with a bandwidth of 4kHz. If we want to transmit 32Kbps on this channel, the minimum number of signal levels needed is: * 8 О 16 32 64 describes the position of the waveform relative to time 0. * frequency amplitude phase voltage
55. Suppose a digitized voice channel is made by digitizing 8 kHz bandwidth analog voice signal. It is required to sample the signal at twice the highest frequency (two samples per hertz). What is the bit rate required, if it is assumed that each sample requires 8 bits? a. 32 kbps b. 64 kbps c. 128 kbps d. 256 kbps
Consider the following bit stream-a. 00000000 b. 11111111 c. 01010101 d. 00110011 Draw the graph of the i. NRZ-Iusing each of the given data streams, assuming that the last signal level has been positive. From thegraphs, guess the bandwidth for this scheme using the average number of changes in the signal level.
Data communication Suppose that the spectrum of a channel is between 8 MHz and 10 MHz, and the intended capacity is 8 Mbps. a. What should be the signal-to-noise ratio (SNR) to obtain this capacity? Constant values= c=3x^10°m/s, k=1,38x^10231/K I
A distant planet is about 9 x 1010 metres from the surface of the Earth. What is the channel utilisation of a point-to-point connection that operates at 64 megabits per second and uses a stop-and-wait protocol for frame transmission? Let's say that the speed of light is 3 108 metres per second, and that the frame size is 32 kilobytes.