Suppose A and B nodes are on the same 10 Mbps broadcast and the propagation delay is 325 bit times between the two nodes. Suppose for this channel CSMA/CD and Ethernet packets are used. Suppose node A begins sends a frame and node B starts sending a frame until it is over. Can Afinish transmitting B until it is detected? Why not? Why or why not? If so, then A incorrectly insists that his frame was transmitted safely without a crash. Hint: Suppose t = 0 bits at the moment, A begins sends the frame. In the worst case, a minimum frame of 512 + 64 bit times is transmitted. So A would end the frame at t = 512 + 64 bit times. The . response is no, if the signal B crosses t = 512 + 64 bits before bit time. In the worst scenario, when does B hit A?

Q: propagation delay is 10 ad B is 100Mbps. Both 5Bytes long and ACK und trip delay between

A:

Q: A sender with window size (W=3) is connected to a go back N receiver by a link with bandwidth =106…

A: In this scenario, the sender has a window size of 3, which means it can send up to three packets at…

Q: A sender with window size (W=3) is connected to a selective repeat  receiver by a link with…

A: Solution:   Given, the window size (W) of the sender is 3, the bandwidth of the link is 106…

Q: Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive…

A: Given that, Length of file= 10 MB Bandwidth= 100 Mbps Distance of link= 2000 km Propagation speed=…

Q: Consider a router that transmits bits onto a transmission medium at the rate of 2 Mbps. Let the link…

A: Given:   Bandwidth = 2 Mbps => 2 *106 bits/sec  Distance = 3 km  Speed = 3 * 108 meter/sec…

Q: 1. Consider a 10Mbps shared Ethernet with Bus Topology. The total length of the cable is 2000m and…

A: Ethernet technology is a popular networking technology that allows several devices to connect with…

Q: Suppose dprop is greater than dtrans. At time t=dtrans, where is the first bit of the packet?

A: The answer is

Q: Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive…

A: Computer networking which refers to interconnected computing devices that can exchange data and…

Q: Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive…

A: Answer: Given File size=10MBytes Rate= 100Mbps Distance=2000Km Speed=2 X 108 m/s

Q: work using slotted control protocol, of 8000 bits. The is 10 KBps. The av missions at each

A:

Q: As discussed in the OSI protocol stack, one way a data link layer handles transmission errors is by…

A: OSI (Open Systems Interconnection) is a reference model for how applications communicate over a…

Q: Two endpoints are linked by a single connection with a rate of R = 56kbps and a propagation speed of…

A: Introduction Two endpoints are linked by a single connection with a rate of R = 56kbps and a…

Q: Suppose there are three nodes in a network, A, B, and C.    A starts transmitting over the medium…

A: For CSMA/CD, nodes B and C have sensed the medium busy and will continuously keep sensing it until…

Q: Computer A is sending a 100 kByte long file to Computer B via packet-switching over two consecutive…

A: Here in this question we have given that  Total size = 100kB Bandwidth= 10Mbps. Link distance…

Q: Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive…

A: Computer Networks which refers to the set of the computers which are connected through the medium…

Q: Computer A is sending a 100 kByte long file to Computer B via packet-switching over two consecutive…

A: Given that, Size of the file= 100 KB Bandwidth of the link= 10 Mbps Distance of each link= 1000 Km…

Q: Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive…

A: Given that, Length of file= 10 MB Length of packet= 1480 bytes Bandwidth of the link= 100 Mbps…

Q: How long does it take a packet of size 10 KB to travel over three links (connection) with a…

A:

Q: A link has a transmission speed of 106 bits/sec. It uses data packets of size 1000 bytes each.…

A: Given: A link has a transmission speed of 106 bits/sec. It uses data packets of size 1000 bytes…

Q: Host A is sending data to host Bover a full duplex link. A and B are using the sliding window…

A: Introduction:Data Packets = 1000 bytes longtransmission time = 50 micro secondpropagation delay in…

Q: A factor in the delay of a store-and-forward packet-switching system is how long it takes to store…

A: Answer

Q: The write buffer returns a block to main memory while the processor issues a request that cannot be…

A: given When a processor delivers a request that cannot be completed in the stored What should occur…

Q: annel is error free and 270 msec is the signal propagation time from the source to destina e…

A: The Answer is

Q: Suppose that KJ sends 3596 back-to-back packets, with each packet composed of 14,000 bits, to TA…

A: To find delay

Q: Consider a short, 10-meter link, over which a sender can transmit at a rate of 150 bits/sec in both…

A: In this question we have to understand the comparison between non-persistent HTTP and persistent…

Q: Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between…

A: Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between…

Q: A packet with 88MB long is generated at node A and sent to node C through node B. The distance…

A: For finding  out the minimum data rate between the nodes B and C so that the buffer of the node B…

Q: Suppose we need to design a stop-and-wait, reliable data transfer protocol between a sender A and a…

A: It is defined as the simplest flow control method. In this, the sender will send one frame at a time…

Q: Segments are transmitted using GO-BACK-N ARQ over a link with RTT= 6 milliseconds with 17 Mbps…

A: solution for the above question is solved in below step 2:-

Q: A factor in the delay of a store-and-forward packet-switching system is how long it takes to store…

A: The answer is as below:

Q: nds. Th km wh m. Finc econd i need?

A:

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.