Solve the current i«(t) in the following circuit: 50 4(t) 20 20 cos(5t + 45°)V 3H 50 Solve the current i,(t) in the following circuit: 50 i,(t) 20 3H 50 +)3 sin(2t) A The following circuit in problem 2(c) is the combination of the circuits in part 2(a) and part 2(b). Use the superposition principal to find i(t). [To elaborate, write down the equation for i-(t) based on the results found for part 2(a) and part 2(b)] 50 20 20 cos(5t + 45°)V 3H 50 +)3 sin(2t) A 1/3/ ll ell

Solve the current i«(t) in the following circuit: 50 4(t) 20 20 cos(5t + 45°)V 3H 50 Solve the current i,(t) in the following circuit: 50 i,(t) 20 3H 50 +)3 sin(2t) A The following circuit in problem 2(c) is the combination of the circuits in part 2(a) and part 2(b). Use the superposition principal to find i(t). [To elaborate, write down the equation for i-(t) based on the results found for part 2(a) and part 2(b)] 50 20 20 cos(5t + 45°)V 3H 50 +)3 sin(2t) A 1/3/ ll ell

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
In the following figure, the switch is left in position a for a long time interval and is then quickly thrown to position b. Find and rank the magnitudes of the voltages (V, VL, VRI, Vr2) across the four circuit elements a short time thereafter from the largest to the smallest. Vs 12.0 V 2.00 H 1 200 0 VRI 12.0 0 Vr2
Tutorial exercise Jimmy the Circuit Builder is at it again and this time he is using AC. He has all of the linear components in pairs: two AC voltage sources, two AC current sources, two resistors, two capacitors and two inductors. He is trying to build circuits to create certain voltages and currents. All of the sources operate at w=500 rad/s. 940° V 2 <90° A - 12<60° V 1-30° A (c) V=6490° V (d) I=64150° A (e) I = 0.6 +j1.04 (f) V=18.25434.7° V + (a) Draw the circuit. (b) Calculate the voltage across each component. 100μF TE 1mF 46 392 -M 1mH hint: try combining the two sources 10mH Jimmy first builds one circuit to check his understanding of AC voltage, current and power. The circuit is a series connection of the 12 <60° V voltage source, the 3 resistor, the 10 mH inductor, and the 1mF capacitor. 1092 M Using only two elements, connect the pair of elements to create the following AC voltage and currents: Using exactly three elements, draw circuits to create the following AC voltage…
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the real power of the circuit?
For the circuit, find Vo if the input is sin(t) as shown in figure .below 1 k2 1V- +5 V 1k2 o Vo -1V -5 V
In the circuit shown in figure the switch is closed at time (t=0). The rate of change of current dt across inductor will be tm0 20 8F 20v (3H
9. Recall that Kirchhoff's laws help to get the current in circuits. Consider the following circuit: L R I(t) C +q(t) -q(t) Ignore the alternating power for this problem. a) What is the voltage over the resistor if it has a resistance of R ohms and the current is I ampere? b) What is the voltage over the capacitor if the capacitance is C and the charge on the capacitor is q. c) What is the voltage over the inductor if it has an inductance of L Henry? The answer must be in a form of a differential equation.
For the circuit shown in figure Req is: * 140 R3 R, R: 22 Rea Ru RC RS R7 33 6 ohm 24.4 ohm 34,4 ohm 44.4 ohm
A resistor and a capacitance are connected in series to an emf source. The time constant of the circuit is 0.87 s. What will be the 35 - time constant of the new circuit when another capacitor identical to the first is connected in series with the circuit? O a) 0.973s O B) 1,742 s O C) 2.034 s O D) 2.136 s O TO) 0.435 s
Determine the inductor current i(t) for t20. Given that Vs1 = 9V, Vs2 = 12V, L= 120mH, R₁ = 2.29, R₂ = 4.792, R3= 18kQ. Vst t=0 VS₂2
Find LT in the network in the figure (a) with the switch open and (b) with the switch closed. All inductors are 24 mH. LT- (a) mH (b) mH
The capacitor in the circuit is initially uncharged and the switch S is suddenly closed at t=0. Find the current on resistor R, at to Take R-3R/2 and R₂-4R. A) MER B) -15 28 O 815 D) -15 35 R₁ R₂