solve for VL and IL using superposition. Look all the pictures . I have done and I dont know why when i use the nodal analysis and the node equation they gave. I got difference voltage value. Can you please help me to do this ? Thanks

Q: Ex. 1922. Fig 1922 Exponential Pulses. A=16 ms, B=128 ms, C=33 volts The time constant of the…

A: Given: With, A=16 ms, B=128 ms, C=33 volts,  The time constant of the exponential function is A=16…

Q: 3) In the circuit shown in Figure 3, what is the value of VA and the value of vo for an input of V1…

A: We need to find out the output voltage for given circuit.

Q: Find the equivalent resistance seen by the voltage source in Figure P2.24. How many nodes are in the…

A: The given circuit diagram is shown below,

Q: Q4. Referring to the circuit shown in figure Q4, by using Superposition theorem, determine a) the…

A:

Q: Problem 2 Please consider the discrete-time system x[k + 1] = [ [k+1 k+: 0 for the initial condition…

A: Everything that receives a discrete-time signal as input and outputs a discrete-time signal is…

Q: A power system has two synchronous generators. The Governor-turbine characteristics corresponding to…

A: Given: A power system has two synchronous generators, the governor turbine characteristics…

Q: Hi,  Are you able to go into some more detail on its opperation if possible.

A: Given: To explain: The operation of the circuit as a NOT gate.

Q: The per-unit impedance of a system is 0.7 pu. The base KVA is 300 kVA, and the base voltage is 11…

A:

Q: A microstrip transmission line is to  be used as a capacitor of 4pf at 800MHZ. The PCB dielectric is…

A:

Q: A point in Cartesian coordinate is represented as P (1, 3, 5). The point P in spherical coordinate…

A: Given: Points in cartesian coordinate,  Px, y, z=P1, 3, 5 The points in spherical coordinates, Pr,…

Q: the steady state currents flowing through inductors capacitor C Calculate L₁ and L2 and the steady…

A:

Q: 6) Consider the circuit in Figure #2 that was set as an example at the beginning. Use different…

A:

Q: a + V1 122 www 223 b 221 For the circuit shown in Figure (V₁-15.5 V, V₂=8.4 V, ₁=6.36 , ₂=2.262,…

A: We need to find out current and potential difference for given circuit

Q: -0.2 V I 1kQ XMM3 DA 1kQ Given this scenario, If XMM3 is a Voltmeter, What will be its reading?…

A:

Q: By using Maxwell's circulating currents, calculate the current in each loop 20V 50 30 4Ω 5V 5V 202…

A:

Q: An impedance coil of power factor 0.8 is connected in series with a 110 µF capacitor to a 50 Hz ac…

A: In this question We need to determine the value of resistance R,  If voltage across the coil =…

Q: Explain the below in really basic terms. Explain what conjugate impedance is in really basic terms.

A: In this question we explain the given network .

Q: What is the value of current of the capacitor after one time constant? Ⓒlov t=0 147 mA 362 mA 242 MA…

A: Answer: given that  a linear RC circuit given that source voltage VS = 10 V initial voltage of the…

Q: Use mesh current method to find the power of the current source. Use the correct sign for the power…

A: We need to find out the power for given current source in the given circuit.

Q: The action potential recorded when the retina is stimulated with a brief flash of light is call an…

A:

Q: Determine Ix for the following circuit using nodal analysis when Va=29 V, Vb=4 V, R1-12 Q2, R2=220,…

A:

Q: Plot the sequence x[n] = (8[n-2] *2").u[n] - 8[n-2] * (2".u[n])

A: Given: A sequence, x[n]=δ[n-2]*2n.u[n]-δ[n-2]*2n.u[n], To do: We have to plot the given sequence.

Q: Apply Thevenin's theorem to find Vo in the circuit below. (Tip: first consider there is no 10 ohms…

A:

Q: A system whose output y[n] at time n depends on any past output values as well as past input values…

A: Answer the following: A system whose output y[n] at time n depends on any past output values as well…

Q: 3. Two station alternators A and B operate in parallel. The station capacity of A is 30 MW and that…

A: 3)

Q: The per-unit values of positive, negative, and zero sequence reactances of a network at fault are…

A:

Q: Two conducting plates are inclined at an angle of 45° to each other with a point Charge between…

A: Given Data: Inclination angle between two conducting plates ϕ=45o To Find: Number of image charges…

Q: What is difference between MOSFET, IGBT and BJT? Brief explanation about SCR.

A: To write: Difference between MOSFET, IGBT and BJT.  Brief explanation about SCR.

Q: Determine Vce in the given circuit if VBB = 10V, VCC = 15V, RB = 10kΩ and RC = 1k Ω. Assume β = 100

A:

Q: Consider the potential difference between pairs of points in (Figure 1). Suppose that E= 8.5 V. For…

A:

Q: find Wo angular frequency

A: In this question We need to determine the angular frequency of the given system.  We know Second…

Q: TOPIC: Power Systems, Power Plants & Illumination INSTRUCTIONS: - Answer in this format: Given,…

A: The diversity factor is the ratio of the sum of individual maximum demands to the maximum demand on…

Q: The electromotive force from a battery drives a current around the circuit shown in the figure.…

A:

Q: Question 1 For the following system with y[1]-1: -2x[n]y[n] +x(n-1)=y(n-1) h[0] is

A:

Q: A point charge of +5µC and −5µC are located at (0, 0, 1) and (0, 0, −1) respectively, in free space.…

A: Magnitude of dipole moment p = Q* d Q is the charge  And d is the distance between the charges.

Q: V₂ R₁ www R₂ al R3 RA

A: The given problem is from circuits. The detailed solution is given in the next step

Q: (2) Consider a linear, time invariant system y(t)=H[u(t)]. The impulse response of the system is…

A: Given impulse response h(t) = sin(2πt) e-t ut) Laplace transform formulae. L{ e-at sin bt u(t) } =…

Q: Problem 3 For the motor in Problem 1 and for a fan-type load, calculate the following if the voltage…

A: It is given that: V1=209 VV2=0.8V1P=6f=60 HzR1=0.128 ohmR2'=0.0935 ohmXeq=0.49 ohmS1=0.02Fan type…

Q: winding

A:

Q: The pu impedance of a circuit element is 0.15. If the base kV and base MVA are halved. Then the new…

A: Given, Per unit impedance of a circuit element, Zpuold=0.15. New kV values, KVnew=12KVold. New MVA,…

Q: a. Determine the ac resistance at I₁ = 2mA b. Determine the ac resistance at I₁ = 25mA c. Compare…

A: Given the graph of ID verses VD  Id=I0evdηvT-1Differentiate w.r.to…

Q: TOPIC: Power Systems, Power Plants & Illumination INSTRUCTIONS: - Answer in this format: Given,…

A: Given information is written below. A coal-fired Power Plant with a 3000 kW rated capacity costs…

Q: 1. Circuit System Consider the following circuit system containing batteries, resistors, and nodes:…

A:

Q: ..A 3-phase,8 pole 50 Hz, star connected salient pole synchronous generator has 90 slots with 4…

A:

Q: The network shown below has a frequency of 150 kHz and a bandwidth The Q factor of the network is…

A: Given- The network shown below, Resonant frequency, fo=150 kHz. Bandwidth, B.W.=600 Hz.   To find-…

Q: in a ser as: i=5sin(314t+ 2n/3) Amperes e = 15sin(314t+ 5/6) Volts What is the: a. Impedance of the…

A:

Q: A 2200V, 60 Hz, three-phase, Y-connected alternator has an effective resistance per phase of 0.5…

A:

Q: 4. Two generating units rated 250 MW and 400 MW has speed regulation of 6% and 6.4%, respectively…

A:

Q: riable points urrent, and the voltage drop 24 V 50 www 30 www 40 www 10 www ? www Terms of all the…

A: The given circuit diagram is shown below,

Q: Two star-connected, cylindrical rotor synchronous generators of identical rating operate in parallel…

A: Introduction Synchronous Generator: A two-star connected synchronous generator is a type of AC…

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.