Situation 22. For the built-up shape shown in the figure, determine: В. by = 200 mm ty = 12 mm h = 200 mm tw = 10 mm 68. The location of plastic neutral axis form the top edge of the flange in mm. 69. The plastic section modulus about the horizontal axis. x10^6 mm^3 (3 decimal places) 70. The plastic moment with bending about the vertical axis if Fy = 345 MPa. KN-m (rounded to the nearest whole number)

Situation 22. For the built-up shape shown in the figure, determine: В. by = 200 mm ty = 12 mm h = 200 mm tw = 10 mm 68. The location of plastic neutral axis form the top edge of the flange in mm. 69. The plastic section modulus about the horizontal axis. x10^6 mm^3 (3 decimal places) 70. The plastic moment with bending about the vertical axis if Fy = 345 MPa. KN-m (rounded to the nearest whole number)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

05. Consider the deformable pin-jointed truss with loading, geometry and section properties as shown in the Figure Q5. Given that E=2x10"N/m, A=10mm, L=Im and P-lkN. The horizontal displacement of Joint C (in mm, up to one decimal place) is „JointC P 2AE 7. AE AE Figure 05
A portal frame shown in figure (not drawn to scale) has a hinge support at joint P and a roller support at joint R. A point load of 50 kN is acting at joint R in the horizontal direction. The flexural rigidity. El, of each member is 106 kNm². Under the applied load, the horizontal displacement (in mm, round off to 1 decimal place) of joint R would be Q P FIAT 5 m EI pole El 10 m R 50 kN
Solve for the y-component (in mm) of the centroid if that a=2.3, b=2.5, c=4.4, d=8.8, and r=1.5. All dimensions are in inches.Round off only on the final answer expressed in 3 decimal places. Use: 1 inch =25.4 mm
B1
Engineering Mechanics DETERMINE THE INTERNAL FORCE OF MEMBER DF FROM THE FIGURE BELOW. Note: for compression, include a negative sign ( - ) and for tension, type answer as is. Use four (4) decimal places during computation and two (2) decimal places for the final answer.
Please provide solution with explanation in detail
An aluminum bar of cross-section 450 ??² is acted upon by the forces as shown in the figure. Determine the total elongation of the bar. Use ? = 70 ???.
with explaination thanks
A rectangular steel block is 4 inches long in the x direction, 3 inches longin the y direction, and 4 inches long in the z direction. The block issubjected to a triaxial loading of three uniformly distributed forces asfollows: 48 kips tension in the x direction, 60 kips compression in the ydirection, and 54 kips tension in the z direction. If ν = 0.30 and E = 29 ×106 psi, determine the single uniformly distributed load in the x directionthat would produce the same deformation in the y direction as the originalloading. Note provide a diagram/figure. -Draw and label the diagram correctly, No diagram in the solution will be marked wrong. -Shortcut solution will be marked wrong.- Direction of the assumption of the equilibrium equation must be shown, no direction will be marked wrong.
answer f3 and p only