series RL with R = 10-Ω and L = 80-H connected across a 24 VDC source for a LONG TIME, what is the current through the inductor? Write the values only (round to four decimal

A series RL with R = 22-0 and L = 81-H connected across a 24 VDC source for a LONG TIME, what is the current through the inductor? Write the values only (round to four decimal places).

180 is the answer amount of ohms needed on the oscilliscope. I need to transpose the equation to solve for R. I must work out an equation that equals 180 ohms R resistance that gives off 50mA of current using the transposed equation. Series impedence ,inductive reactive, phase angle formulas may need to be used. I need to get as close to 180 ohms as possible.

A 6-ohm resistor is connected in parallel with a 300 uF capacitor and the circuit is supplied by a 10A 60Hz current source. Find the instantaneous current through the resistor and the capacitor.

A resistance R. an inductancel =0.01H and a capacitance C are connected is series. When an alternating valtage v = 400 sin (3000t - 20°) is applied to the series combination the current flowing is 10/2sin(3000t -65°).Find the values of Rand C.

show the complete solution for this problem, thanks!

2. Find the energy stored in inductor Lx for the circuit shown in figure C2 if total inductance of the circuit is 33mH. The current through Lx is 5 A 5 mH 9 mH LT 80 mH 70 mH 8 mH Figure C2

Original Schematic and OrCAD Schematic: The input primary voltage is 250V, frequency 50 Hz, primary inductance setting is 2000H and secondary inductance is 10H and voltage peak to peak ripple is approximately equal to 92mv. U1 D4 IN our DINA002 C3 DIN002 90u R1 R2 10k TXI BC540A V1 VOFF =0 VAMPL 2 FREQ- 50 AC0 XFRM_LINICT-SEC D5 DIN4002 C2 0.384m 84 5 HH

The picture shows three LC circuits, two of them with capacitors of capacitance C and the three with coils of inductance L, the three circuits are coupled by means of two capacitors Cc capacitors.L inductance coils, the three circuits are coupled by means of two capacitors of capacitance Cc. The currentscirculating through each mesh are those indicated in the figure: I1, I2 and I3. Using Kirchhoff's law for voltagesand taking into account the definition of current I = -dQ/dt, find the system of coupled equations for the systemand then find the angular normal frequencies of the system.

For the following circuit, Vsrc=1.5 V and Rload%3D225 Q. What is the power sourced by the DC voltage supply? Is Vsrc VR Rload 1.5 W 10 mW 81 mW 6.67 mW