SA7. Two solutions have identical absorbance value at 350 nm of 0.100 Abs unit. One contains fluorene and the other anthracene. The fluorescence emission intensity measured from the anthracene sample was higher than that measured from the fluorene sample. Explain the fundamental reason for this observation.

SA7. Two solutions have identical absorbance value at 350 nm of 0.100 Abs unit. One contains fluorene and the other anthracene. The fluorescence emission intensity measured from the anthracene sample was higher than that measured from the fluorene sample. Explain the fundamental reason for this observation.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter26: Molecular Absorption Spectrometry

Section: Chapter Questions

Problem 26.32QAP

See similar textbooks

Similar questions

Three compounds (A, B and C) are mixed together ( they are present in the same container). Molar absorptivity coefficients of these compounds at 575nm -1 -1 are: 2500, 3750 and 5250Lcm mol, respectively. Concentrations are: 2 × 10M for A, 5× 105 M for B and -6 1.5×10 M for C. What is the absorbance measured at 575mm, in 1.0cm cuvette of the solution containing all three compounds? Show your calculations.
You have to obtain the UV-Vis spectrum of biphenyl which has an absorbance maximum at 245 nm. Which of the following solvents (toluene, methanol, hexane) would you use for the task? Explain.
Define mass spectroscopy and the underlying principle/background of its method for characterizing samples.
Carbon monoxide [CO] exhibits an IR absorption at 2143cm-1, acetone [CH3C(O)CH3],exhibits an IR absorption for the CO vibration at 1715 cm-1 and ethanol [CH3CH2OH] exhibits an IR absorption for CO at ~1150 cm-1. Draw Lewis structures of these three molecules and use your structures to explain the observed differences in the CO IR absorption peak frequency (nCO).
biphenyl has an absorbance maximum at 245 nm. Obtain the UV-Vis spectrum of biphenyl Which of the following solvents (toluene, methanol, hexane) would youuse for the task? Explain.
1. at what wavelength was Pb determined? 2. What is the slope of the calibration curve? 3. What is the y-intercept of the calibration curve? 4. The researcher determined the Pb content of water sample from a river suspected to be contaminated with Pb from a nearby factory by complexing with cyanidine and the absorbance measured was 0.405. What is the lead content of the water sample?
Share Highlight Rotate Markup When XeFa was originally prepared a combination of IR and Raman spectroscopy was used to determine its geometric structure (nominal Dan VS Ta). The data showed three bands in the Raman and two bands in the IR (it was predicted that a third mode should have been observable, but it was too low in energy to be seen by the authors' instrumental set-up). a) Derive r3n for XeFa in Dan and Ta symmetries b) From F3n determine rvib for XeF4 in Dah and Ta symmetries c) Determine which normal modes are IR active and which are Raman active for XeFa in Dah and Ta symmetries d) Show that the experimental vibrational data is consistent with square planar XeF4
6 Why standard solutions are used in Atomic absorption Spectroscopy (AAS) whereas UV-Vis molecular absorbance only extinction coefficient is necessary?
7 of 10 > Atomic absorption spectroscopy was used to determine the amount of aluminum in a sample of sunscreen. A blank solution was measured seven times to determine the detection and quantitation limits of the spectrometer. The blank readings were: 0.0073, 0.0082, 0.0110, 0.0101, 0.0102, 0.0098, and 0.0090 AU. Determine the signal at the detection limit and the signal at the limit of quantitation for this method. signal detection limit: signal limit of quantitation: hulu étv 14
The spectra (IR, ¹H NMR, ¹³C NMR and MS) of an unknown compound are shown in the following spetta. Based on these spectra, determine the structure of the unknown compound. Explain your answers clearly for each spectrum. Absorbance/% IR 2000 1500 1000 500 50- 100+ 4000 11 1H NMR 3000 Integration 9 10 2500 7.95 7.25 U 2 2 8 7 Wavenumbers/cm-1 6 5 ppm 4.30 2 3 2.35 3 2 1.35 3 T 1 O
Identify the following in the given IR Mass spectrum. Compound 1 Mass Spectroscopy: Interpretation of peaks: Compound 1 Mass Spectroscopy: MASS SPECTRUM 100 80 60 40 20 0.0- 10 20 30 40 50 60 70 m/z Interpretation of peaks: Rel. Intensity
The max peak in the UV-VIS absorption spectrum of acetone appears at 279nm when hexane is used as a solvent, but shifts to 262nm when water is used as solvent. Explain.