Resistor Resistance Voltage Current 1 100 Ohm     2 47 Ohm     Total   10 V   Complete the table by filling up the blanks with the appropriate information about two different resistors arranged in parallel. Show all pertinent solutions.

Q: Consider the following signal: s(t) = 20 cos(1000.pit)][cos(4000.pit)]. The Nyquist rate for this…

A: Given signal, st=20 cos 1000πtcos4000πt

Q: The cross product of two non-identical vectors is always new vector parallel to both of them. O True…

A: We need to tell about whether the given statement is true or false.

Q: Find vo(t) using nodal analysis. 5 sin (1000 t ) ( T • 30 Ω 10 Ω www 10 Ω 50 MF 10 mH

A:

Q: * Q2: Find the (Rth and Vth) by using thevenin's theorem in the circuit as shown below? R1 47002 A B…

A:

Q: What are important aspects of using a MOSFET? O Great efficiency Can operate at low voltages O High…

A: Given  What are important aspects of using a MOSFET....

Q: equation. known node voltage, we only need voltage = 0 (16.4.1) (16.4.2) V₁ - Vs 10/3 V₁-0 i(0) V₁ -…

A: How 0.1 is taken out as common from the equation (16.4.1) ?

Q: Exhibits no energy gap between the valence and conduction ? OInsulators O Conductors O…

A: We need to select correct option for given statement

Q: 23. For the voltage-divider configuration of Fig. 7.95, determine a. Ipo and VGS b. VD and Vs. 9 24…

A: We need to find out current and voltage for given circuit

Q: Exhibits no energy gap between the valence and conduction ? OInsulators O Conductors O…

A:

Q: what the value of RL for the zener to draw maximum power. IR ww 200 Ω 20 V 667 Ohm O200 Ohm O250 Ohm…

A: We need to find out the value of load resistor for given circuit

Q: 54. If both JFETs in the cascade amplifier of Fig. 8.93 are changed to those having the specifica- =…

A:

Q: Design and calculate the values of collector resistance and base resistance of the common emitter…

A: For the above given common emitter amplifier we need to design all the resistances which are…

Q: q(s) = s(s+ 9) (s+ 9 + j 9) (s+ 9-j9) +K The value of parameter K when s=9+j9 is.

A: Ans :(b)  Since characteristic equation equal to zero ...to find closed loop poles or roots

Q: Find current I in the circuit in 12 Ω 50/0° 2Ω 4Ω m -j3 Ω b 4 Ω 8 Ω C 16 Ω 8 Ω

A: Calculation of current I in the given circuit : In the circuit first need to simplify the circuit…

Q: Given a transformer connected to a constant pressure system at a frequency of 60 cycles, would the…

A:

Q: Red = ? 6Ω Μ 1 Μ 7 19 6924 2Ω www 2 Μ Β ΙΩ 6Ω 35 Μ 2Ω 3 Μ 9 2Ω ΖΩ

A: Given circuit:

Q: VDS is 1 ΜΩ .2V + Ο τον Ο 4.75v Ο 24V Ο 811 G VGS 0 16V • 2 ΚΩ OD -S Ips = 10 mA = Vp =-8 V

A: Given data, IDSS = 10 mA , VP = -8 volts, We know input impedance of JFET Is infinite ohms so input…

Q: 13.42 For the ideal transformer circuit of Fig. 13.106, find Vo. -j50 Ω 10 Ω www 1:4 120/0° V το 20…

A:

Q: 25³ +54 +25³ +4s² + s +6 Ans. 2 D2.11 The Routh-Hurwitz tests for the following polynomials might…

A: Routh Hurwitz criteria :- Coefficient of characterstics equation should be real and positive and no…

Q: 8- The inverter output is a distorted ac signal because of the voltage harmonics,the most difficult…

A: Solution of question (8): It is asked which harmonics are most difficult to filter. We need to…

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377…

A: Given data:  AB=BCElement 1:  Distance between point B and point N is 0.707 and it makes the angle…

Q: The device (or element) that used to protect electronic components which are vulnerable to reverse…

A: here we need to find the device ( or element ) that used to protect electronic componentswhich are…

Q: Clamping cut down the certain part of the input wave. True False Explain if True or False R…

A: For the above given statements we need to find their correctness whether they are true or false with…

Q: *8. Determine V, and Ip for the networks of Fig. 158. 0 Vo Si | |10 mA ' 2.2 ΚΩ • 2.2 ΚΩ +20 V Ο 6.8…

A: a) Given,

Q: What is the force (in Newtons) applied to a point charge of 2.4 mC placed at a uniform electric…

A: Given, Charge, q=2.4 mC Uniform electric field intensity, E=400 V/m

Q: The function of zener diode is to provide a constant output voltage to a load. this process is…

A: Function of Zener Diode:

Q: series type ohmmeter,

A:

Q: b) A single-phase diode bridge rectifier has a purely resistive load of R-15 2 and, VS-300 sin 314 t…

A:

Q: V=+02V — V=-0,5 V - V, = +0,8 V – 33 ΚΩ 22 ΚΩ 12 ΚΩ Μ 10 + R₁

A:

Q: The order of operations when executing arithmetic operation is: Multiplication Division and mod -…

A: Answer: false

Q: The switch in the circuit shown in figure beside has been closed for a long time, and then opens at…

A: given here a electrical circuit and asked to find the voltage across the capacitor.

Q: Example: X1 X2 X3 1 Fine the transfer function for this system O O 1 O -2 O 1 10 EHH

A: Given State matrix representation is shown below. x1˙x2˙x3˙=010001-1-2-3x1x2x3+1000uy=100x1x2x3…

Q: Q5/B: Explain delta-star connection of 3 ph transformers. What its advantages and disadvantages?

A: ∆-Y connection of 3-phase transformer: In a three-phase transformer with a delta-star connection,…

Q: Q4:- A) Series resonance Circuit, R = 156 02, L = 1.26 mH, C= 2.01 µF Calculate:- 1) fr, 2) Qr, 3)…

A: In this question we will find resonating frequency , bandwidth ,quality factor for given circuit....

Q: V₁ - Vs 10/3 V₁-0 i(0) V₁-[v(0)/s] + 5s S 1/(0.1s) or 2 1 How 0.1 s +3+ ² ) v 3 V₁=+=+0.5 S S S…

A: To explain how 0.1 is taken out as common from the equation no. (16.4.1)

Q: peration of the diode and the entire circuit. Use drawings to illustrate how battery current changes…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 19. In a series circuit containing pure resistance and a pure inductance, the current and the…

A: given in a series circuit containing pure resistor and pure inductor.current in the circuit is i t…

Q: mean square (rms), and peak current ratings of the diode. Assume Ip = 500 A of a half sine-wave.…

A:

Q: Determine IE and VC for the network. +8 V 3.3 ΚΩ B-110 Vc 3.9 k -0-12 V

A: The current gain β is the value obtained by dividing the collector current by the base current. For…

Q: A source generates binary digits 0, 1, with probabilities P(0) = 0.3 and P(1) = 0.7. Calculate the…

A: given a source generates binary digits 0 , 1 with probabilities P0=0.3 & P1=0.7Here we have to…

Q: trasformer has a copper loss of 1.5% and reactance 3.5% when tested on load. Calculate its full load…

A:

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

A:

Q: Given the magnetic circuit, calculate 3 from the right column if the coil wound in the left column…

A: Magnetic flux is the number of magnetic fields passing through a magnetic field. It is like an…

Q: ) For the circuit shown in figure beside, if V-480Cos400t Volt. Find the: 1. Average power delivered…

A:

Q: along time. d the numerical expression for ilt) for tyo? Also d Vlt) for tyo A www 40 A €405 20 602…

A:

Q: 7. A 3-phase, star-connected alternator generates 6,360 V per phase and supplies 500 kW at a p.f.…

A: Given data:  Generator voltage per phase = 6360 VGenerator line voltage = 6360×3 = 11.01 KV    Since…

Q: write true or false in the following sentences :. 1-Two quadrant operation of de motor can be…

A: 1- Two quadrant operation of the dc motor can be obtained from the three-phase thyristor-based…

Q: Zener diode is widely used as I I 1 I

A: In this question we will write about zener diode...

Q: What type of HVDC link is the following configuration? a) Monopolar b) Homopolar c) Bipolar d)…

A: The given HVDC link is shown below:

Q: Consider the following signal: s(t) = 20 [cos(1000.pit)][cos(4000.pit)]. The Nyquist interval for…

A: Given signal, st=20 cos 1000πtcos4000πt

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.