Two resistive coils R1, R2 are connected in parallel across 110 V DC supply and takes 18 A from the supply. The power dissipated inR1 is 600 W, then the value of resistive coil R1 isWindows buانتقل إلى الإعدادت لند

Answered: Image /qna-images/answer/d187a289-5fd7-4a99-968e-708c35bd1320.jpg

Answered: resistive coils R1, R2 are connected in…

resistive coils R1, R2 are connected in parallel across 110 V DC supply and takes 18 A from the supply. The power dis 600 W. then the value of resistive coil R1 is

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: The copper coils of a generator have an equivalent resistance of 10 Ω at 20°C. After being used for…

A: Given, The resistance of a copper wire at 20° C is 10 ohm. Let, at unknown temperature (say t)…

Q: . The resistance of the copper field winding of a DC machine at 40 deg. C is 0.40 ohms. After…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: b) A student sets up an electric circuit like the one shown in Figure Q1(b). i) Describe how a…

A: Given : Practical current source the student in the laboratory has made the circuit. The…

Q: How are branch circuits rated? See PEC 2.10.3

A: According to PEC 2.10.3 ampacity of branch circuit conductor should not be less that the maximum…

Q: Ques 2. Two coils connected in parallel across a 100V DC supply, take 10 A current from the supply.…

Q: A series circuit consists of a 66.2-uF capacitor and a variable resistor. For what two values of…

Q: If a voltage of 200 v, 50 Hz is applied to a resistance of 4092, write the voltage and current…

Q: The temperature coefficient of resistivity of carbon is -0.0005/C° . If the resistor is made of…

A: Solve the problem

Q: Answer the following. Use a detailed explanation. In clamping circuit, what is the value of the sum…

A: The upper or lower extremity of a waveform is clamped to a set DC voltage level by a clamping…

Q: What is GENERATION AND MEASUREMENT OF DC VOLTAGE? Give some introduction about it in 2 page if…

A: According to the question, we have to find the value of Generation and measurement and generation…

Q: c) For electric circuit in Figure Q1 (c), determine /, l2 and loz. l2 D1 Si V1 12 V D2 lo2 Si R1 3kQ…

Q: The temperature coefficient of resistivity of carbon is -0.0005/C°. If the resistor is made of…

Q: 2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are…

A: The solution can be achieved as follows.

Q: In the figure, the ideal batteries have emfs ℰ1 = 25.0 V and ℰ2 = 0.500ℰ1, and the resistances are…

A: Given circuit is - Given values are -

Q: The circuit shown below is an example of a simple voltage regulator. Determine the current through…

Q: 23. (a) Find the equivalent resistance between A and B in the circuit in Figure below. b)i State the…

Q: A

A: Ohms law: V=IR Where V=voltage across resistor I= current flowing through the resistor R=…

Q: Q4/ Assume DC source with internal resistance 7.5 2, connect to load with 8 2 through copper wires…

Q: • A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current…

A: The snubber circuit consist of the series connected resistor and the capacitor Given Data: I = 5 uA…

Q: a) A coil consist of 2000 turns of copper wire having a cross sectional area of 0.8mm?. The mean…

A: Given data is number of turns of a coil n=2000. Cross sectional area A=0.8mm2 mean length per turn…

Q: Express your idea of free currents and bound currents.Are they linked

Q: Q2- (A): Draw the thyristor v-i characteristics and define each region of operation. Explain briefly…

Q: If a circuit has two equal parallel resistances connected to a 150V DC power source , then the P.D.…

A: if the two resistance are connected in parallel then the voltage across the both are same

Q: B. Maximum current circuit Circuit connection for minimum current delivered by a 30V DC source:…

A: This question belongs to circuit theory . It is based on the concept of ohm's law in the circuit .…

Q: Draw the mechanical network for the system in Figure below and draw it's analog circuit using…

A: electrical analogy

Q: A coil of copper wire has a resistance of 10 2 at 20-C. If the temperature coefficient of resistance…

Q: Solve for V1 and V2 using nodal analysin in figure 2.86

Q: Find the current in the 17 ohms resistor by using Wye/delta conversion. Provide a clear solution.

Q: A coil consists of 2000 turns of copper wire having a cross-sectional area of 0.8 mm2. The mean…

A: Given a coil consist of, Number of turns = 2000 turns The mean length per turn, l = 80 cm = 0.8 m So…

Q: Find the open-circuit voltage and current i flowing in 6-ohm resistor.

Q: A coil of copper wire has resistance of 90 Ω at 20°C and is connected to a 230- V supply. By how…

Q: resistors? 5. Two equal resistors R and Ra are connected in parallel and to a 120-volt source. What…

A: From which end u r assuming potential will really matter

Q: 82 42 82 12V Figure Q2(b)

Q: What is the temperature coefficient of resistance, and what are its units?

Q: THE POLARITY MARKINGS ON TWO WINDINGS MUST BE DETERMINED EXPERIMENTALLY. THE DEVICE FOR SUCH…

A: The solution is given below

Q: RIN = 75 N±%5 ve ROUT = 300 2± %5 b) Design the circuit in the figure with when there is no…

A: Given data: RIN=75±%5 Ω ROUT=300±%5 Ω Solution: To design a given circuit, we have to replace the…

Q: The resistance of the copper field winding of a DC machine at 40 deg. C is 0.40 ohms. After…

A: The solution can be achieved as follows.

Q: A single phase half-wave rectifier is connected to a 300V RMS 50Hz AC supply. If the rectifier is…

Q: Using Kirchhoff’s rules, a) find the current in each resistor shown in the figure and b) find the…

Q: b) A parallel clipper circuit with a 5 V DC supply is depicted in Figure Q2b. Sketch the output…

A: Given that

Q: Four resistors are connected in parallel across a 200-mA independent cu rent source as shown in…

Q: The working coil of a 0-400 V moving - iron volmeter requires 300 ampereturns to give full - scale…

Q: 1 kN 100 N 100 mA 500 N 50 N

A: Given: Figure

Q: R, R www

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Using Kirchhoff's rules, find: (a) the current in each resistor (b) the potential difference…

A: Given data, The value of resistances as R1 = 2 KΩ , R2 = 3 KΩ , R3 = 4 KΩ The value of emf as E1=…

Q: A resistance of 120 ohms is supplied by a 220 V, 60 Hz source. Determine the equation of voltage and…

A: In this question we have given some data... We have to write equations of voltage and current…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

Two resistive coils R1, R2 are connected in parallel across 110 V DC supply and takes 18 A from the supply. The power dissipated in
R1 is 600 W, then the value of resistive coil R1 is
Windows bu
انتقل إلى الإعدادت لند

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Choose the correct answers The coil winding in PMMC meter is -1 small heavy large fine
Determine the loop currents Ia, I,, and Ic. 100 Ic 100 100 100 100 Ib 55V 100 V la
Three coils each having resistance of 12 Q are connected in star across 413 V, 50 Hz supply. Then the total power consumed is OSs O 715.36 W O 1184.58 W O 8206.75 W O 14214.08 W
AC xuf lac V ac 21. The simple AC powered circuit above is being measured for AC current and voltage across a 1uF capacitor. The measured current is 200mA and the measured voltage is 40V. (note: 2 separate questions follow) a. Calculate the capacitive reactance, Xc. b. Calculate the voltage frequency.
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
Determine the DC currents (la. lc and I) and dc junction voltages (Var Ver and Vca) la-Blank 1 mA, le-Blank 2 mA, I-Blank 3 mA, Var Blank 4 V, Vcr Blank 5 V and VcB - Blank 6 V Use 2 decimal places. Use the following values. VBB= 3V RB= 5kOhms Rc=232 ohms Vcc =18 V BDC=65
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
The maximum power that can be generated by a wind turbine is called Select one: O Cut-in Power O Cut-out Power O lock-in Power O Rated Power
Given the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz (operating values). Choices: 0.11A 22mA to 89mA 9A 0.11A to 9A Plss show complete solution
نقطة واحدة Series Field * The electrical circuit diagram in the figure is described Ise Rse Eb Ra LOAD DC series motor DC shunt motor O AC series motor O AC Shunt motor O None of all O
Question 1 A direct current (DC) of 4A flows into a previously uncharged 20 pF capacitor for 3 ms. Determine the voltage between the plates. O A. 500 V O B. None of the given answers O. 600 V O D. 200 V O E. 800 V O F. 300 V