Refer to the given circuit below. Determine the equivalent resistance across terminals b and d if R1 = 20 R2 = 4 0 R3 = 70 R4 = 8 0 R5 = 20 R6 = 3 0 R7 = 20 Rg = 20 R1 R2 R3 R4 R5 R6 R7 Rg b d

Q: three phase converter has a rating of 600 kW when operating at unity power factor. Neglecting any ch...

A: We need to find rating at given power factor

Q: 7. The Fourier series of an even and half-wave periodic function, contains only a. none of these odd...

A: In this question we will write about Fourier series of even half wave periodic function....

Q: ovecall 40 kwh per day (the month) average.we need a geathermal system to couer oll the healing and ...

A: Geothermal energy is considered a renewable resource. Ground source heat pumps and direct use geothe...

Q: Jx, 0<x<π, f(x) = Problem 4: 10, π<x< 2π;

A:

Q: One branch A of a parallel circuit consists of a 60-µF capacitor. The other branch B consists of a 3...

A: Kirchoff's law and ohms law are the two important tools to analyze the electrical circuits. Accordin...

Q: Find the resultant angle when given a pure sine phasor with magnitude 10 and a pure cosine phasor wi...

A: In this question, Find the resultant angle when given a pure sine phasor with magnitude 10 and a pur...

Q: 1. One of the complicated parts of solving for the input impedance is the hyperbolic tangent of the ...

A:

Q: 5. Find the 6th term of the expansion of 3x - c. -41236/ x5 d. -61236/ x4 а. -51236/ x4 b. -61236/ x...

A:

Q: . A three-phase,50-Hz, 470-V system supplies the following loads:
 A six-pole, 50-Hz, 340-hp, three-...

A:

Q: Two coils are connected in parallel across 200 V, 50 Hz mains. One coil takes 0.8 kW and 1.5 kVA and...

A: In this question,  Two coils are connected in the parallel. calculate the single coil which would ta...

Q: If three Impedances each of (8-j 6) N are connected in mesh across a three-phase 400 V ac supply, th...

A:

Q: FIGURE R4 20 R5 V1 102 3PH C1 120V 60HZ 1mF L2 10mH Figure 3.1

A:

Q: 3. A Fourier series representation of a periodic signal #(t) is given by (t) =2+ 2 -int/2 2+jn n-00 ...

A: The solution is given below 

Q: 1. Assume that the registers are 8-bit wide. Consider the following code: MOV R1, #4A MOV R2, #40 AD...

A:

Q: a. Find all currents: I, I, and I, using superposition and Mesh Analysis. b. Find V. a 20V I, I2 V b...

A: In this question,  We need to determine the unknown currents and voltage v using the mesh analysis a...

Q: 2. Determine x using delta to wye transformation. In Bn 1o0V +

A:

Q: 100 220 V 50 Hz 0.138 H 12.6 uF f(x) = 0 90 ohm Solver Configuration Electrical Reference Scope รูปท...

A:

Q: The transition matrix of a channel is given by: [0.1 0.2 0.25 0.55 If p(x1) = 0.4, find: a) noise en...

A: The given transition matrix is: pYX=0.10.30.60.20.250.55px1=0.4

Q: 8. Given r(t) = 5 cos 4nt 8(t - 0.25) then X (w) is %3D a. 5e-jw/4. b. 5eejw/4 c. 5eie-ju/4 d. 5eJw/...

A:

Q: L max the frequency (in hertz) of the resulting ocillations. 77 HZ = 1.00 ms, find the charge on the...

A: Solution- At t=0  charge on capacitor, qmax= q0 = 170μCL=95 mHC=11μFLC= 95×10-3×11×10-6      = 1045...

Q: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle -45°

A:

Q: Write the equation of the output D of Half-subtractor using NOR gate. 2. (True or False) Full subtr...

A:

Q: 100 A 220 V 50 Hz 0.138 H f(x) = 0 90 ohm Solver Configuration Electrical Reference

A:

Q: Does the reverse saturation current of the diode change significantly in magnitude for the reverse-b...

A: Given: Diode reverse saturation current

Q: Draw the equivalent logic circuit diagram of the given expression.  F= (ab) + (ac)

A: Logic circuit- A logic gate is a digital circuit which is the fundamental building block of logical...

Q: A- Using Kirchhoff's current law, determine the unknown currents for the below network. 5 mA 3.5 mA ...

A: Given, We have a network. We have to find the unknown Currents. Please find the below attachments fo...

Q: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle -45° A

A: Given, Two magnitudes with angles , We have to draw the phasors. Please find the below attachment fo...

Q: A 120-hp, three-phase, wye-connected, 50-Hz, 450-V, four-pole, cylindrical-rotor synchronous motor i...

A: Given: Power, P=120 hp=89484 W Frequency, f=50 Hz Voltage, V=450 V  Power factor, cosϕ=88 % leading ...

Q: Given the circuit fed by 50HZ voltage source Vs, knowing that Z1 is an inductive load with 0.8 power...

A: Given circuit shown  frequency f=50 HzZ1 is inductive load Z2 is capacitive load

Q: calculate the shot noise current in a transistor whose average collector current is 5mA if it is ope...

A: In a transistor the Major contributor to noise is "Shot Noise". The value of shot noise current in a...

Q: PROBLEM 4.1 Consider the circuit containing a nonlinear element N as showr in Figure 4.54. The v-i r...

A: Given: The circuit below contains a nonlinear element N whose v-i relationship is given by: iA=c2vA2...

Q: three phase converter has a rating of 600 kW when operating at unity power factor. Neglecting any ch...

A: We need to find out rating for the given power factor .

Q: Find the no-laad phase and line valtapge of a star- Comected. 4-pole altemator having flux per pole ...

A: GIVEN: double layer winding             flux=0.15             slots per pole per phase (m)=4        ...

Q: Explain the concept of supermodel and supermesh.please designas an example,  two seperate circuits w...

A: Node:It is a point or junction at two or more elements join each other is called Node. Mesh:It is a...

Q: 1.Determine the resistance of a four-band resistor having a color sequence of red, yellow, black and...

A: Resistance values of four band indicates 1st digit 2nd digit 3rd multiplier and 4th tolerance Black-...

Q: A coil is in series with a 20 µF capacitor across a 230-V , 50-Hz supply. The current taken by the c...

A: In this question,  We need to calculate the value of inductance of the coil if power factor is laggi...

Q: AC resistance in ohms per km

A: 1. Given- Diameter= 3/4''=228.6 mmCopper conductivity= 97.3%Frequency= 60HzTemperature= 75o  

Q: The load on a 250 V supply system is : 12 A at 0.8 power factor lagging; 10 A at 0.5 power factor la...

A:

Q: The load on a 250 V supply system is: 12 A at 0.8 power factor lagging; 10 A at 0.5 power factor lag...

A:

Q: A 50 Hz, 250 V single phase power line has the following loads placed across it in parallel; 4 kW at...

A: Given    Single phase 50 Hz,250 v power line   Three parallel loadsLoad-1P1=4 kwPF1=0.8 laggingLoad-...

Q: 20. Which of the following cannot be the Fourier series expansi a periodic signa a. all of these can...

A: Fourier series is only for periodic signals 

Q: 1. The torque profile applied to the shaft of the ball-and-lever system shown below is given. Assume...

A: Answer -

Q: Suppose an ideal bandstop filter is used to remove an interfering signal that has bandwidth 10a, whe...

A: The solution is given below

Q: 8. Determine the value of I1 and I2 in the network. I 102. 3:1 220/0° V elll ll

A: We need to find out current for given circuit

Q: 1. Find the AC resistance in ohms per km of a ¾" diameter conductor made of 97.3% conductivity, hard...

A: It is given that: d=34 in=2.54×34conductivity=97.3%f=60HzT=75°CAssuming,l=100cm

Q: What is the effect of the resistance connected in series with the capacitor on the feedback?

A:

Q: R3 ts) - For the below network: (1 a. Find the total resistance RT. b. Find the source current Is an...

A:

Q: how to solve v1  node voltage

A: The node equation is in rectangular form and the node voltage V1 can be obtained by simplifying the ...

Q: 1. See example 4.2 on page 112. For silicon at 300 K, calculate the clectron concentration, no for t...

A:

Q: 1. Determine v1 and v2 in the following circut 82 ww ЗА 12 V 40 ww

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.