Real liquid (y = 10 kN/m3) is flowing laminar in a pipe at a steady rate, but the direction of flow is unknown. Is the liquid moving upward or moving downward in the pipe? If the pipe diameter is 8 mm %3D Elevation 10 m --p 110 kPa and the liquid viscosity is 3.0 x 10-3 N. s/m? what is the magnitude of the mean velocity in the pipe? Elevation = 0m ----p= 200 kPa

Real liquid (y = 10 kN/m3) is flowing laminar in a pipe at a steady rate, but the direction of flow is unknown. Is the liquid moving upward or moving downward in the pipe? If the pipe diameter is 8 mm %3D Elevation 10 m --p 110 kPa and the liquid viscosity is 3.0 x 10-3 N. s/m? what is the magnitude of the mean velocity in the pipe? Elevation = 0m ----p= 200 kPa

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q3. SAE 30 oil (Sp. Gr. =0.833) with a dynamic viscosity 0.28 N.S/m? flows in a 4-cm-diameter pipe which is inclined with an angle 37°. For the pressure measurement shown, determine A. Whether the flow is up or down The flow rate in m'/h C. The shear stress and velocity 1 cm from the boundary Draw the shear stress and velocity profile with the section of the pipe. В. D. P-180 kPa P- sOokPa 15m 20m
PROBLEM 2 The pipe bend shown is in a horizontal plane. Oil with a specific gravity of 0.86 enters the reducing bend at section A with a velocity of 3.2 m/s and a pressure of 150 kPa. Neglecting head loss, determine (a) The velocity at section B, V (m/s) (b) The pressure at section B, ps (kPa) (с) Fмх (N) (d) FMY (N) (е) Fpx (N) (f) Fpy (N) (g) The x-component of the reaction by the bend, FRx (N) and (h) The y-component of the reaction by the bend FRY (N). de = 100 mm B- da = 150 mm 30°
1. A block, 1ft square and 9 inches deep floats on a stratified liquid composed of a 6in layer of water above a layer of mercury. Determine the weight of the block if the position of its bottom is 1 inch below the mercury. 2. At point A in a pipeline carrying water, the diameter is 1m, the pressure is 98kPa and the velocity is 1m/s. At point B, 2m lower than A, the diameter is 0.5m and the pressure is 20kPa. Determine the direction of flow. Show detailed computation. 3. What is the hydraulic radius of the channel shown: 1.5m 1.5h 4. wty A vertical right-angled triangular surface has a vertex in the free surface of a liquid. Find the force on one side. 1.5m 1:2m
Q1. An oil of relative density 0.92 and dynamic viscosity 0.082 Pa.sec flows in an 80 mm diameter pipe. In a distance of 20 m the flow has a head loss of 2 m. Calculate (i) the mean velocity. (ii) discharge, (iii) velocity and shear stress at a radical distance of 38 mm from the pipe axis and (iv) boundary shear stress.
Problem 9-36 pipe bend shown is in a horizontal plane. A fluid weighing 8.615 kN/m enters the bend with a velocity of 3.5 m/s and a pressure of 280 kPa. Neglecting head loss, find the force required to hold the bend in place. The Ans 10.4 kN 65 200 mm O 80 mm diam
PROBLEM 9 Heavy fuel oil flows from A to B through 3000 ft of horizontal 6-in steel pipe. The pressure at A is 155 psi and at B is 5.0 psi. The kinematic viscosity is 0.00444 ft?/s and the specific gravity is 0.918. (a) What is the head loss (ft) between A and B? (b) Assuming laminar flow, what is the velocity (ft/s) of oil from A to B? (c) What is the flow rate (ft/s) assuming laminar flow? (d) Is the flow really laminar? Prove by solving the Reynolds Number.
Liquids A, B and C, in the containers shown, have SG of 0.60, 1.20 and 1.60 respectively. At what elevation (EL. A) will the liquid A stand in each of the piezometer tubes? Round your answer to the nearest hundredths. Pair = 12.5 kPa EL. 8 A (SG =) EL. 6 B (SG =_) EL. 2 C (SG =_) %3D EL. 0
An ideal liquid flowing through a pipe A of cross-section 0.2m² with velocity 10m/s enters a T-junction. One side of the T-junction B has cross-section area 0.1m² and the other side Chascross-section area 0.05m². If the velocity of water in C is 15m/s then in B the velocity is
Liquids A, B and C, in the containers shown, have SG of 0.60, 1.00 and 1.60 respectively. At what elevation (EL. C) will the liquid C stand in each of the piezometer tubes? Round your answer to the nearest hundredths. Pair = 12.5 kPa EL. 8 A (SG =) EL. 6 B (SG =_) %3D EL. 2 C (SG = EL. 0
A time independent non Newtonian fluid of density 0,00085kg/cm3 flows in a cylindrical pipe with a mean linear velocity of 1.70 m/s at steady state. The pipe is 3m long with an inside diameter of 0.075m. The point pipe consistency coefficient is 1.52 (N/m2)s0.3 and the flow behavior index is 0.3. Determine: a) The point values of the apparent viscosity. b) Reynolds Number. c) Pressure drop in Pascals.
Q2. Oil with an absolute viscosity of 0.125 N.s/m² and a density of 890 kg/m' is flowing in a 16.5 cm diameter pipe at a 7.5 L/s flow rate. • The fully developed flow is expected to start after.. ... m of pipe entrance.. • plot the shear stress within the pipe cross section.
Q-Water flows through a pipe having an inner radius of 10 mm at the rate of 36 kg/hr at 25° C. The viscosity of water at 25°C is 0.001 kg/m.s. The Reynolds number of the flow is