Answered: R Vs( the C

Engineering

Electrical Engineering

R Vs( the C

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 22RQ

See similar textbooks

Related questions

Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the…

Q: A voltage is given by v(t)=50 sin(500πt+120°).. First, use a cosine function to express v(t). Then,…

Q: In the circuit in the figure, there is a load formed by connecting the resistor R0 between the…

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 2, (b)…

A: In this question, find the instantaneous current with different different impedance. Draw the…

Q: 6 Find the real and reactive power supplied by the source in the circuit shown in Figure P7.26.…

A: Given circuit is – Total impedance is –

Q: In the circuit in the figure, there is a load formed by connecting the resistor R0 between the…

A: In the circuit in the figure, The amplitude of the voltage Vs (t) is √2 150 volts, the phase angle…

Q: 7.34 Suppose that the electricity in your home has g out on a hot, humid summer day and the power…

A: The air conditioner consumed power is found below; Average power,PA=V×I×p.fV=120 V,I=9.6…

Q: Two sinusoidal voltages of the same frequency have rms values of 8 V and 3 V. What is the smallest…

A: As the phase angles are unknown, the maximum RMS value can be,

Q: lectrical load that draws current whose impedance varies throughout the cycle of the put ac voltage…

A: Linear load is defined as whose impedance is constant throughout its applied voltage cycle.…

Q: The circuit shown is operating in the sinusoidal steadystate. Find the value of ω ifio=100…

A: The current signal in cosine wave is: So, the current and voltage in polar form are respectively:…

Q: In U.S. residences, electrical power is generally utilized at a nominal voltage of 120 V rms. What…

A: If the electrical grid is designed for voltage 12 V rms, the power supply would be made difficult.…

Q: 9 Determine the time-averaged total power, the real power dissipated, and the reactive power stored…

A: Consider the impedance Z1. The current through this impedance is,

Q: A 240-Vrms, 60 Hz source skpplies two loads as shown above. Find the capacitance of a capacitor…

Q: A sinusoidal voltage v(t) has an rms value of 20 V, has a period of 100 μs, and reaches a positive…

Q: The circuit shown in Figure Q5.1 consists of a current source connected to a load via a cable. The…

A: Current is given , On comparing with standard equation. Taking cos as reference current will be,

Q: Given the waveform of a voltage source shown inFigure P7.8, find:a. The steady DC voltage that would…

A: Part (a) The period of the given wave is 2 s. The heating effect of the wave is decided by the RMS…

Q: 1. A 70-Vac source has the following waveform. Determine: a) Vp b) Vpk-pk c) Vrms d) Period e)…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: 1 H 7. The circuit shown in the figure has two sources connected in series. Find the rms 10 value of…

Q: Find the forced solution by using the Sinusoidal Continuous State Analysis method.

Q: For the circuit shown in Figure P7.43, assume thatvg = 120 V rms. Finda. The total resistance seen…

A: The given circuit is: Where, Vg = 120 V (RMS)

Q: 2. A 70-Vac source has the following waveform. Determine: a. Vpk b. Vpk-pk C. Vrms d. Period e.…

A: According to Bartleby question answer rule I have to solve first three part of a question hence I…

Q: voltage is +80 V k. the time (2nd occurrence) after t = 0 when the voltage is –10 V Answers: a.…

Q: If we knew that the transformer shown in FigureP7.49 were to deliver 50 A at 110 V rms with a…

A: Write the given values on the secondary side of the transformer. Find the output power of the load.

Q: What is the mathematical expression of the voltage Vg(t) in the steady (continuous) state?

Q: Find the apparent power and the real powerdelivered to the load in the Y-Δ circuit shown in…

A: In the figure shown above in the circuit is the balanced 3-phase circuit. The voltage source…

Q: , reactive and apparent power consumed by the lo

A: The given load is an RL load that means the power factor of the load is lagging in nature means the…

Q: 3 For the following numerical values, determine the average power P, the reactive power Q, and the…

A: (a) Write the given values of voltage and current and write them in phasor form.

Q: A voltage is given by v( t )=10 sin(1000πt+30°). First, use a cosine function to express v(t). Then,…

A: Given data: vt=10sin1000πt+30° vt=10sin1000πt+30°cos90°-z=sin…

Q: 7.18 A single-phase motor draws 220 W at a power factor of 80 percent (lagging) when connected…

A: The circuit diagram of the motor is shown below: First, we will calculate the equivalent impedance…

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 Ω, (b)…

A: Given: Alternating voltage f=50 HzVrms=150 V

Q: Q.1. If an RMS current of 5 A at 60 Hz flows through an inductor of 10 mH, what is its average…

Q: as i (t ) = 125cos (5000π t −135) mA Determine the period, T, and the time, t1, at which the first

Q: For a source which has: • Vrms = 345 V • P= 8195 W • pf = 0.95 What is the rms current?

A: In this question we need to find RMS current .

Q: An industrial process requires a power of 10 kW with a lagging power factor of 0.6 in a single-phase…

Q: When the average real power absorbed by an impedance is zero, then the impedance is: Select one: a.…

Q: At t=−2 ms, a sinusoidal voltage is known to be zero and goingpositive. The voltage is next zero at…

A: (1) Write the expression for half time-period. T2=8 ms--2 msT2=10 msT=20 ms

Q: Read A 70-Vac source has the following waveform. Determine: a. Vpk b. Vpk-pk c. Vrms d. Period e.…

A: According to the question, A 70-Vac source has the following waveform as shown below, As mentioned…

Q: An AC source Vs1(t) and a DC source V2 is applied together to the circuit given below. a Find and…

A: L = 0.01H C= 0.0001F R1= R2= 10 ohm Vs(t) = 10√2 cos1000t v Vs = 10 v

Q: A telephone receiver has an impedance of 306 ohms at 800 cps and a resistance of 60 ohms. For what…

Q: Consider a 760 W light bulb that requires an RMS voltage 21 V to operate normally. How large should…

Q: Given the applied source and network below: a. Determine the sinusoidal expression for the source…

A: The solution can be achieved as follows.

Q: For the circuit shown below, Given that V= 10020°V, and I= 30430°Ams then the values of P2 rms and…

Q: 4 For the circuit of Figure P7.23, determine the power factor for the load and state whether it is…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: 7.73 To correct the power factor problems of the motor in Problem 7.72, the company has decided to…

A: The circuit diagram is, From the circuit,

Q: 3 The load Z, in the circuit of Figure P7.28 consists of a 25-2 resistor in series with a 0.1-mF…

A: As per our guidelines we can only answer a maximum of three sub-parts at a time. Please resubmit the…

Q: The expressions for the steady-state voltage and current at the terminals of the circuit seen in…

Q: 36 An industrial assembly hall is continuously lit by one hundred 40-W mercury vapor lamps in…

A: The total power consumed by 100 bulbs is:

Question

Compute the average power dissipated by the load seen by the voltage source in figure P7.6. Let omega = 377 rad/s, V_s = 50<0, R = 10 ohm, L = 0.08H, and C = 200 microFarads.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

so then how is Rth 0.8695 kOhms in the original explanation?
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
Sketch even and odd for this figure
Q3Where t = 7.18 Where fo =11.18
1. Find the average value of current when the current that are equidistant are 4A, 5A and 6A. a) 5A b) 6A c) 15A d) 10A
What is the ripple factor of a DC signal having ripple voltage of 2 V and a DC voltage of 50 V? Answer in percentage % O 8% O 1.2% O 2.83% O 4.0%
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
What's the rise time for this system with its closed-loop poles as shown? 14 -6 -4 12 -j6 Select one: a. 0.607 sec b. 3.14 sec C. 1.80 sec d. 0.254 seC e. 0.554 sec
The complex volt amperes in a series circuit are (4300- j2500) and the current is (25 + j43.3)A.Find the applied voltage.
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
From the given Ammeter diagram, the span is -- A. J0407 A O a. -1 O b. 4 O C. 3 d. -1 to 3
The transformers works on phenomenon of to change the values of alternating voltages and currents.