Answered: Quick help with short answer!! Only…

Quick help with short answer!! Only Analytical separation methods….. Question: What would you recommend to separate the two peaks that could not be separated in GC and HPLC?

Organic Chemistry: A Guided Inquiry

2nd Edition

ISBN:9780618974122

Author:Andrei Straumanis

Publisher:Andrei Straumanis

ChapterL2: Mass Spectrometry

Section: Chapter Questions

Problem 3E

See similar textbooks

Related questions

Q: If the TLC plates had been developed in a more polar solvent, would retention factors on the whole…

Q: Sixth question: Was a separation of a mixture of phenol to phenol? Rf is very valuable, TLC. and…

A: TLC is an important for sepration of compounds as it works on Forces of interaction with polar…

Q: Study figures 31-6 a & b in chapter 31 (page 863) of your prescribed textbook, and draw separation…

A: 1

Q: , can someone please help me interpret this IR? it was done in the lab and I've also attached the…

Q: What is the Rf value for the uppermost yellow spot in TLC plate 3 (plate imaged below)? It is…

A: The TLC plate 3 with all the spots is given below :

Q: and all basic drugs using SPE with hydrophobic resin. ▪ A)True In an untargeted analysis by GC-MS,…

A: 1) False In SPE technique ,one or more analyte from liquid sample are isolated by extracting or…

Q: would it be a problem to use an ink pen or a marking pen instead of a pencil, as directed in step 1…

A: question - would it be a problem to use an ink pen or a marking pen instead of a pencil, as directed…

Q: Why mixture of solvents such as ethyl acetate with 5% acetic acid is used as a solvent/mobile phase…

A: TLC (Thin layer chromatography) is a technique to separate the components of mixture. TLC uses a…

Q: What would happen if you put too much of a compound in the cuvette during the spectral measurement?

A: Given: Compound filling during spectral measurements To find: what happens if we fill the cuvette…

Q: It is never necessary to take more than one composite sample per field. True Or False

A: Composite soil sampling is the traditional soil sampling method. To make a composite sample we mix…

Q: How would you discuss method of separation and identification of compounds in TLC?

A: The laboratory technique used to separate components of a mixture is called chromatography. It…

Q: Explain how the charged aerosol detector used

A: Charged aerosol detector: The detector, which is used to detect (measure) the amount of charged…

Q: How does the wavelength in chromatogram affect the signal intensity in an HPLC

A: wavelength in chromatogram affect the signal intensity in an HPLC explanation is given below.

Q: Why should you not use a ballpoint pen when marking a TLC plate and why does the horizontal line…

A: If ball point pen is used, the ink will travel up with the solvent, just like the samples. The…

Q: Consider stereoisomers. What type of isomers would you expect would and what types could not be…

A: Thin-layer chromatography can be used to sperate cis and trans-isomer because these isomers have…

Q: I need help darwing a TLC plate and figuring out the Rf values is the retention factor values We…

A: The crude mixture is the component that is obtained directly from the reaction after its completion.…

Q: Choose suitable detector when you need analyse multi-analyte with multi wavelength. O a.…

A: The detector needed to analyze multi analyte with multi wavelength is given below.

Q: If a TLC was run in a solvent system that caused all the spots to show up at the baseline, how could…

A: Rf value Vs polarity of the eluent

Q: (a) Draw the curly arrow mechanism to show bonds being broken/formed (b) Comment on the polarity of…

A: (a) The curved arrow mechanism is shown below

Q: Question 9 how do you call the analysis technique done by identifying the fragments corresponding to…

A: fragmentation is the dissociation of energetically unstable molecular ions formed from passing the…

Q: f you were to try a column one-half the length of the one you usually used, how do you think the…

A: Retention time is defined as the time required for the solute to spend in a column.

Q: What would be the effect of increasing the carrier gas flow rate on the retention rate?

A: Retention time is the distance that the compound cover from the time of injection till the maxima in…

Q: What would be the effect of raising the temperature or increasing the carrier gas flow rate on the…

A: The gas chromatography is a set of separation techniques to find the volatile substances in gaseous…

Q: Investigate the linear calibration range of this experiment.

A: Lead Concentration, ng ml-1 Absorbance 10 0.05 25 0.17 50 0.32 100 0.6 200 1.07…

Q: You can perform a TLC experiment even if the solvent level is above the level of the initial spots.…

A: Here I have solved the question

Q: Would the spots on the TLC plate in Scenario 3 be visible under UV? Why or why not?

A: Thin layer chromatography is used to separate the non-volatile substances from a mixture. Here, two…

Q: Question a) Discuss the effect of solvent polarity on Rf-values.

A: Since you have posted two questions, we will solve first question for you. Please repost other…

Q: What four values are needed to calibrate a CO2 sensor (IRGA)? B. Briefly describe how to obtain…

A: These sensors depends on the IR light source and detects the quantity of CO2 molecules. Calibration…

Q: 2-naphthol IR Tables that contains the important peaks for the experimental

Q: What may have happened if you didn’t dilute the unknown sample and proceeded to measure the…

A: The importance of dilution in the measurement of absorbance to determine the concentration of…

Q: could products be isolated for further analysis suing TLC (thin-layer chromotography) as a…

A: Chromatography is a laboratory technique for the separation of a mixture into its components. The…

Q: Why are some of the detectors listed unsuitable for HPLC? Which of the GC detectors ) in the table…

A: The function of detectors used in high-performance liquid chromatography is to monitor the mobile…

Q: A HPLC column had a sample (0.10ml) loaded onto it. The detector volume showed 0.15 mL. From this…

A: Before starting any troubleshooting, whether it is related to instruments or columns, it isessential…

Q: Please list the appropriate peaks in the NMR spectra results with a short narrative. Thank you.

A: The multiplicity in NMR spectroscopy depends upon the number of nearest neighbouring protons by n+1…

Q: A student spots an unknown sample on a TLC plate. A single spot with an Rf of 0.55 showed up on the…

Q: state/hexane, the sample showed a single spot at 3.4 cm (relative to vent had risen to 7.1 cm…

A: TLC ( thin layer chromatography) is the technique used in chemistry laboratories to identify the…

Q: select

A: We know that A detector is a device that converts an amount of radiation into some other measurable…

Q: I need help to perdect the ir spectreum for this lab for the staring matrial and the product and…

Q: How can you ensure “good quality” peak separation in high performance liquid chromatography (HPLC)?

A: In HPLC , different kind of columns are used to separate to isomers. So, here by using trial method…

Q: Both melting points and TLC rely on differences in non covalent forces. Explain the role of these…

A: Answer - According to the question - TLC - Thin layer chromatography (TLC) is an affinity-based…

Q: Put all steps (below) of a TLC analysis in a correct order. Write the two main visualization methods…

A: TLC analysis in correct order is as follows.

Q: If peak A has a width of 10 min and peak B has a width of 16 mins, what is the column resolution?

A: Given :- Width of peak A = WA = 10 min Width of peak B = WB = 16 min Column resolution = ?…

Q: Different from GCMS, why is an interface needed when coupling HPLC with MS?

A: In addition to the liquid chromatography and mass spectrometry devices, an LC-MS system contains an…

Q: In TLC, point of origin refers to O The bhottom edge of the TLC plnto.

A: Question 1: Option 1 is the correct answer. The point of origin was sketched very lightly with…

Q: Paper Chromatography laboratory report explanation

A: Paper chromatography is an analytical method used to separate colored chemicals or substances. It is…

Q: Please describe possible sources of error in HPLC experiments - systematic and random and how they…

A: HPLC(High performance liquid chromatography) Errors in HPLC can be systematic and random. Systematic…

Q: Among a mixture of compounds, the one that travels highest on the TLC plate has O the highest Rf…

A: This can be explained as follows

Q: According to given TLC plate below which of the following statement(s) is/ are false ? |- Rf value…

A: It is given a TLC plate in which the solvent travels a distance of 0.75 (approximately), and…

Q: When would using Thin Layer Chromotography (TLC) NOT be useful in conducting an oxidation reaction?…

A: Although it is a very simple and convenient technique, one of its limitations is that it cannot tell…

Concept explainers

UV Visible Spectroscopy

Spectroscopy refers to the absorption or emission of light or other radiations by matter. When a substance or chemical absorbs light or radiation, they reach an excited state followed by de-excitation or emission of the light or radiation forming distinct spectra. UV-visible spectroscopy or ultraviolet-visible refers to the absorption and emission in the ultraviolet and visible regions of the electromagnetic spectrum.

Question

Quick help with short answer!! Only Analytical separation methods….. Question: What would you recommend to separate the two peaks that could not be separated in GC and HPLC?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

"Better resolution" means... a) detected peaks are separated from each other as much as possible and are as narrow as possible b) something in HPLC, but nothing in GC c) detected peaks are separated from each other as little as possible and are as wide as possible d) detected peaks are separated from each other as little as possible and are as narrow as possible e) detected peaks are separated from each other as much as possible and are as wide as possible
On what does the strength of MRI signal depend on? i.e. can we increase it or control it?
Assign as many non-fingerprint region peaks as possible in anisole
From this IR what are the relevant peaks?
I need some help assessing the spectra of maleic anhydride how do I determine the integration, multiplicity, chemical shift for each structure/ fragment part of the maleic anhydride
M Can somebody explain the peaks for this HNMR and CNMR for deoxybenzoin?
The absorbance of sample A is higher than the absorbance of sample B. Therefore, sample A has (circle the correct one) more / less dissolved solute than sample B. The absorbance is (circle the correct one) directly / inversely related to the transmittance of a sample.
Find all the IR Peak Assignment and NMR Peak Assignment
What does it mean if the peaks of all samples are the same in UV Visible spectroscopy? How about in Fluorescence Spectroscopy? Include reference link
Which method, AES or XPS, is better for resolving chemical shifts and why?
state if true or false 1. Considering that concentration and the size of sample container are the same, a sample with a higher molar absorptivity will have a higher TRANSMITTANCE than a sample with the lower E (molar absorptivity). 2. Considering that concentration and the size of sample container are the same, a sample with a higher molar absorptivity will have a higher ABSORBANCE than a sample with the lower E (molar absorptivity). 3. The higher the concentration of a sample is the higher the transmittance will be. 4. Spectrophotometry is the study of how light interacts with matter 5. During an absorbance reading, light must pass through the opaque side of the cuvette. 6. Distilled water is an acceptable blank solution for any sample
A size standard: Group of answer choices A. Is run along with every sample on a run. B. Is used to determine the size of unknown fragments in a sample. C. Has an expected peak pattern that is recognized by the analysis software. D. All of the above