Que. If two devices A and B contesting for the BUS have ID’s 5 and 6 respectively, which device gets the BUS based on the Distributed arbitration. i) Device A ii) Device B iii) Insufficient information iv) None of the mentioned

Q: QUESTION 39 Which one of the fllowing is =not= true of a bus buffer? It can be used to isolate the…

A: Option 2 is correct option Because, the term fan out refers to no of gate input for a particular…

Q: What addresses in the output portion of the datapath are mapped to the DSR and DDR respectively?…

A: Solution is:

Q: Beca use the ports are linked to a variety of devices, a technique must be implemented so that the…

A: Introduction: A port connects a computer to other computers or peripheral devices.  A port is a…

Q: Question 4 How do you think the TS and NT flag bits differ from each other? Question 5 Explain…

A: 4. TS Flag bits: Task Switch flag if set, indicates the next instruction using extension will…

Q: __________ is the process whereby devices connected to a bus autonomously determine which of the…

A: Distributed arbitration using self selection isthe process whereby device connected to a bus…

Q: Why is it that a bus is frequently a communication bottleneck?

A: To be determine: Why is it that a bus is frequently a communication bottleneck?

Q: 4. The system is notified of a read or write operation by a. Appending an extra bit of the address…

A: Please find the answer to the above question below:

Q: How many conductors will be necessary if an address bus must be able to address eight devices? What…

A: With the help of conductors, the address bus must be able to address the devices. The address bus…

Q: Bus arbitration schemes (as with everything) are all about tradeoffs. Which statement below is NOT…

A: Below i have answered:

Q: One of the disadvantages of the Bus topology that you should mention is the difficulty in…

A: Please find the detailed explanation in the following steps.

Q: When we want to place the content of PC onto the bus, what will be the value of selection inputs…

A: Given question has asked to find the value of selection input s2 s1 s0 in two scenario: When we…

Q: Which of the performance rules in the sidebar “General Rules for Performance” are addressed by the…

A: In this question , firstly we can tell about host bus adapter. After that we can define circuit…

Q: er for controller for wide bus? Thanks Mohammad

A: SCSI refers to Small Computer System Interface , is a set of standards for physically connecting and…

Q: The challenges associated with reconnecting and isolating faults are two of the disadvantages of the…

A: The answer is

Q: ) Describe isolated and memory mapped I/O.

A: NOTE: Based on our rules, when multiple questions are posted, we should answer only the first…

Q: The bus topology has high utilization under heavy traffic.

A: Bus topology: Bus topology uses a single cable that connects all included nodes. The main cable will…

Q: In a Mil-Std 1553 Bus, one of the Remote Terminals (Terminal Address 4) would like to send the…

A: The answer is

Q: السؤال 11 The bus signals that the bus has been granted to the DMA controller: الاجابات DMA   DMA…

A: السؤال 11 The bus signals that the bus has been granted to the DMA controller: الاجابات DMA…

Q: Maximum propagation delay on this bus is 4 ns. The bus master takes 1.5 ns to place an address on…

A: Question :-

Q: During an I/O write: [select all that are true] The address is sent in to the MPU…

A: According to the information given:- We have to find the correct option that satisfy the given…

Q: TRUE or FALSE? A bus is a collection of wires that carry information as electrical signals between…

A: Actually, bus is used to transfer the information from source to destination.

Q: Question 4 Cyrtem" in which bus Lycles 2akes b0o ns. Transfer of but control in either dire ction i…

A: Answer

Q: The FSM of the arbiter defined in section 8.8, and reproduced in Figure 2, can cause the third…

A: Answer:

Q: Choose... 1.default mode The real mode of operation is 2.is a control bus the protected mode of…

A: The solution to the given problem is below.

Q: hot-swappable b). honesty c). hang d). bus mastering e). CrossFire

A: a) Hot-swappable describes a component device that can be removed or installed without powering down…

Q: 12. A segment is a PDU of layer ロ4 02 03 ロ7

A: The correct answer is 4 Explanation below

Q: When multiple sources send data to the bus it results in ___.   a. data collision   b. bus…

A: Let us see the answer below.

Q: What are the four types of bus arbitration?

A: Bus arbitration Bus arbitration is the process of determining for competing bus master allowing…

Q: What are the disadvantages of the bus topology?

A: GIVEN: What are the disadvantages of the bus topology?

Q: Give the following about BUS TOPOLOGY: Advantage Disadvantage When to use?

A: According to the question the bus topology only used for in the small network area and the its cheap…

Q: Two disadvantages of the Bus topology that you should describe are difficulties in reconnection and…

A: Introduction: Multi-point electrical connections in a bus architecture can be accomplished via…

Q: Register Bus AC BUS 4 PC BUS 2 IR BUS  5 MAR BUS  7 MBR BUS 7 which the above register…

A: AC register connected with BUS 4 PC register connected with BUS 2 IR register connected with BUS 5…

Q: What addresses in the output portion of the datapath are mapped to the DSR and DDR respectively?…

A: Solution:

Q: What are the advantages of the bus topology?

A: The advantages of bus topology are:

Q: ked with the bus top

A: Bus topology also referred to as a line topology, a transport topology is an organization…

Q: QUESTION 12 Which of the following instructions will disable all of the interrupts? O a. SEI Ob.…

A: The question is to choose the correct option for the given questions.

Q: distributed, synchronous arbitration scheme.

A: In distributed synchronous arbitration scheme, all devices got access the TR(transfer request) line…

Q: If two devices A and B contesting for the BUS have ID’s 5 and 6 respectively, which device gets the…

A: The Answer :

Q: What are the four different forms of bus arbitration?

A: Bus Arbitration Arbitration is required in instances when there are several master devices. While…

Q: Why is a bus often a communications bottleneck?

A: Bus: Bus is a collection of wires which is connected to one or more subsystems within a same system.…

Q: For the following figure, answer the questions below: 1. What is the size of address bus? 2. What is…

A: Here we have given the answers for the mentioned questions. You can find the solution in step 2.

Q: Which one of the following O a. Dedicated bus means system bus O b. Dedicated bus means that one bus…

A: EXPLANATION: There are 2 types of bus, Dedicated bus Multiplexed bus.   A dedicated bus means it…

Q: a) For the direct-mapped configuration, determine the number of index bits and tag bits in the…

A: А.   Memоry  =  32  bit Blосk  size  =  32Byte  ->  Blосk  Оffset  =  lоg  32  =  3  bit.   Tоtаl…

Q: What is the method of arbitration of the PCI bus? Modify the following diagram arbitration, when…

A: In order to attenuate the latency of access, PCI's arbitration mechanism relies on access instead of…

Q: create a working serial communication solution containing optocouplers between an Arduino and a…

A: #include <FastLED.h>   ///////////////////////////// //VARS //the time we give the sensor to…

Q: As a general rule, is it better to switch auxiliary buses in parallel or drop-and-pick-up? why?

A: Introduction: Drop and pick-up: It is a strategy in which a single bus is used to pick and drop the…

Types of input and output devices

Input-output devices help in the functioning of a computer. An input device lets the user enter data into a computer. Common types of input devices are mouse, keyboard, joystick, and microphone.