QI A power station is to supply two loads. The daily load curve of the station is as shown in figure below. If the load factor of the two loads are 0.416 and 0.458 respectively, and the diversity factor of the power station is 1.142, find: 1- The load factor of power station. 2- The energy consumed per day and the maximum demand (connected load) of each load.

QI A power station is to supply two loads. The daily load curve of the station is as shown in figure below. If the load factor of the two loads are 0.416 and 0.458 respectively, and the diversity factor of the power station is 1.142, find: 1- The load factor of power station. 2- The energy consumed per day and the maximum demand (connected load) of each load.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
A power station is to supply two loads. The daily load curve of the station is as shown in figure below. If the load factor of the two loads are 0.416 and 0.458 respectively, and the diversity factor of the power station is 1.142, find:1- The load factor of power station.2- The energy consumed per day and the maximum demand(connected load) of each load.
The power factor of the circuit shown in figure 2 is. a. 0.866 lagging b. 0.5 lagging c. 0.707 lagging d. 1
Q1 A power station is to supply two loads. The daily load curve of the station is as shown in figure below. If the load factor of the two loads are 0.416 and 0.458 respectively, and the diversity factor of the power station is 1.142, find: 1- The load factor of power station. 2- The energy consumed per day and the maximum demand (connected load) of each load. KW 1400 1200 1000 800 600 400 200 6 12 14 20 24 hours
A base load station having a capacity of 18 MW and a standby station having a capacity of 22 MW share a common load. Find the annual load factors and plant capacity factors of two power stations from the following data :Annual standby station output = 740OMWH Annual base load station output = 100000 M kWh Peak load on standby station = 12 MW Hours of use by standby station/year = 2200 hours
step down chopper has Vs = 230 V and R = 10 0. For a duty cycle of 0.4, the power taken by the chopper is 2097 Watts. Find the chopper efficiency. Take the voltage drop across the chopper switch as 2 V. a) 98 % b) 89.96 % c) 99.14 % d) 96.54 %
Q2/ Find Yous for the power system all reactance on a common base. Bus 3 j0.25 j0.10 j0.25 Bus 2 j0.125 Bus 1 j0.40 j0.20 j0.10 Bus 4
A power station is to supply four regions of loads whose peak values are 10,000 kW, 5000 kW, 8000 kW and 7000 kW. The diversity factor of the load at the station is 1.5 and the average annual load factor is 60%. Calculate the maximum demand on the station and annual energy supplied from the station.
60. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following series resistances and reactances: R1=10 ohm, R2= 15, XL1=20 ohms, XL2=25 ohms, XC= 40 ohms. Find the real power. a. 65.3899 b. 392.4372 c. 397.848 d. 588.6559
A generating station has a maximum capacity of 100 kW and costs $300,000. The annual fixed charges are 12% of the cost of the generating station consisting of 5% interest, 5% depreciation and 2% taxes. Find the fixed charges per kWh generated if load factor is (a) 100% and (b) 25%.
a) Explain briefly how electricity can be sold to a grid by use solar energy. b) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20 MW for farm as a whole, in year 2020, the farm produced a total energy 43416MWH, find a capacity factor.
8. Three generators are rated as follows: Gl: 100MVA, 33kv,Xg1 = 0.1pu. G2: 150MVA,32kv.xg1 0.08pu.G3:110MVA,30kv.xg1 = 0.12pu.Determine the reactance of the generator corresponding to base values of 200MVA and 35kv.