Id last two digit 20 Hydro power plant costs Tk. 45x10º with maximum capacity of (x+6) MW. If the annualfixed charge is 9% and the running charge is Tk. 9 per unit generation, plot a curve ofCost/unit Vs. load factor. Assume load factors are 30%, 40% and 50%.

Answered: Image /qna-images/answer/0467206d-8bb1-4ec4-9aac-b187bb58d58c.jpg

Answered: Hydro power plant costs Tk. 45×101º…

Engineering

Electrical Engineering

Hydro power plant costs Tk. 45×101º with maximum capacity of (x+6) MW.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: 20,000 Ω 5000 Ω +60 V - 2 V 1V -60 V Ως 9Ω 12Ω νo

Q: i, 12 1Ω 1F V 1H

Q: R = 10 ohm |= ? 5V

A: According to the question we have to find the value of the current I.

Q: 10 ka 10V 50mH

Q: 42 10 V 3Ω b ww

A: Here 6 ohm and 3 ohm are in parallel. I have solved it using kcl.

Q: 12/0* v 10 10 ww 10 2/0 A A

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: In a Pumped Hydro storage system, if 1000 kg of water is raised 100 m it will store 0.2725 kWh of…

A: Hydropower generation is a very safe and environment-friendly power generation method. it converts…

Q: +18 V 2 ka B = 200

Q: ac = 250 mnH if

A: To find the equivalent inductance across the terminal a-b

Q: A consumer is charged at a block rate tariff of 20 baisa for the first 100 units and 30 baisa for…

A: In this question , we will find total electricity bill..

Q: Given :- 385 Gea 4s 25 12

A: Let's solve for the equivalent Geq by using the network reduction techniques. Care must be taken so…

Q: 1 kn 100 nF

Q: 30 10 80 Rin 50 Figure 3

A: Here 2 ohm,8ohm and 5ohm form star.hence for the simplicity we convert it into delta and solve it.

Q: 15 kN a 10 mA { 10 kN (1 ) 3 mA 35 kN 30 V

Q: 10 2 ww + V 10 Ω 2V 40 V (+

A: Given circuit shown

Q: 50 ww a 50 V 202 ww 606

A: Norton's current is short circuit current at load terminal. Norton's resistance is equivalent…

Q: rate tariff of 15 T00 Uhits and 30 baisa for the remaining units, then the monthly electricity bill…

Q: Ro 2.2 kn R 10 MO 680

A: As we have given: RD=2.2 kΩRS=680 ΩRG=10 MΩVDD=9 V

Q: 82 ww 6 V ЗА

A: The given circuit is

Q: 56 ohms + 10% 22,000 ohms + 5% 470 ohms t 5% 68 ohms 4 obms + 10 %

Q: 1 (t) 3202 vos 50 cos (40ot - 98) Volts 31.25 Ho0mH HF

A: Given Vg =50cos400t-90° VR1 =320 ΏR2 =80 ΏC =31.25 μF L =400 mHω =400 rad/S

Q: Calculate the current " I " to give air-gap flux of 20 mwb

Q: 2. Different rate per unit of energy consumed for different type of consumers is called as

A: Need to find what type tariff is used for different types of consumer are charged with different…

Q: 5Ω t = 0 10 V 2 mH 10 ww

Q: L1 750 mH 0/V1 R1 680 ko Vout 1kHz

A: In electrical networks we shall get different kinds of dynamic circuits which contains dynamic…

Q: 4 k 36 kN 6 kΩ + 2 mA 32 kN 5 V( +

Q: why is it 10 v instead if 20v?

A: In the given circuit, the input voltage magnitude is given as 20 V (peak-to-peak).

Q: 10kn 12 V 6 mA 4kn 18 V

Q: A battery is charged at 15 A for 10 hours. If the charging voltage is 120 V, what is the charging…

A: Choose the correct option If battery charge by current I= 15A for time t= 10Hours Voltage across the…

Q: 10 kn 33 kn 2 kN + U, 4 kN 18 mA, 15 kn 12 kl

Q: the skin depth or penetration depth ō for couper plate at f=10kHz is 2 micro meter 6.66 micro meter…

Q: +10 V 10 k2

A: The output voltage v0 can be calculated as by applying KCL at node 3. The voltages v1, v2 denotes…

Q: 60 Ω 12Ω 6Ω 2.5 Ω ww 80 2 15Ω 20 Ω Rea

A: To solve above problem one should know the equivalent resistance calculation of series and parallel…

Q: a 200 2 12002 400 2 240 Ohms b.

A: Given circuit

Q: 24S Gea 手5 325 122

A: Here i have converted delta to star and found the answer.

Q: Given: 10 ohm each

A: To solve this question we redraw the circuit as shown below.

Q: Determine the unit of energy if the power is measure in mega watts and the time in minutes. O a.…

A: Option d is correct. The explanation is provided below.

Q: What is the power in Watts of 25dBm? 316.2W 316.2mW 17.78W 12 07 W

A: Given: Power in dBm PdBm=25 dBm

Q: Commercial unit of electricity is kWh. When we convert kWh to joules the equivalent value will be O…

A: Given, Commercial unit of electricity is kWh. To convert kWh to Joules.

Q: 20. It is defined as net work output per heat absorbed.

A: we are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The specific fuel consumption by a thermal power station is 0.75kg/Kwh. The units generated for a…

A: In this question we need to find a fuel consumption per day by station

Q: 10 kΩ 6 kN y Ο 4 kΩ 12 kN 4 ΚΩ

A: The detail solutions in image

Q: 5 kN a 10 kN 75 V 10 kN 40 nF 40 k 100 V

A: During transient condition it is seen that, Capacitor does not allow sudden change of voltage,…

Q: The power output of a typical large power plant is 1000 megawatts . Express this result in Watts

Q: 10 k2 120 kN + 20 V

A: Given circuit is shown below Assume base to emitter voltage drop VBE=0.7v and Given β=80 Apply KVL…

Q: 24/ Determine the unit of energy if the power is measure in mega watts and the time in minutes. a.…

Q: 1 mF 100 2 8 H ell Zin 1 mF 200 2

Q: 0.5 H ell www + 10 cos (10t + 75°) 10Ω F

A: Impedance of Resistive Element: ZR=R Impedance of Inductive Element: ZL=jωL Impedance of…

Q: 4+1j -O A I, = 20/10° Awgk/rms" 3+4j OB

Question

Id last two digit 20

Hydro power plant costs Tk. 45x10º with maximum capacity of (x+6) MW. If the annual
fixed charge is 9% and the running charge is Tk. 9 per unit generation, plot a curve of
Cost/unit Vs. load factor. Assume load factors are 30%, 40% and 50%.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the purpose of power factor correction to a given load? O To reduce the amount of voltage to the load. O To reduce the amount of dependence on automated machinery. O To reduce the amount of current to the load. O To reduce the amount of resistance of the load.
What are the elements which contribute to the cost of the electricity? And discuss how the “load curves’ and ‘load duration curves’ can helpful in the economics of generation.
A generating station has a maximum capacity of 100 kW and costs $300,000. The annual fixed charges are 12% of the cost of the generating station consisting of 5% interest, 5% depreciation and 2% taxes. Find the fixed charges per kWh generated if load factor is (a) 100% and (b) 25%.
Driving-point admittance The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base Voltage is 600 V and Base Power is of O 6000 VA O 8000 VA O2000 VA 4000 VA Jump to ncements MacBook Air DD DII F10 F9 F8 000 F7 F6
Two generators are supplying a load. Both the generators have a no-load frequency of61.5 Hz and the slope sp of 1 MW/HZ. If they are supplying a real load of 2.0 MW at 0.8 pflagging, what would be the system frequency and power sharing between two generators?What measures can be taken to make the frequency 60 HZ. If an additional 1.0 MW load isconnected to the existing one what would the system frequency be.
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
Hoover Dam has a nameplate capacity of 2080 MW[] and an annual generation averaging 4.2 TW·h. (The annual generation has varied between a high of 10.348 TW·h in 1984, and a low of 2.648 TW·h in 1956.) Determine the capacity factor. Ans. 23% (Show the Solutions)
The reactance of a generator is given as 0.25 per-unit based on the generator’s of 18 kV, 500 MVA. Find its per-unit reactance on a base of 20 kV, 100 MVA. a. 0.0505 b. 0.0605 c. 0.0405 d. 0.0606
For a power station the yearly load duration curve is a straight line from 50,000 to 4000 kw. To meet the load three turbo-generators are installed. The capacity of two generators is 16,000 kw each and the 3rd is rated at 7,000 kw. Determine the following a) Load factor. b) Capacity factor. c) Maximum demand.
In a Three-phase alternator, a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f. of 1500 V on open-circuit. Calculate the terminal p.d. when a load of 250 A at 6.6 kV and 0.8 p.f. lagging is switched off. Calculate also the regulation of the alternator at the given load. Subject: Electrical engineering
A generating station is to supply four regions of load whose peak loads are10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Then the installed capacity is (25 to26)MW. O (24 to25)MW. O (23 to24)MW. O
The voltage regulation of an alternator having 0.75 leading p.f. load, no-load induced e.m.f. of 2400V and rated terminal voltage of 3000V is............... percent. *