Q2.The periodic triangular current in shown in Figure 1 has a peak value of 180 mA. Find the average power that this current delivers to a resistor. etc. - Ty2 – T/4 T/4 T)2 3T/4 /T

Q: Give one example of where Lattice Vibrations occur in Superconductivity

A: Lattice Vibration Lattice vibration can explain sound velocity, thermal properties, elastic…

Q: a) Peak voltage, (b) Peak-peak voltage, (c) root mean square voltage, (d) period and frequency, (d)…

A:

Q: V1 4 Vrms R2 + R3 R4 750 Hz 0°

A: Let the equivalent resistance be Req

Q: Problem 15. A source of e.m.f. of 15 V supplies a current of 2A for six minutes. How much energy is…

A: In this question we will find energy provided by source ...

Q: An alternating current of frequency 50 c/s has a maximum value of 100 A. (a) Calculate its value…

A: The solution is given below.

Q: The waveforms show a voltage (v) and a current (i) for an AC circuit. The current signal has a value…

A:

Q: The voltage sensitivities of Barium Titanate and Quartz are respectively 12 × 10-³ Vm/N and 15 ×…

A: Given, For Barium Titanate: Voltage sensitivity = 12×10-3 VmN Permittivity = 12.5×10-9 Fm   For…

Q: For the given waveform, current the voltage by an angle, þ. cot

A: we need to fill the given blanks.

Q: A The value of: A=5 ms C= 15 ms Peak to peak = 10 B D Figure 1 (a) From Figure 1 above, identify the…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: R1 L1 R2 C1 5000 795.77mH 2000 5.53µF V1 R3 300Vrms 60HZ 0° L2 530.52mH

A: Maximum power theorem: This states that in the circuit load resistance is equal to the source…

Q: Direct current (DC): Alternating current is that varies sinusoidally with time It is a current that…

A: alternating current is current which is always varies with time  where as direct current is the…

Q: QUESTION 2 a) Figure 3 shows some parts of a power supply circuit. Assume that the diodes D1- D4 are…

A: The solution is given below

Q: If the forward voltage drop on a diode is 774 mV, what is the current passing through it? Assume I s…

A:

Q: For the given waveform, the current the voltage by an angle V ot (rad) T/2

A: From the given waveform , we can easily found which one leading or lagging.

Q: Alternating voltage and current differ from direct voltage and current because alternating voltage…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Q2 (a) Explain the generation of single phase alternating voltage. Illustrate with a diagram.

A: Introduction: Single phase AC (Alternating current) supply can be generated with single phase AC…

Q: 1. Find the average value of current when the curren that are equidistant are 4A, 5A and 6A.

A: It is given that:

Q: Suppose you are asked to generate the waveforms as shown in figure 1, continuous over time, using…

A:

Q: 1. If maximum value of current is 5√2 A, what will be the value of RMS current?

A: It is given that:

Q: Perform the following:

A:

Q: A constant current of 2.8 A exists in a resistor. The rms value of current is A.

A: Given: In a resistor the constant current is I=2.8 A

Q: Find the RMS current from 30⁰ to 180⁰ at  Im = 10 Amperes

A:

Q: 1) Explain how this circuit works 2) Draw the waveform at the output (Vrl) for a sinusoidal signal…

A: Transformer ratio =5:1 Input voltage = 120 V  ( We assume it as rms value as nothing mentioned about…

Q: The voltage sensitivities of Barium Titanate and Quartz are respectively 12 X 10-3 Vm/N and 50 X…

A: Given- Voltage sensitivities- For Barium Titanate - 12×10-3 Vm/N, For Quartz- 50×10-3 Vm/N,…

Q: The value of α20 for copper is 0.00393, so find the value of α for 0 °C and for 50 °C.

A:

Q: The average (DC) value of a half-wave rectified voltage with a peak value of 200 V is: a. 63.7 V b.…

A:

Q: Tu netuork show in opeating in the thndy doulce. If V, = 2aes2t state wilh sinusoidal ve and V, 2…

A:

Q: Item 8 of 10 Most ac-supplies are in the form of Select the correct response: sine-wave…

A: This is a basic problem of sinusoidal and phasor. The solution is given in the next step

Q: The efficiency of any real wind turbine O a. can be more than 59.3% O b. can be less than 59.3% O c.…

A: According to Betz's law as air flows through a certain area, and as wind speed slows from losing…

Q: Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms…

A:

Q: 4) Listen Regarding a Sine wave of an A.C. voltage (pictured below for reference), changing the…

A: Option c only correct Since charging voltage level per division will only effect the village values…

Q: What is value of RMS current if voltage is 10sin(100t) Volt and load is 10mH inductor.

A: v(t)= 10sin (100t) Volt XL=jωL  XL=j(100)(0.01) Ω XL=j1 Ω

Q: iii) A sine waveform with following specifications. RMS voltage 161.4V Time for ten cycles 0.02s…

A: Given values are =

Q: If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit…

A:

Q: Electrical Engineering What are the implications of intensity in energy generation

A: Given: Energy intensity: Intensity has a deep role in the energy generation. Energy intensity is…

Q: 6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll

A: In this question,   We need to determine the peak voltage Across the load and average power P?  We…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.