Q1. Find the centroid

Q: what is the direction and magnitude of the resultant?

A: Analyze the FBD of the given system.

Q: Determine the resultant of the force system in next fig. Then locate it with respect to point (A).…

A:

Q: The force Ris the resultant of Pand Q. Determine Q and the angle e. P = 3 kN R= 2 kN

A:

Q: Determine the magnitude of the force F given that its moment about the axis BC is 150 Ib ft.

A:

Q: Q/ Use the conditions of equilibrium to solve the following problem and find the magnitude of the…

A: for the given system of forces  To determine  The magnitude of the resultant force and its…

Q: ction measured clockwise from the positive= Fi 45

A: Given Data : F1=30 lbF2=40 lbF3=25 lb

Q: Can you now find the vertical support reaction in support B.  Enter your answer in kN to two…

A:

Q: point A towards O, determine the magnitudes of the resultant force and forces Fg and Fo Set the X =…

A: Given that: Cable AB and AC are fixed to support the 2000 N load which is acting along negative z…

Q: F2–24. Determine the resultant force at A. 1m Fc = 2.45 kN F = 3 kN 3 m 2 m 1 m 5.

A: Given Data: The force FC = 2.45 kN. The force FB = 3 kN. The coordinate of point B is (0,2,1). The…

Q: Determine the internal forces of the members that are marked in red. Note: The answer must be in…

A:

Q: The force R is the resultant of the other three concurrent forces shown. Force F = 200 lb and T =…

A:

Q: The three forces, each of magnitude F, are applied to the crate. Determine F so that the three…

A:

Q: Determine the components for the forces at A and D. The mass of the cylinder is 50 kg. 0.8 m 0.8 m…

A: Given : AD = 1.2 m             AC = 1.6m

Q: 2-32 Determine the magnitudes of the u- and v-compo- nents of the 1000-N force shown in Fig. P2-32.…

A:

Q: Q1): Determine the general solution of the O.D.E: (1-x) y'-y² =0

A:

Q: The cable BC carries a tension of 750 N. Write the force in the cable as a vecto 12m- C 0.7 m 1.6 m.

A: The given problem can be solved by using the formulae  FBC/|FBC| = rBC/|rBC| where FBCis the force…

Q: Situation 5. Determine the forces in cables AC and AB needed to hold the 20-kg ball D in…

A: GivenF=300Nm=20kgd=1m

Q: Determine the value of P acting to the left that is required to pull the wedge out from under the…

A:

Q: 6/9 The tongs are designed to handle hot steel tubes which are being heat-treated in an oil bath.…

A: FBD is drawn with half angle theta = 10 deg

Q: Determine the magnitude of forces FA and FB acting on each chain in order to develop a resultant…

A:

Q: The two 104-mm-diameter spheres constructed of different metals are located in deep space. Determine…

A: Given: The diameter of the spheres is d=104 mm=0.104 m (a) The distance is  d=2.2 m (b) The distance…

Q: The bucket weighs 1,697 lb and its center of gravity is at F, the ADE line is horizontal. Determine…

A:

Q: Q3: Find the magnitude, location and slope of the resultant of the force system shown below.

A:

Q: Determine the magnitude of the reactions at A and C (resultant). 2m 1.8m 3m 12KN/m

A: The equivalent force due to uniformly varying load can be determined as the area of a triangle…

Q: Q3: The vertical force R is the resultant of the three forces acting on the bent bar. C_2 m D 30°…

A:

Q: Determine the height h above the base B at which the resultant of the three forces acts: 300 lb 30"…

A:

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.