Q1:- A) Find the total capacitance CT shown in fig.1 if:i. the switch is open3 µF6 µFii. the switch is closedB) Two branch currents in a network are known toСтbe i (t) = 4.5 sin (600t + 45°) A, i2 (t) = 2 cos (600t+ 25°) A, determine the phase angle between themthen write each of them in phasor representation.3 µF6 µFFig. (1)

Q1:- A) Find the total capacitance Cr shown in fig.1 if: i. the switch is open 3 µF 6 µF ii. the switch is closed B) Two branch currents in a network are known to be i (t) = 4.5 sin (600t + 45°) A, i2 (t) = 2 cos (600t 3 µF Ст 6 µF + 25°) A, determine the phase angle between them then write each of them in phasor representation. Fig. (1)

Q1:- A) Find the total capacitance Cr shown in fig.1 if: i. the switch is open 3 µF 6 µF ii. the switch is closed B) Two branch currents in a network are known to be i (t) = 4.5 sin (600t + 45°) A, i2 (t) = 2 cos (600t 3 µF Ст 6 µF + 25°) A, determine the phase angle between them then write each of them in phasor representation. Fig. (1)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 50-µF and 100-µF capacitors are connected in series and across a 100 sin (wt + 30o) voltage. Write the equation of the current.a. 1.26 sin (wt + 120o) c. 5.65 sin (wt + 120o)b. 1.26 sin (wt + 90o) d. 5.65 sin (wt + 90o)s
A non-inductive resistor is connected in series with a coil across a 230V, 50Hz supply. Thecurrent is 1.8A and the potential differences across the resistor and the coil are 80V and 170Vrespectively. Calculate the inductance and the resistance of the coil, and the phase differencebetween the current and the supply voltage.
Determine ZT for the circuit if inductive reactive is 10220 and resistance is 9850. Answer:
2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b) Determine the voltage v(t) and current i(t) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors V,, VR and Vc. e) Sketch the phasor diagram showing Vs, Vr, Vr, Vc and I.
5) Find the reactance the inductance and impedance of the circuit. Calculate the current of this circuit and the sketch waveform of current and voltage. V1 10 V 60 Hz R1 m 100kQ 12 Vrms 1000 Hz 0° 6) Find the reactance the inductance and impedance of the circuit. Calculate the currents of this circuit R www 502 L L1 106mH eee 10 mH
When 50Hz alternating voltage of 150V is applied across the 10-Ohm resistor, 0.2H indcutor and capacitor pf 50micro farad. Find the expression for the current for each element individually.
Calculate capacitance Cand voltage U over resistance. What is the peak value of resistance's voltage? Voltage source e(t) = ésin(wt + 45°). Resistance R-50, circuit's total reactance X-50, inductance L =50mH, ê -40V and frequency f =50Hz. R L Give the answers to one decimal place. Do not write numbers in the complex number form! Absolute value of voltage source (RMS value): V Total impedance of circuit (absolute value): Capacitance: μF Absolute value of current (RMS value) supplied by voltage source: Phase angle of current: degrees Peak value of resistances voltage: 22 A
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. For the following pairs of voltage and current, indicate their phase relationship (e.g. v leads i by 10°). Analyze whether the element involved in each pair is a resistor, inductor, capacitor or a combination. Also obtain the value of R, L, and C if sufficient data are given.
A resistance an inductance of 31.8mH. The circuit is connected to a 100V 50Hz sinusoidal supply. Calculate the current in the circuit. a. 2.2 A b. 4.2 A c. 6.2 A of 7 ohm is connected in series with d. 8.2 A
Given: L1 = 17 mHL2 = 21 mHL3 = 0.014 HL4 = 11981 mHL5 = 89 uH Calculate the total inductance of the circuit, LT.
Q1. Solve for the equivalent capacitance if C1 = 26 micro Farad and C2 = 69 micro Farad. Note: All capacitance are in microfarad. Q2. Solve for the equivalent inductance at terminals a-b, if L1 = 12 mH and L2 = 43 mH. (Hint: You may add wires and flip the circuit) *Pls show the whole solution of these two questions thank you!
A sinusoidal current of 5 Arms is flowing through a series combination of a resistor and Inductor. The value of R is 45 ohms and that of the inductance is 15 mH and a frequency of 60 Hz. Find the magnitude and the phase angle of the voltage across the combination. (Hint: you can use phasor diagram). Select one: a. [V]=28.89, angle=9.39 b. IV]=25.60, angle367.00 c. [V]=128.01, angle3D10.18 d. IVl=226.77, angle=D7.16