Answered: A resistance an inductance of 31.8mH.…

A resistance an inductance of 31.8mH. The circuit is of 7 ohm is connected in series with connected to a 100V 50Hz sinusoidal supply. Calculate the current in the circuit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: 11.85 A regular household system of a single-phase three- wire circuit allows the operation of both…

A: The household circuit model is shown below,

Q: Question 4.2-2: ' The below circuit at left includes two D flip-flops. Recall that a D flip- flop's…

Q: Simplify the circuit

A: The given circuit needs to be simplified by reducing the resistor network using the delta to star…

Q: A 12470 Vrms, 3-phase 60 Hz supply is applied to a balanced Delta-connected 3-phase load consisting…

A: A 12470 Vrms, 3-phase 60 Hz supply is applied to a balanced Delta-connected 3-phase load consisting…

Q: -1 h) Determine the closed-loop transfer function of the following control system. R(s) + G(s) (($)…

A: For this given control system we need to find the closed- loop Transfer…

Q: Determine all possible signals that can have the following z-transforms. 1 (a) X(z) = (b) X(z) =…

Q: Three loads are operating at 1000 V. Load 1 is an induction motor consuming 80 kW at 0.83 PF…

A: The above question is based on the concept of complex power in AC circuits.If V is the voltage, I is…

Q: Determine Thevenin equivalent voltage of the following circuit + E = 20 V R₁ ≤6N 6Ω R₂- 6Ω 6Ω M R3

A: Circuit diagram is given as,

Q: A signal that has the highest frequency component of 4.2MHz and a peak to peak value of 4 volts is…

A: here we have to find the code word length and bitrate and output signal to quantization noise ratio.

Q: Sketch F-1 {sinc²(f)Fg(f)} where g(t) is shown in Figure 1. LL Figure 1: g(t).

Q: 5 A discrete-time system can be (1) Static or dynamic (2) Linear or nonlinear (3) Time invariant or…

A: (1) Static or dynamic system: A static system has an output that depends only on the current input,…

Q: Consider the signal x(n) = [−1, 2, −3, 2, −1] ↑ with Fourier transform X(w). Compute the following…

Q: 1- Find the z transform of the following sequences: (a) x₁(n) = (0.1)"-3u(n) (b) x2 (n) = (0.1)"…

A: Given discrete sequences are

Q: For the following discrete-time signals, determine the z-transform, ROC and if they are BIBO stable…

Q: Task 3 a) The current, i, through a capacitor depends on time, t, and is given by i=c(dv) where V is…

A: Given:The current through the capacitor is given by,The change in current wrt voltage is given by,Is…

Q: Find the Nyquist rate of the following signal (2000) a 300 samples/beconds Ob 400 samples/seconds c.…

A: In this questionWe need to choose the correct option. We knowNyquist frequency ws = 2wm Where wm…

Q: Show the Qoutput with relation to the input signals. Assume Q starts LOW. S R EN Q S EN- R Q

Q: 2- An electric heater takes 1.48 kW from a voltage source of 220 V. Find the resistance of the…

A: In an electric heater,Power usage, .Source voltage, .

Q: A DC voltage source has a source resistance variable from 5 0 to 25 Q and it is connected to a load…

A: A DC voltage source has,Source resistance, variableLoad resistance,

Q: Problem 5) Find the Fourier Transform for the following signal. 2 0 2

Q: Use Laplace transform to solve the following differential equation. y" + 8y' +16y= 16 sin(4t) y…

Q: Consider the signal x(n) = [1, 2, 3, 2, −1] ↑ with Fourier transform X(w). Compute the following…

Q: A 10-MVA 4.6-kV 60-Hz 6-pole three-phase synchronous generator has armature resistance of 2 ohms and…

A: Note: The solution which is already provided is correct, answer is 1255.11 amperes not 1253.14

Q: For the following circuit, draw 2 cycles of the voltage in RL, if the transformer provides a maximum…

A: We need to draw the output voltage waveform of the given circuit.

Q: The radiation pattern of an antenna in spherical co-ordinates is given by F (0) = cos¹ 0; 0 ≤0 ≤ π/2…

Q: A 100 MVA, 20 kV alternator has X1 = X2 = 0.20 pu and Xo = 0.05 pu. The neutral of the generator is…

A: The above question is based on fault analysis.Please note that all the options are wrong here as…

Q: For the Feedback Control system given in the figure.

A: "Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Using two D flip-flops only, Design asynchronous Counter. The Counter counts in the sequence 1, 6,…

A: Requirement:An asynchronous Counter using D-Flipflops to count the sequence of,1637...Procedure:1.…

Q: For spring mass system, Mass (m)= 5 kg Time period (T)= 1.2 sec Horizontal displacement =10 mm=0.01…

Q: Three charged particles lie on the x axis. q1 = 70 nC at x = -7m, q2 = -100 nC at x = −3m, and q3 =…

Q: Use Laplace transform to solve the initial value problem of the ff DEs. 1. y"+y = 1; y(0) = 6, y'(0)…

A: Laplace transforms for differentiation in the time domain is given by,

Q: Figure 1 shows a potentiometer used to measure the displacement and velocity of an elevator. The…

Q: How many address lines are required for 4 kB memory addressing Your answer

A: The given memory is 4kB.

Q: 5.In three-phase transformers, the high voltage star connection is preferred. This is so because in…

A: It is given that:In three-phase transformers, the high voltage star connection is preferred.

Q: For the following circuit, find the location of the operating point. In what region of bias is the…

A: Since beta (B) is not given, consider B as infinite.Therefore IB= 0. Hence IE= IC.

Q: Design a 3-bit ripple up counter using positive edge trigger J-K flip-flops.

Q: X nine: inductor. by the capacitor. =&A 1 mH 2 mil

Q: 2- An FIR filter is described by the difference equation y(n) = x(n) + x(n-10) i) Compute magnitude…

A: Given dataThe difference equation is, ;We have to determine its magnitude and phase response.The…

Q: Determine all possible signals that can have the following z-transforms. 1 1- 1.52-¹ +0.5%-² (a)…

Q: For battery operated high voltage insect killer (i.e. bug zapper) used at home: (a) Summarize types…

A: A battery-operated high-voltage insect killer, also known as a bug zapper, is a portable device used…

Q: 1. A coil is wound uniformly with 300 turns over a steel ring of relative permeability 900, having a…

A: Number of turns in coil N = 300.Relative permeability of ring Cross sectional area of ring Mean…

Q: Consider the signal x(n) = [−1, 2, −3, 2, −1] ↑ with Fourier transform X(w). Compute the following…

Q: 5 4 O O O 3 Imaginary Axis (seconds ¹) N 2 O -3 -4 -5 -10 40 12 -8 32 Root Locus The root locus plot…

A: closed loop poles are located at proportional controller - K

Q: I want current equations in 2×2 matrix. I don't want a solution just send me the equations ASAP!!

Q: The output of a linear system is c(t): = tcos2t when the input is r(t) = sin2t. Find the transfer…

A: Given:To find:The transfer function of the system.

Q: Use superposition to find the currentio. Additionally, determine the power consumed by the 12 Ohm…

A: Given dataAn electrical circuit contains two independent current sources of and .The independent…

Q: Q.1 (i) Draw the structure of NPN BJT transistor with the biasing junction voltage in forward active…

A: Need to NPN BJT transistor biased in the forward active region and brief about the electron flow…

Q: 4. In a series RL circuit current and voltage are expressed as i(t)=5245° and v(t)= 15 2 30°…

A: The voltage, The current,

Q: 2. If the rotor frequency of a 6-pole, 50Hz, three phase induction motor is 3Hz, determine (a) the…

A: Number of poles P = 6.Frequency f = 50 Hz.Rotor frequency

Q: Given a sinusoidal waveform: v, (t) = 1000 cos(500t -90°). what is the phase angle? 90 degree -90…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A resistance
an inductance of 31.8mH. The circuit is
connected to a 100V 50Hz sinusoidal supply.
Calculate the current in the circuit.
a. 2.2 A
b. 4.2 A
c. 6.2 A
of 7 ohm is connected in series with
d. 8.2 A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data:

VIEW

Step 2: Determining current in the circuit:

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
The source in the circuit shown is a sinusoidal source. The supply voltages across various elements are marked in the figure. The input voltage is: 3V- ww -14 V-10V moon It
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source.
Problem Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage source.
An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
The below figure shows the waveform of the voltage and current in a purely inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor Lags by 90° Is in phase with the voltage Leads by 90° Lags and then leads by 160°
A 25ohm resistor is connected in series with a %0 mH inductor. This circuit is connected to a 120V, 50Hz supply. Solve for a. Inductive reactance b. impedance c. S d. P e. Q
In CRO, an alternating current completes 2 cycle in 20 mS. Then its frequency is given by, ...................