Q. No.3 For the circuit shown in figure below, calculate the following: (a) Total resistance across the source (b) Total current from the source (c) Current through the resistor 1 ka (d) Voltage from A to point B. 910n 5600 5600 5600

Q: A 1-m length of tungsten wire draws 5 A when connected across a battery. The wire is then cut into…

A: The tungsten wire will have resistance, the above circuit can be thought of as if a battery is…

Q: For the Cicuit shown 'in Figure Vcc sgV j Bc = 1-8 K^ ,=100 Zo=? Bc Ai = ?

A: Zo = 1.66kΩ  Zi = 733Ω  Re = 7.47Ω  Ai = 19.3

Q: • In the source room you connect a battery of 20V to terminals A and B, A being the point of higher…

A: Here, we have given two rooms, one of them is the source room and the other one is the sink room.…

Q: 5/Which of the following circuit element receives energy? a. Active Element b. Passive Element c.…

A: The explanation is as follows.

Q: A 12-volt battery is connected to a series circuit in which the inductance is 1-henry and the…

A:

Q: snown below, current I. And solve for the potential difference (a)Vaf (b) Vie (c) Vah (d) Vnf a b…

A: KVL (Kirchhoff's Voltage Law) states that the algebraic sum of all voltage in a closed loop is zero.…

Q: 4 k0 For the circuit of shown in Figure, find the following quantities: 1 The circuit current, L b.…

A:

Q: When you connect a voltmeter to read a dc voltage   a. polarity is not important b. connect the…

A: In this question,  We need to choose the correct options When you connect a voltmeter to read a dc…

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: WHEN CURRENT FLOWS THROUGH A RESISTOR, THE CURRENT WILL FLOW FROM NEGATIVE TO POSITIVE TERMINALS…

A: FALSE.  When a current flows through a resistor, voltage will drop across it. That means voltage…

Q: In the figure below, the voltage reading of the multimeter (Pr1) will be -5 V if V, 10 V and V, 5 V.…

A:

Q: Part II: The potential difference across different elements of a circuit resistance in series 1.…

A: Part 1 and 3 are experimental based hence we can not solved. We are solving for part 2   i) relation…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,677 ohms R2 =…

A: Given the following resistances and inductors are in series with a voltage source, R1=1677 ΩR2=1966…

Q: you have a moving iron ammeter to measuring the current signal shown in figure bellow, the reading…

A:

Q: Find Vout 5V 10 ohms ww 100 ohms ww Vout

A: In this case, the output voltage of the following circuit is to be determined:

Q: For the circuit shown in figure below, find the unknown currents. 50 A 12 100 A 20A 10A 20 A

A:

Q: Find Vout 10 ohms SVMM 100 ohms + • Vout

A:

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Given     Rating of lamp ,P = 50W Voltage rating of lamp ,VL= 12V Available Voltage, V= 24 V

Q: What is the greatest voltage that can be applied across a -W, 2.7-MN resistor without causing it to…

A:

Q: Three resistors of 5, 10, and 15 ohms respectively are connected in series with a 24V source…

A: In this question we will find current through 5 ohm..

Q: 2 What is the current passing through resistor (R=180) in the circuit?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find Vout

A: In this case, the output voltage of the following circuit is to be determined:

Q: A circuit component carries a current of 2.4 amperes and has a voltage drop of 10 volts across it.…

A: Given that,             current I= 2.4A             voltage drop Vd=10V             resistance R=?…

Q: what is value of current (I).

A: Given circuit is -

Q: Which among the relationship given below is correct? a. AC resistance = DC resistance/1.6 O b. DC…

A: In this question  Choose the correct option Which among the relationship given below is correct?

Q: Rea Each resistor is 100 2 (a)

A: Here there are combinations of resistors. We have to use the basic methods of simplification of…

Q: Calculate the peak voltage across R2 in the diagram R1 = 1 kohm, R2 = 680 ohms, supply voltage is…

A: A sinusoidal signal can be mathematically represented as, x(t)=A sin(2πft+ϕ). Where A is the peak…

Q: 15 Determine the voltage across resistor R2. (assume Zener voltage is 3 volts) * R2 1K R1 10V D2 1K

A: