provide process flow diagram of scrubber to remove NOx component 2.In addition to number 1, provide a process flow diagram (with addition of another scrubber) to reduce emission of NOx component

Q: Derive the Kremser equation for a stripper with three equilibrium stages

A: Kremser equation for stripping section is to be derived.

Q: How does heat transfer work in the chemical industry? Explain each step of the heat transfer process…

A: Heat transfer offers with temperature gradients and non-equilibrium phenomena. It is critical that…

Q: What is the material and energy balance of liquid liquid extraction process

A: Liquid-liquid extraction: Liquid-liquid extraction is a separation operation in which the solute…

Q: filtration of 7. Distinguish the difference between filtration rate and velocity. 8. List the…

A: Q7) Filtration rate Q is the volume of filtrate V passing through a point at time t. Its SI Units…

Q: How microwave reactor wattage, temperature, and solvents in a reaction affect the reaction?

A:

Q: DISTILLATION PROCESS IN INDUSTRY. EXPLAIN IN DETAIL: 1-THE FLOW DIAGRAM. 2-THE BASIC SYMBOLS USED.…

A:

Q: Flash distillation is normally carried out in which mode?   a Batch   b Continuous

A: This question is based on distillation. We will analyse each option and find out the correct option.

Q: What are two main problem: associated with the use of Oxygen electrode as a transducer in an…

A: The oxygen electrode is an Ag-Pt electrochemical cell in which the electrode has non-conductive…

Q: Determine whether an example is spontaneous process (SP) or a non-spontaneous process (NSP). 6. ball…

A: Given data 6.ball rolling uphill 7.removing stain from a cloth 8.ripening of fruits 9.flow of heat…

Q: What is the capture efficiency for thermal oxidizer?

A: The thermal oxidizer is equipment that is used in chemical manufacturing industries in order to…

Q: What is the name of the device shown in the figure? Feed Packed Drying fuel bed Pyrolysis Air Air…

A: Updraft gasifier An updraft gasifier is also known as a counter-current gasifier where the air…

Q: Why is distillation boundary important?

A: The reason for the importance of distillation boundary is to be mentioned.

Q: In the laboratory experiment "Plate and Frame Filter Press" 1. Discuss its significance, and…

A: Filtration is the process of separation in which solids from the fluid sepaarted by passing through…

Q: Write a short note on the catalyst in selective catalytic reduction (SCR) technique?

A: The note on the catalyst in the selective catalytic reduction technique is to be mentioned.

Q: Draw the diagram of an reboiler ONLY of Amine Sweetening process in a Central Processing Plant?

A:

Q: A water treatment plant requires three processes for TSS removal: coagulation-flocculation,…

A: Total Suspended Solids (TSS) can be removed by water treatment methods.

Q: Analyze the following images. Identify the type(s) of corrosion. Clearly state your assumptions.…

A: By seeing this image, we can infer that this is an image of a switchboard and by the use of screws…

Q: Write brief comments, with equations where appropriate, on the following   i. Constant Pressure…

A: The following basic concepts are to explained with relevant equations.   i. Constant Pressure…

Q: Given the table below and your judgement for extreme operational conditions, select polymers for the…

A: Given Data Different Material With their Glass Transition Temperature and Melting Point.  To find…

Q: identify a specific process industry of heat exchanger evaluate the use of heat exchanger in the…

A: A process industry is to be mentioned where heat exchanger is used along with the applications of…

Q: Explain the working of regenerative thermal oxidizer (RTO).

A: An industrial system known as the Regenerative thermal oxidizer (RTO) is incorporated in an…

Q: Discuss the classification of heat exchangers.

A: Heat exchangers are those equipment's which is used to transfer heat from a hot fluid to a cold…

Q: 6. With the aid of diagrams, explain what occurs during recovery, recrystallization and grain…

A: Note: Here only 1st question is answered as specific one is not mentioned 6.In the given question…

Q: What is specific objective for Waste Vegetable Treatment to produce electricity

A: The overall objective for the assessment carried out for waste management is described below: a) To…

Q: with neat diagram.

A:

Q: Factor affecting leaching process: - Particle size • Solvent • Temperature · Agitation - Surface…

A: Factors affecting leaching process: a. Particle size The particle size is important in deciding the…

Q: Employing the Kammerlingh Onnes equation of state, find the compressibility factors of CO at -500C…

A: Given that  CO substance  T =-50 C  We have to find Z at different pressure

Q: Explain the Fouling phenomenon. What is the effect of fouling on heat transfer rate?

A: The concept of fouling arises in heat exchangers (HE). The common heat exchangers where fouling is…

Q: Give examples of separation operations used for the steps in a bioprocess.

A: The examples of separation operations used in the steps of a bio process is to be mentioned.

Q: Describe how the gas absorption tower functions

A: We are asked to describe how the gas absorption tower works.

Q: Discuss the Water Sachet Failure due to Change in Supplier and one thermal analysis technique for…

A: Introduction Potable sachet water (drinking water)  quality is solemnly dependent on the quality of…

Q: . Calculate the elastic modulus and thermal conductivity perpendicular to continuous reinforcing…

A:

Q: Question 3: In the following table, you are requested to add the name of the technique that will…

A: There are several deposition techniques that can be used to deposit materials , and the best…

Q: two varieties of dryers used in the chemical Industry

A: Drying is the process by which the excess amount of moisture content present can be removed. The…

Q: 14. A smaller absorption factor means an increased driving force for absorption. [……..] 15.…

A:

Q: Draw the diagram of a wet contact tower or packed tower ONLY of Glycol Dehydration process in a…

A: The glycol dehydrator is a complete machinery where the operation takes place in multiple steps. The…

Q: n SPME for HPLC, analytes are desorbed from the fiber into solvent that is injected into the HPLC…

A: SPME also known as Solid Phase Micro Extraction is an equilibrium sampling method and can be used…