Convert the continuous signal described by y(t) = 10 sin 2πt V into a discrete set of eight numbersusing a time increment of 0.125 s.KNOWN The signal has the form y(t) = C₁ sin2f₁twheref₁=w₁/2π = 1 HzC(f₁ = 1 Hz) = 10 V$(f₁) = 0St = 0.125 sN = 81010.00.20.40.60.81.01. FIND {y(r8t)}2. WHAT KIND OF CIRCUITS SHOULD BE USED TO CONVERT THE ANOLOG SINGNALINTO DIGITAL SIGNAL?Problemy (t) [V]5-10

We need to convert the signal described by Volts, into a discrete set of numbers using a time…

Problem Convert the continuous signal described by y(t) = 10 sin 2πt V into a discrete set of eight numbers using a time increment of 0.125 s. KNOWN The signal has the form y(t) = C₁ sin2+f₁t where 1. FIND {y(r8t)} y (t) [V] 10 5 O 5 -10 0.0 0.2 f₁=w₁/2π = 1 Hz C(f₁ = 1 Hz) = 10 V $(f₁) = 0 St = 0.125 s N = 8 0.4 0.6 0.8 1.0 2. WHAT KIND OF CIRCUITS SHOULD BE USED TO CONVERT THE ANOLOG SINGNAL INTO DIGITAL SIGNAL?

Problem Convert the continuous signal described by y(t) = 10 sin 2πt V into a discrete set of eight numbers using a time increment of 0.125 s. KNOWN The signal has the form y(t) = C₁ sin2+f₁t where 1. FIND {y(r8t)} y (t) [V] 10 5 O 5 -10 0.0 0.2 f₁=w₁/2π = 1 Hz C(f₁ = 1 Hz) = 10 V $(f₁) = 0 St = 0.125 s N = 8 0.4 0.6 0.8 1.0 2. WHAT KIND OF CIRCUITS SHOULD BE USED TO CONVERT THE ANOLOG SINGNAL INTO DIGITAL SIGNAL?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

C1 L1 R1 V1 Vout V1 contains the fundamental and its harmonics (fo, 2fo, 3fo, ...). The amplitude of the harmonics is inversely proportional to the harmonic number. V(fo) = 10 mV V(2fo) = 10mv/2 = 5 mV V(3fo) = 10mv/3 = 3.33 mV V(4fo) = 10mv/4 = 2.55 mV a) What is the minimum value of Q for the circuit that will attenuate the third harmonic (3fo) in Vout to be less than 1% of the fundamental? b) What is the amplitude of the fifth harmonic (5fo) as a percentage of the fundamental?
-Consider the following DT sequence, Is this signal as Power Signal or Energy signal? Determine it. * 0Snくs X [n ]= lo-n 55.n510 • ther wise Power Signal, P=85 Energy Signal, E=85 O Neither energy nor Power O Both, P=30 E=55 -Is the following signal is X(4) - Sin 3t + Sin 大t Periodic Aperiodic
Identify the nature of the signals Jon YLL". 700 An x 100 À Discrete time & discrete amplitude Continuous time & Continuous amplitude Continuous amplitude & discrete time Continuous time & discrete amplitude
1. Obtain the signals given below from the signal generator and view these signals on the oscilloscope screen and draw them on the screen given. a) v(t) = 5*sin(314*t) b) v(t) = 3*sin(37699*t) CH1 CH1 M =.... ..... ... ..... .. ..... ...
Q6. Figure Q6 shows a modulated waveform v(t) in microvolts as a function of time t in nanoseconds. 25 50 75 100 125 150 175 200 225 250 50 40 40 30 30 20 20 10 10 -10 -10 -20 -20 -30 -30 -40 -40 -50 -50 250 25 50 75 100 125 150 175 200 225 time/ns Figure Q6: Modulated waveform (a) Describe the modulation scheme. (b) What are the values of the carrier frequency and the modulation frequency? (c) What is the value of the modulation index? (d) What is the transmission efficiency (ratio of modulated to total power) in this example? (e) Sketch the spectrum of this modulated waveform indicating the relative magnitudes of the various spectral components. (f) The modulating wave in this example is substituted with a square wave of 50% duty cycle and of fundamental frequency 1.0 MHz. Sketch the absolute value of the spec- trum of the modulated waveform indicating the frequencies and relative magnitudes of the sideband components. (g) Demodulation of this type of signal is usually accomplished…
Problem 5 The voltage signals below have identical peak values. Their rms values are also the same. If the first waveform is a sinusoid, what is the pulse duration Tpulse of the second waveform? Provide your answer in terms of T, the period. V ← Tpulse time 5- K time
Show the Analog Waveform Signal of the problem below. Please include the formula you will be using to get the waveform, also include what application you will be using to get the waveform. If you will use sine or cosine, please include the whole formula so I could just substitute it from the problem below. Problem: An oscilloscope's output is an analog signal that ranges only from 12.5mV to 50mV, while its highest frequency is 50kHz.
SS Precision 3450 DELL a8ed Task #3: Remember these identities: TC = COS sin A = cos (v-s00 D -v) Convert a sine signal into a cosine signal. Let S3(t) = 5 sin(2n100t) Write s3 (t) signal in cosine form: Convert a cosine signal into a sine signal. Let S4(t) = 10 cos(2n50t) Write s,(t) signal in sine form: 直 0 F1 F2 F4 F5
A certain voltage function contains a constant term, a fundamental and third harmonic. The maximum value of the fundamental is 85 % of the constant term and the maximum value of the third harmonic is 55 % of the constant term. If the effective value of this function is 180.3V, find the magnitude of the two harmonics.
Show that the total area under the curve of sinc function is equal to 1. That means ( sinc (t) dt = 1 00
covert to discrete sinusoidal signal x_a(t) = 3 sin (100 pi t)
A nonperiodic composite signal has a bandwidth of 170 kHz, with a middle frequency of 120 kHz and a peak amplitude of 20 V. The two extreme frequencies have an amplitude of 10 V. 1. The lowest frequency is KHz. 2. The highest frequency is KHz. Draw the frequency domain of the signal. (You don't need to submit the curve to the Canvas.)