Problem An open circular tank of 20 cm diameter and 100 cm long contains water upto a height of 60 cm. The tank is rotated about its vertical axis at 300 r.p.m., find the depth of parabola formed at the free surface of water.

Problem An open circular tank of 20 cm diameter and 100 cm long contains water upto a height of 60 cm. The tank is rotated about its vertical axis at 300 r.p.m., find the depth of parabola formed at the free surface of water.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Water is flowing into a frustum of a conical vessel 2 m high at 100liters per minute. The vessel has…

A: To determine the height of water when the water surface is rising at 25.72 mm/min.

Q: 542.A hydraulic jump was established in the river. The depth before the jump measured 3.38 cm and…

A: Given data in question Depths of flow Width of channel Discharge To find out Type of jump

Q: A discharge well that completely penetrates a confined aquifer has radius 0.5 m. The steadystate…

Q: 4. A prismatic vessel has two compartments A and B connected by a 30cm x 30cm standard orifice. The…

A: Orifice:An orifice is a small entrance on the side or bottom of a tank that enables any type of…

Q: Determine the pressure at the higher end if the pressure at the lower end is 24.525 N/cm^2. 23.924…

Q: A commercial solvent at 20°C flows from tank A to tank B through 152 m of new 150-mm asphalt-dipped…

A: We have to solve for value of flow in system.

Q: -solve it with diagram A closed conical tank has a base diameter of 3m at the top and an altitude of…

A: An inverted closed conical tankBase diameter (D) = 3 m, Base radius (R) = D/2 = 1.5 mAltitude (H) =…

Q: 1. Oil is placed inside a closed container, but it is not filled to the top. The vacant area above…

Q: 11. A tank 3.66m has its ends vertical, top and bottom horizontal, 1.82m high. The top and the…

A: Given: Required to find: the time necessary to lower the water surface to 1.22m

Q: determine the critical depth of a trapezoidal channel conveying 1.33 cumecs of fluid .The base of…

Q: A liquid flows at a depth of 400 mm with an average velocity of 6 m/s in a rectangular channel.…

Q: In fig. if water level = 2 m and the liquid * ?--- =S.G=0.85 , hl %3D Water Ah A' B' 2.35 m. 3.35 m…

Q: 1. The tank in figure is 3 m wide into the paper. Neglecting atmospher compute the hydrostatic (a)…

Q: A cylindrical tank having a diameter of 1.8 m and a height of 5 m is open end and closed at the…

Q: A conical funnel has radius 4 cm and height 8 cm. A liquid is draining from the funnel at a constant…

A: Draining rate (Q) = 1.3 cm3/sRadius of cone (R) = 4 cmHeight of cone (H) = 8 cm(a) Depth of the…

Q: An isosceles triangle inclined 30 degrees with the horizontal with its top base 2.5 m deep from the…

A: Hydrostatic force: The pressure acting on the fluid at rest influence of gravity is known as…

Q: A 0.1m-Φ x 0.094m solid cylinder weighs 4 Newton. It is submerged in a liquid (SG = 0.8328) which is…

Q: SG = 0.90 Determine the elevation difference, between the water levels in the two open tanks shown…

Q: An upward flow of oil (mass density 800 kg/m3, dynamic viscosity 0.8 kg/m-s) takes place under…

Q: If the flow changes from subcritical to supercritical, would form. A. Hydraulic jump B. Submerged…

A: Flow types and conditionswanted to know if the flow changes from subcritical to supercritical what…

Q: A vertical circular tamk is 1.5 m high, has sloping sides. The tank is 50 m and 30 m in the top and…

A: h=1.5m C=0.63

Q: A large tank contains water to a depth of 95cm. The water discharges from a sharp edged orifice of…

A: Given that A large tank contains water to a depth of 95cmThe water discharges from a sharp edged…

Q: A 1.2m diameter open vessel, 2m high is filled with oil s.g = 0.85 at a depth of 1.6m and rotated at…

Q: A town is planning to develop a new water supply from an aquifer. Two observation wells installed…

A: Calculation of total ground water discharge/ volumetric flow rate:

Q: A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev.…

Q: Water at 300C flow in a Venturi meter with the velocity 3 m/s. The tube diameter at station 1 is D1…

A: velocity at station 1V1=3 m/stube diameter of station 2D2=30 cmpressure at station 1P1=30 Kpa…

Q: A syphon of diameter 200 mm connects two reservoirs having a difference in elevation of 15 m. The…

A: Given- Diameter of syphon d=200 mm, Difference of elevation of two reservoirs=15 m, Total length of…

Q: An open rectangular tank 6 m long, 3 m wide and 2m deep contains water to a depth of 1 m. It is…

Q: In fig. FV = -----? If the tank width is 5 m (into the paper)

A: This question is related to the Fluid Mechanics.

Q: Part A Water flows at 700 ft° /s over the 12-ft-wide spillway of the dam. The depth of the water at…

Q: 1. A circular orifice 30 mm in diameter, in the interval side of a vessel, discharge water under a…

Q: Answer fast please clarify all question.

A: Solution:To calculate the velocity of the pressure wave in the pipe and plot the variation of…

Q: Sand is contained in a hopper that is in the shape of an inverted circular cone. Sand flows out of…

A: Given values, H= 10 m, r = 12/2 =6 m Rate of flow of sand = 10 m3/min depth of sand = 3 m

Q: A square plate having one of its side equal to 3m is immerse in a water surface in a vertical…

A: Given square plate of side = 3mThe center of pressure = 8 cm from CG of plateIt is asked to…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Problem
An open circular tank of 20 cm diameter and 100 cm long contains water upto a
height of 60 cm. The tank is rotated about its vertical axis at 300 r.p.m., find the depth of parabola
formed at the free surface of water.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

13. An open tank contains liquid 8 m deep of unit weight of 9 kN/m3, water of unit weight of 9.81 kN/m3 is poured over the liquid and the the total depth of both liquids is 5 m. Obtain the gage pressure in KPa in the interface of the two liquids
Within 5 minutes
A vertical circular tank that is 1,5 m high, has sloping sides. The tank is 50 m and 30 m in the top and bottom diameters respectively. Discharge takes place through a triangular orifice situated at the bottom of the tank. The orifice has a base of 0,8 m long, 0,5 m below it's vertex. If the tank is originally full of water, what time is required to empty the tank? Take discharge coefficient as 0,63.
Question A wooden block is form of a rectangular prism, floats with it's shortest axis vertical. The block is 40 cm long, 20 cm wide and 15 cm deep with a depth of immersion of 12 cm. Comment on the stability of the block.
A vertical cylindrical tank, 2 m diameter has, at the bottom, a 5 cm diameter, sharp-edged orifice, for which C_{d} = 0.6 Water enters the tank at a constant rate of 9 l/sec. At what depth above the orifice will the level in the tank become steady?
Solve with clear solution.
A flow of water of 100 lt/sec flowing through rectangular tube of width 600 mm and having adjustable bottom slope with C = 56. Find the bottom slope required for uniform flow of depth 300 mm. Also, determine the convience of fume.
Situation 2: An open cylinder vessel 1.2 m in diameter contains water at a depth of 3.75 m. 3) If it is rotated at a speed of 85 rpm about its vertical axis, determine the least depth (m) of the vessel so that no water will be spilled out. A) 4.0 B) 4.2 C) 4.5 D) 4.7