Answered: Problem #1: If the current flowing…

Problem #1: If the current flowing through a 75mH inductor has the waveform shown below, (a) Determine the equation of the current for 0

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: All capacitors were initially discharged. at t = 0, S1 is placed at position 1 and S2 is closed.…

Q: The switch in the circuit has been in position a fora long time. At t=0, the switch moves…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: An inductance of 1 H, a resistance of 8 Ω and capacitance of 0.04 F are connected in series with a…

Q: The voltage across a 0.5 H inductor is given by the equation, e(t) = 0.5t + 2, V at t = 0. Find the…

Q: The electric current i (in A) through an inductor of 0.40 H as a function of time t (in s) is i= e -…

Q: An inductor in an electric circuit is essentially a coil of wire in which the voltage is affected by…

Q: Exercise 5: The current through a 50 mH inductor is i, (t) = 10sin(200t) Calculate the expression…

Q: A capacitor is composed of 2 plates separated by a sheet of insulating material 2mm thick and of…

A: We need to find out relative permittivity and equivalent capacitance, charge and voltage for each…

Q: Exercise VI A Circuit has in series an EMF given by E(t) = 100 sin(200t)V, a resistor of 400, an…

Q: The current through a 10-mH inductor is shown in Fig.1. plot the voltage across the inductor. i(t)…

A: Given data: Current through inductor Inductance, L=10 mH

Q: 2. A. Plot the voltage on the capacitor ve verses time for the circuit below. B. Give the equation…

Q: A 0.1 henry inductor, a 4x10^(-3) farad capacitor, a O ohm resistor, and a voltage source having a…

A: In this question we will find differential equation for series RLC circuit...

Q: 3. A. Plot the voltage across the inductor, vL, verses time for the circuit below. B. Give the…

Q: 2. If the voltage across 300 mH inductor is v(t) = (0.5-3t)e³r V; %3D A. Plot a graph of the voltage…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 7. After the 5F capacitor is fully charged with a 9V battery, disconnect the capacitor with the…

A: In this question we will find capacitor voltage at given time and charge stored in capacitor at that…

Q: Q2: The swien n the circuit shown has been in position 1 for a long time. At t 0 it moves…

A: "Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: The current at the terminals of the two capacitors shown is 240e −10tμA for t≥0. The initial values…

A: Current, i = 240 e-10t µA. Capacitance, C1 = 2 µF. Capacitance, C2 = 8 µF. Initial voltage across…

Q: Determine the charge on the capacitor at any time t> 0 in a circuit in series having an emf given by…

A: We need to determine the charge on the capacitor at any time t>0 in a circuit in series having an…

Q: The current flowing through a 10-μF capacitor having terminals labeled a and b is i ab =0.3 exp(…

A: To find the equation of voltage across capacitor when a current of 0.3 exp( −2000t ) A flowing…

Q: Two capacitors, of capacitance 3µF and 5µF, are connected as shown to batteries A and B which have…

Q: 5. In the circuit shown, the 2.50 µF capacitor is charged initially to 175 V, while the 1.20 µF…

A: The solution is given below

Q: For the circuit shown, calculate 1. the initial energy stored in the capacitors; 2. the final energy…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 20μF capacitor is subjected to a voltage pulse having a duration of 1 s. The pulse is described by…

A: The capacitance C=20 μF Ther expression for current through the capacitor is given by…

Q: Consider the circuit below. The capacitor has 61 uF capacitance. R1 has 36 kQ of resistance and R2…

Q: The rectangular-shaped current pulse shown is applied to a 0.1 micro F capacitor. The initial…

A: The Given Capacitor C=0.1mF The Initial voltage on the capacitor is 15V To derive the expression for…

Q: The resistance, inductance, änd capacitance in a parallel RLC circuit are 2000 N, 250 mH, and 10 nF,…

A: For the characteristics equation, the roots are expressed as:

Q: If a current i(t)=5sin(10t) mA flows through an inductor of inductance L=10 H, then find out the…

A: Method 1:It is known that current flowing through the inductor is a sinusoidal wave. It can be…

Q: 100 µF 15 mA 6 kO 0.3 H 60 mH 24 V 250 µF 3 k2 4 kO 2 ΚΩ

Q: * Determine the charge stored on a 2.2 µF capacitor if the capacitor’s voltage is 5 V. *In some…

Q: Determine the current through a 100-p F capacitor if its voltage as a function of time is given by…

A: Find the current in the circuit Voltage waveform are given in the figure. Find the current…

Q: A 10μ F capacitor is connected in series with a 0.7 MΩresistor across a 200 V d.c. supply. If the…

A: According to question: a) The time constant and initial charging current is calculated as…

Q: The voltage across a 15 H inductor is given by v = 28.5 + 6t1/2 v. Find the current in the inductor…

Q: inductor in an electric circuit is essentially a coil of wire in which the voltage is affected by a…

Q: If the current through a 5 mH inductor is increasing at 3 A/s, what is the voltage across the…

Q: A capacitor consists of two metal plates, each 40 cm×40 cm, spaced 6 mm apart.The space between the…

A: The solution can be achieved as follows.

Q: The current in and the voltage across a 5 H inductor are known to be zero for t≤0. The voltage…

A: a) The given data from the question is depicted below: 0≤t≤1s v=-100t1s≤t≤3s…

Q: If the expression of the voltage across a capacitor of capacitance C=10 mF is v(t)=5 sin(10t) mV,…

A: If v(t) represents the voltage applied across a capacitor of capacitance C, then the expression of…

Q: Determine the charge on the capacitor at any time t> 0 in a circuit in series having an emf given by…

A: The emf of the capacitor is given by,f(t) = t,0<t<π0,t>πAndThe value of the components…

Q: In the circuit shown, given that v(0) =10 V, (a) Find the capacitor voltage v(t) for t>0. (b) Find…

Q: QI. The initial values of i, and iz in the circuit shown are +3 A and -5 A, respectively. The…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Calculate the capacitance between two parallel plates, each of which is 100 sq. Inches and 2 mm…

A: We need to find out capacitance for given parallel plate capacitor . We will also find out…

Q: A parallel-plate capacitor was measured to have a capacitance of Co. What would be the new…

Q: 4. When a capacitor, charged to a p.d. of 300 V, is connected to a voltmeter having a resistance of…

Q: The equation for the voltage v(t) across a capacitor at time t is 1 i(t)dt + 90 v(t) = – Where i(t)…

A: In given voltage expression, the initial charge across capacitor is “0” and capacitance of capacitor…

Q: Given that the electric circuit shown below is at steady state, find the energy stored in each…

A: We have given that the electric circuit shown is at steady state find the energy stored in each…

Q: When an electrical circuit has inductance L, resistance R, capacitance C, and applied voltage v(t)…

A: Given Equation: Lq"(t)+Rq'(t)+1cq(t)=V(t)Ld2qdt2+Rdqdt+1cq=V(t)V(t)=2 sin(t)0<t<π0t≥π

Q: Time-Dependent Circuit capacitor that charged when the switch is in the left position and then…

Q: (i)In the RC charging circuit shown below whose R=2kQ, Vs=23 V and C=600µF (a) What is the voltage…

A: According to Bartleby guidelines I am supposed to do only a , b , c , d. Kindly post next one as a…

Q: The resistance, inductance, and capacitance in a parallel RLC circuit ar nF, respectively. a)…

Question

Problem #1: If the current flowing through a 75mH inductor has the waveform shown below,
(a) Determine the equation of the current for 0 <t < 1, 1<t< 3,and 3 < t < 4 sec.
(b) What will be the equation(s) representing the voltage that develops across the inductor terminals for the
same time interval?
(c) Sketch your results from part (b).
i(t) (A)
3
4 t(s)
-5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Find the equivalent capacitance with respect to the terminals a, b Determine the the initial voltage drop for the equivalent capacitance with respect to the terminals a, b
The current through a 5-mH inductor is shown in the Figure. Determine the sign and magnitude of the voltage across the inductor at t = 5 ms. Enter your answer in magnitude of volts with the current sign.
Find the equivalent capacitance with respect to the terminals a,b Determine the the initial voltage drop for the equivalent capacitance with respect to the terminals a, b
An inductor is "charged" to some value, then connected in series with a 1002 resistor and allowed to "discharge". A measurement of the potential difference across the resistor is shown in the figure below. Compute the time constant of the circuit, the inductance of the inductor, and the initial current through the inductor. 12 10 8 6 Potential across resistor (V) 2 0 0 0.0001 0.0002 0.0003 0.0004 0.0005 0.0006 0.0007 time (s)
A capacitor can be used .............................................. in electrical circuits. Which of the followings fit? To regulate the currents To regulate the voltages To store energy by deposition of electric charges To provide energy as passive circuit element To store energy in the form of magnetic field To create time varying voltages and currents To dissipate energy To convert elektrik energy into heat or light
a. Show how you would connect all five capacitors to get a maximum capacitance and find the maximum capacitance in terms of C. b. Show how you would connect all five capacitors to get a minimum capacitance and find the minimum capacitance in terms of C.
The current through a 10 mH inductor is shown in the figure below. Sketch with proper labels the voltage waveform in the same time interval. Show your solution.
A 140-mH inductor and a 5.50- resistor are connected with a switch to a 6.00-V battery as shown in the figure below. E ww 000 R L (a) After the switch is first thrown to a (connecting the battery), what time interval elapses before the current reaches 220 mA? (???) s (b) What is the current in the inductor 10.0 s after the switch is closed? (???) A (c) Now the switch is quickly thrown from a to b. What time interval elapses before the current in the inductor falls to 160 mA? (???) ms
how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
Find the voltage v1 across the inductor as shown in figure below due to DC voltage source.
Please draw the problem and answer, thank you. A capacitor is made of 2 rectangular metal plates with side length of 3 cm x 6 cm separated by a distance of 2.36 cm with water in between the plates. The capacitor has a voltage of 110 v and is not connected to a battery. Calculate the capacitance. What is the new capacitance if we replace water with a new dielectric material with a constant of 3.75 in between the plates? What is the new voltage? What is the charge on each plate?