Please show you detailed solution Number 44 A capacitor passes a current of 12.6 mA when supplied with 20-V AC with a frequency of 1000 Hz. The capacitance will A. 10 µF C. 10 nF B. 100 µF D. 100 nF

Please show you detailed solution Number 44 A capacitor passes a current of 12.6 mA when supplied with 20-V AC with a frequency of 1000 Hz. The capacitance will A. 10 µF C. 10 nF B. 100 µF D. 100 nF

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 14RQ: A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow,...

See similar textbooks

Related questions

Q: 9) A car moving with a speed of 120Km/h along a straight highway and is brought to rest within a…

A: Given: Speed, u=120km/h or u=120×518=1003m/s Distance covered to come in rest, s=150m Final speed,…

Q: Caxade Three similar resistors connected in star draw a line current of 5 A from a 400 V, 3-phase…

A: Given - Line current, IL=5A, Line Voltage, VL=400 V, To find - Line Voltage to obtain the same…

Q: image 93

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: How do you convert a voltage source in series with a short-circuit to a current source? A B Multiply…

Q: How do you convert a current source in parallel with a resistor with infinite resistance to a…

A: We need to select correct option for given statement

Q: Describe the operation of a transparent latch and possible applications for it.

Q: Find :

Q: Question 25 Not yet answered In a parallel circuit 1.5 mAmps flows through a 600 ohm resistor. What…

A: Given, A parallel circuit with, Resistance, R=600 Ω. Current flow through resistor, I=1.5 mA.

Q: An ideal 7.5 kW electric machine runs at 10000 rpm. What is the torque developed? T= Nm

A: Given, An idea electric machine has, Rated power, P=7.5 kW. Speed, N=10000 rpm.

Q: a.8.) A robot can use a back-pressure sensor to (a) measure the intensity of visible light. (b)…

A: a.8) Back pressure sensor : Robotics engineers use back-pressure sensors mostly to limit the…

Q: Consider a causal second-order system with the transfer function G(s) lim c(t), rounded off your…

Q: A coil having inductance of 0.04 H is connected across 50 hertz AC supply. Calculate the inductive…

Q: O A 50- load consists of a resistor in parallel with a 75-µF capacitor. If the load is connected to…

A: Important note: In the given problem statement, it is given the the load is consisting of a resistor…

Q: Please show your detailed solution Number 17 A 100-mH inductor is connected across a supply of 50 V…

Q: In a series R-L-C circuit, R = 200, X₁ = 350 and Xc = 150. The phase angle of the circuit is…

A: Given, A series R-L-C circuit where, R=200 ΩXL=350 ΩXC=150 Ω

Q: A spring controlled moving iron voltmeter draws a current of 1 mA for full scale value of 100 V. If…

A: Given a spring controlled moving iron voltmeter draws, Current, I1=1 mA. Full scale value, α1=100 V.…

Q: op-Amp circuit that produce output given by Vo= -(4√₁ + √₂ +0.11₂) if v₁ = 2 sin wt ; V₁₂ = 5V, and…

A: We need to design the given circuit and we need to draw output

Q: What are the different types of 4 layered diode

A: To explain: Different types of 4 layered diode.

Q: Describe the operation of a transparent latch and possible applications for it.

A: Given: Describe the operation of a transparent latch and possible applications for it.

Q: How to transform a voltage source in series with a resistor R to a current source? Divide voltage…

Q: op-amp circuit to produce No = "( V₁ +5V/₁₂ with maximum output voltage is lov and the feedback…

A: 7

Q: A unity feedback control system has an open-loop transfer function G (s) = The centroid of the…

A: Given, Open loop transfer function, Gs=Kss+1s+2s+3. Unity feedback, Hs=1.

Q: energy a) Draw energy band diagram of a pn junction in thermal equilibrium showing the bands in the…

Q: 6. These 3 sinusoids are added together, and sampled every 10 ms, Calculate the first 10 points of…

A: Given three time domain signals. Asked to find the sum of the given signals and plot, sampled at…

Q: Example 1: If the resistance of an electric iron is 50 Q and a current of 3.2 A flows through the…

A: Given data, Resistance R=50 Ω. Current i = 3.2 A.

Q: 3. Find the inverse Z-Transform of the following signal: Z-1 H(z) = |z| > 1 (1-z-¹)(1-z-¹)²

Q: Given the following linear system: 8d²y(t) +9+7 y(t) dt² dt Find Y(s)/R(s) for the above system…

A: Given, The linear system is, 8d2ytdt2+9dytdt+7yt=6rt. All initial conditions are zero.

Q: Calculate the displacementand conduction current densities of a material having conductivity 102…

Q: Problem #1 Consider the following waveform: Forstoff 0.3m -0.3m -1.5m -8.9m x(t) 0.9m 1.5m (a) Find…

Q: Ex = Design op-amp circuit to produce Vo = (v₁ +51₂) with maximum output voltage is lov and the…

Q: Question # 5: Find the ramp response for a system whose transfer function is G(s) = s/ [(s+4) (s+8)]

Q: 5.6 Two types of connection of Wattmeter pressure coil are shown in the figures. voo O 000 10 ΚΩ 000…

A: Given two types of connection of wattemeter pressure coil. The connection errors are same in both…

Q: B- Find the F.T of f(t) = cos(w.t) f(x)

Q: Problem 03.049 - Mesh analysis: Independent voltage source and dependent current source In the…

A: Given:

Q: 2. Find the output voltage v, across RL a. in terms of vi, and b. in terms of v, (substitute your…

A: In this question We need to determine the Vo. We are solving this problem using the voltage…

Q: In a de shunt motor, at 4 amp. the torque developed is 20 Nm. If the load current doubles, what is…

A: Given, For a dc shunt motor with, Current, I1=4 A. Torque developed, T1=20 Nm. If current doubles,…

Q: Consider a causal second-order system with the transfer function G(s) = lim c(t), rounded off your…

Q: R(s) = G(s) s+3 s+5 Zero: s= C(s)

A: Given

Q: In a TVRO circuit, the antenna is connected directly to the amplifier. To match the input impedance…

A: Given equivalent noise resistance Rn=129 kΩ the input resistance of the amplifier Ra=15 kΩ Noise…

Q: 1. What would a mobile robot most likely use to locate itself in a large vacant parking lot? a.A…

A: Solution of question (1): It is asked what is used by a mobile robot most likely use to locate…

Q: What is Filter Design?

A: A filter is an electronic circuit that removes unwanted components (noise, interference, distortion,…

Q: QUESTION 4 Find the mesh currents i1, 12 and 13, and the resistor R in the circuit below. Show all…

Q: A balanced load of 30 MW is supplied at 132 kV, 50 Hz and 0-85 p.f. lagging by means of a…

A: Given, Balanced load P=30MW, Voltage V=132KV, frequency f=50Hz Power factor cosϕ=0.85, series…

Q: [H-W3:] show that V. (1)= [R²2 V₁ (4) + [CR₂ + 1 ] dvi (4) Ri at + Lc d²vict) dt² for the circuit…

Q: A coil having inductance of 0.04 H is connected across 50 hertz AC supply. Calculate the inductive…

A: We need to find out for given coil reactance .

Q: 3 A 4 Ω 2 Ω 2Ω www 4 Α 10 Ω www 10 Ω 1746

A: We need to find out total resistance and total current for given circuit

Q: Can you please explain how line current was found?

Q: 3. Calculate Vas in the circuit. 75 V + 2012 120 .300 280 150 एक ww ab www 2012 a 180

Q: Find the inverse Z-Transform of the following signal: Z-1 |z| > 1 (1-z-¹)(1-¹-z-¹)²' H(z) =

A: This is a problem of Z transform. The solution is given in the next step.

Q: What is the multiplying power of a shunt of 200 resistance when used with a galvanometer of 1000…

A: Given, Shunt resistance, Rsh=200 Ω. Meter resistance, Rm=1000 Ω.

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
Through a capacitor of capacitance 15 micro-farad with a frequency of 50 hz. Compute its reactance 212 ohms O 4,712 ohms O 0.0047 ohm O 0.0002 ohm