A capacitor of capacitance C discharges through a resistor of resistance R. Which one of the following statements is not true? 106. A. The time constant will decrease if C is increased. B. The time constant will increase if R is increased. C. After charging to the same voltage, the initial discharge current will increase if R is decreased. D. After charging to the same voltage, the initial discharge current will be unaffected if C is increased.

Q: Insulation detorioration of transformer winding due to high temprature is an incepient fault O True…

A: Insulation deterioration of transformer winding due to high temperature is an incipient fault  Is it…

Q: What will be the losses of a transformer if it is working in step up mode compared to its losses in…

A: Transformer: It is an electrical device that is responsible for transforming the voltage from one…

Q: What are the differences between natural fractures and induced fractures on the core? a) Surfaces of…

A:

Q: What are the protection coordination procedure of circuit breakers

A: Protective Devices MOV (Metal Oxide Varistor) fuse Circuit Breaker Relay Lighting Arrester Inrush…

Q: - Inter pole winding is connected in

A: Inter pole produces a counter emf to nullify reactance voltage.

Q: The open circuit voltage of a transformer is 248 V and its % regulation is 2.5 %, then the value of…

A:

Q: what is meaning of contamination of condensate water and reasons and how to solve this fault, 2-…

A:

Q: In a power system with negligible resistance, the fault current at a point is 800 p. u. The series…

A: fault impedance = prefault voltage / fault impedance. Fault current before and after series…

Q: Load sets are connected in series or in parallel but fuse must be always connected in a)series…

A: ANSWER:- OPTION.A

Q: Isolation transformer is used for purpose.

A: isolation transformer is used in the system which is not at the ground potential and in other…

Q: For the following circuit if the secondary voltage of the transformer is 20V max, the output voltage…

A: given here a electrical circuit and asked to find the output voltage.

Q: In static characteristics, is specified at only one particular point of scale.

A: Static characteristics: It is used to measure the quantities that are slowly varying with time or…

Q: In your own understanding what do you understand by step down transformer

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: 7- DC-DC converters can be classified depending on the flow direction of current and voltage.…

A:

Q: In cross circuits, how do i know the resistances are in parallel or in series connection?

A: The solution is given below

Q: 1. R,=". %3D Ry = 100 Ω %3D R2= 50 Ω R3 =50Ω

A:

Q: Perform the following arithmetic using 2’s complement form (Show step by step process) (a) -6 + 13…

A: 2's complement of a number can be obtained by adding 1 to the 1's complement of the number. 1's…

Q: Series/parallel

A:

Q: In Step down transformer, the Number of the primary winding (N1) is Larger Number of the secondary…

A: a transformer changes the voltage level  when its step up then it increases the voltage level from…

Q: In a step-up transformer, the turn ratio is 1: 20. The resistance of 100 connected across the…

A: It is given that:

Q: Cite practical applications of Kirchhoff’s Laws and Divider Rules.

A: Kirchhoff's laws: 1) Kirchhoff's current law: According to this law, the sum of total incoming and…

Q: The compensating winding is connected in ) parallel with main poles series with main poles parallel…

A: The explanation is as follows.

Q: Soru 4) Yukandaki devrede R1=59, R2=5 ohm, C1=0.1F, C2=0.2F olduğuna göre transfer fonksiyonu H(s) =…

A: The transfer function of the given circuit across the circuit element needs to be obtained.

Q: B. H.

A: Bulb brightness depends on current flowing through the bulb  When current is more, brightness is…

Q: transformer, the secondary side operates almost in open circuited condition.

A:

Q: .A commutator is made of segments a. Iron b. Steel O c. Copper O

A:

Q: Think about the benefits and drawbacks of anticipatory standards vs reactive ones.

A: ***Anticipatory standards are standards that are established in advance of a particular event or…

Q: Choose the correct statement. A step-up power transformer has "a" greater than 1. O A step-up power…

A: In this question we need to choose a correct option.

Q: A resistor can remove the direct current bias. A True B) False

A: Given :  Note : It is the kind notice that the mentioned questions are different , according to the…

Q: What is VR3?

A:

Q: The time available to turn-off thyristor in load-commutated chopper is 3-2E2Cf, 4-C, 5- None of…

A: The above question is based on load commutated chopper.

Q: Generators are often run in parallel because it Keeps stability of supply Gives facility of repair…

A:

Q: What is the nodal voltage?

A: Given: To answer what is nodal voltage?

Q: What is the rated current of the autotransformer at the low voltage side ( ILrated )? Note that the…

A:

Q: was If the number of layers/slot is 4 then the number of coils ----- the number *.of slots twice O…

A: Four layers/ slot means there are 4 diffrent coil sides under one slot one coil has it sides in two…