Please offer a brief justification for your answer to each of the following questions. The alternating-bit protocol and the SR protocol are interchangeable when the window sizes of the transmitter and receiver are both one.

Q: What is the purpose of Sub-Address in data transmission on data bus 1553 Protocol?

A: Given: What is the purpose of Sub-Address in data transmission on data bus 1553 Protocol?

Q: please answer with proper explanation and step by step solution with final answer conclusion.…

A: To calculate the transmission rate in bits/sec, we need to know the size of the picture frame in…

Q: Recognize the differences between ternary and three binary connections.

A: The most common sort of relationship that contains instances of two entity types is a binary…

Q: Find the CDMA waveform for the following users ' data [1100 ] , [ 0101 ] , [ 1101 ] , [ 1000 ] and…

A: Required : CDMA waveform for given data and PG

Q: Explain the ARP procedure that occurs when a frame is sent.

A: ARP (Address Resolution Protocol ) is a network protocol used to distinguish a device's hardware…

Q: Study the works of Shannon and Nyquist on channel capacity. Each places an upper limit on the bit…

A: Given: Learning about the research of Shannon and Nyquist on channel capacity is essential. sets a…

Q: Explain REST and state the protocol that REST used for communication

A: A protocol is set of rules and regulations which governs during working of system.

Q: Discuss the main difference(s) between sliding window (e.g., Go-Back_N) protocol and the Simplex…

A: Difference between sliding window protocol and simplex stop-and-wait protocol: Some of differences…

Q: Give an example of a synchronous connection and one of an isochronous connection, and explain the…

A: Synchronous and isochronous connections are two different methods of transmitting data between two…

Q: Convert the following numbers to 32-bit IEEE foating point format: 10, -5, -6, -1.5 ,384

A: -5 Significand: 0100000000000000000000000000000000000000000000000000  Exponent: 10000000001  10…

Q: 1. (b) Suppose you were in a classroom with your friends and professor. Your professor was teaching…

A: We are going to understand the scenario given in the question involving a classroom and we will…

Q: Please indicate if this statement is true or incorrect, and provide a short explanation for your…

A: The statement is incorrect they explanation is given in step2

Q: True or false, and please provide a short explanation for how you feel about each of the following…

A: Explanation: SR : It is a selective repetition technique that is used in the OSI model's data…

Q: lex cable runs at T1 data rate cable is 2/3 the speed of light in the cable is

A:

Q: Define bisection bandwidth.

A: Bisection bandwidth: In computer networking, if the network is separated into two…

Q: SAMPLE DATA HELLO CODE

A: A)in below figure shows how to transit message  are multiplexed into frames.

Q: source encoding is 101 and the r is 2. what is the channel encoding?

A: Code for the source: A feed encoder turns electrical wavelengths to bits, while a receiver reverses…

Q: What are the key differences between asynchronous, synchronous, and isochronous connections, and…

A: Asynchronous Connection: Information is transmitted from one end to the other. A connection is…

Q: write the numricals of  queying  delay transmission delay and propagation??

A: Delays, means time required for processing of the packet. There are following types of delays:-…

Q: Please let us know if you believe each of the following assertions to be accurate or false, and…

A: Alternating-bit protocol and Selective repeat (SR) protocol are two protocols commonly used for…

Q: Suppose two users in a Direct Sequence-CDMA system have signatures (that is, sequences of chips)…

A: Actually, given question regarding CDMA.

Q: MAC address of a device is represented using Hexadecimal number. A section of MAC address is given…

A: Mac Address section taken as: 031(Hex) We have to convert this to binary. Hex: 031 Binary: 110001…

Q: As a Network Engineer, assume that you are given 9 input-lines that carry digital inputs, and the…

A: Given: As a Network Engineer, assume that you are given 9 input-lines that carry digital inputs, and…

Q: Give an example of a synchronous connection and one of an isochronous connection, and explain the…

A: Introduction: Data is exchanged between two parties via an asynchronous connection. The connection…

Q: By inspecting the LSB, you may quickly determine if a bit stream represents an odd or even decimal…

A: Everything is represented in machines in terms of bits. A bit is capable of storing either 0 or 1.…

Q: A voice channel occupies a bandwidth of 28 kHz 10 voice channels are to be multiplexed together…

A: FDM is a technique used in telecommunications and signal processing to combine multiple signals into…

Q: Calculate the minimum timeout value for a stop-and-wait algorithm running over a 50-meter…

A: A stop-and-wait algorithm is a flow control protocol used in data transmission between two nodes. In…

Q: e need to use Synchronous Time Division Multiplexing to combine 17 different channels, where 10…

A: It is defined as the multiplexer assigns an equal time slot to every device at all times, whether or…

Q: Use appropriate SFR to initialize all bits of port D with 0 Note: give your answer in hexadecimal…

A: Given: Describe appropriate SFR to initialize all bits of Port D with 0.

Q: 6. In CRC, if the generating function is 1001 1, and input bit stream is 0110001 101, what is the…

A: Cyclic Redundancy Check (CRC): It is an error detection method. It is based on binary division. CRC…

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.