Time Division Multiplexing scheme is implemented in a channel. The multiplexer in TDM used eight 500-kbps channels using a time slot of 4 bits. a. What is the output of the multiplier if the input to the channel is b. c. 100010101010101000? What is the frame rate? What is the frame duration? What is the bit rate? MEC_AMO_TEM_035_02 Page 4 of 11 iii. d. What is the bit duration?

Time Division Multiplexing scheme is implemented in a channel. The multiplexer in TDM used eight 500-kbps channels using a time slot of 4 bits. a. What is the output of the multiplier if the input to the channel is b. c. 100010101010101000? What is the frame rate? What is the frame duration? What is the bit rate? MEC_AMO_TEM_035_02 Page 4 of 11 iii. d. What is the bit duration?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 37VE

See similar textbooks

Similar questions

The Fig 4.1 shows a demultiplexer of a TDM. If the frame size is 16 bits long (no synchronous / frame bits), what is the bit stream in each output? The bits arrive at the demultiplexer as shown by the arrow. 000011101010101010000111011100000111100011 Fig: 4.1
Suppose, you have 6 voice channels, each of 60MBPS. You have to use synchronous TDM to multiplex these channels. If 2 characters at a time are multiplexed (2 characters in each output slot), answer the following: What is the size of an output frame in bits? What is the output frame rate? What is the duration of an output frame? What is the output data rate? Input bit duration? Output bit duration? Output slot duration?
IV For a bit stream 0110010 1, sketch the waveforms for (1) NRZ-I (i) Manchester Note: (i) For NRZ-I and differential Manchester, assume that the signal level for the previous bit at the start is negative. (ii) For pseudoternary, assume that the most recent preceding '0' bit has a positive voltage. (ii) Differential Manchester (iv) Pseudo ternary
I A channel has a frequency range between 3 KHz and 14 KHz. The SNR in this channel is 25 dB. Find the maximum Bit rate of the channel and the Signal levels. [3 marks] For a bit stream "0 1 1 0 0 1 0 1", sketch the waveforms for (i) NRZ-I - (Assume the initial level at time zero is Low) (ii) NRZ-L - (assume 0 as High and 1 as Low) (iii) RZ Encoding – (Assume the initial level at time zero is Low) [3 marks]
5- A synchronous TDM with four 2 Mbps data stream inputs and one data stream output. The multiplexing unit of data is 1 bit. The input bit duration is the output bit duration is the output frame rate is ------- Frame/sec. otansmi Mbps; and us; the output bit rate is natos imeni adi stonl -.oi mibanaine 1. 1. ... 2 Mbps Be eill Frames ilsbit ... 0. 2 Mbps MUX 2 Mbps 1. 1. ... 2 Mbps .. 7- A de pulse train has a peak voltage value of 5 V, a frequency of 4 MHz, and a duty cycle of 30 percent. The minimum bandwidth necessary to pass this signal without excessive distortion is MHz. (Note: to =T*Duty Cycle; T= 1/F) 8- Ten channels, each with a 200 kHz bandwidth, are to be multiplexed together using FDM. The minimum bandwidth of the link is need for a guard band of 10 k Hz between the channels; while the minimum bandwidth of the link is 20 kHz between the channels. KHz when there is a KHz when there is a need for a guard band of 9. If a channel can transmit a range of frequencies from 10 MHz…
Study the works of Shannon and Nyquist on channel capacity. Each places an upper limit on the bit rate of a channel based on two different approaches. How are the two related?
We have 14 sources, each creating 500 8-bit characters per second. Since only some of these sources are active at any moment, we use statistical TDM to combine these sources using character interleaving. Each frame carries 6 slots at a time, but we need to add four-bit addresses to each slot. Answer the following questions: a. What is the size of an output frame in bits? The output b. What is frame rate? c. What is the duration of an output frame?
4. Using a combination of ASK, FSK and PSK: b) Sketch the transmitted signal for the following bit stream: 10110011 01110100 11000001 c) What would be the data rate of this system if 20,000 signals were sent per second? d) What would be the effective bit time (not the signal time)? e) Could this be sent on a channel with a signal to noise ratio of 20 dB and bandwidth of 11,000 Hz?
6. In CRC, if the generating function is 1001 1, and input bit stream is 0110001 101, what is the output sequence ?
Assume M = 1 1 0 1 02 and P = 1 1 02. Compute: a. The frame check sum (FCS).b. The transmitted frame.c. The received frame and check if there is any error in the data.
We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each output slot carries 1 bit from each digital source, but one extra bit is added to each frame for synchronization. Answer the following questions: a. What is the size of an output frame in bits? b. What is the output frame rate?c. What is the duration of an output frame? d. What is the output data rate? e. What is the efficiency of the system (ratio of useful bits to the total bits)?
Four computers are sending the digital data over a multiplexed line as shown in the Figure below. A). Show how the messages are multiplexed into frames using synchronous TDM and Asynchronous TDM. B). How many frames are generated if you are using Synchronous TDM? C.) How many frames are generated if you are using asynchronous TDM with frame size 3?