Part A A 20.0 uF capacitor initially charged to 30.0 μC is discharged through a 1.20 k2 resistor. How long does it take to reduce the capacitor's charge to 15.0 μC Express your answer with the appropriate units.

Part A A 20.0 uF capacitor initially charged to 30.0 μC is discharged through a 1.20 k2 resistor. How long does it take to reduce the capacitor's charge to 15.0 μC Express your answer with the appropriate units.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 14RQ: A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow,...

See similar textbooks

Related questions

Q: A 3-phase, 50 Hz, Y-connected, AC generator has a stator with 72 slots, each slot contains 10…

Q: Q2\ fill in the blanks 1- Cd element is....... 2- The capacitor has between 2 sheets of electrodes.…

A: “Since you have posted multiple questions, we will provide the solution only to the first five…

Q: Prove that every circuit in Km,n has an even number of edges.

A: 1. Introduction:We aim to prove that every circuit (cycle) in the complete bipartite graph has an…

Q: solve this

A: In both cases, the final step is to have the array sorted in ascending order.Explanation:Step…

Q: 6.1 Show that the radiation resistance of an earthed X/4 vertical aerial is approximately 40 22. An…

A: The objective of the question is to calculate the effective height of the aerial, the electric field…

Q: electromagnetic

A: This is the electric field question

Q: Da R₁ R3 + R2 I HT www RA + R5 Vo i) Find Find Vin terms of R1, R2, R3, Ra, R5 Evaluate V. and I. if…

Q: From Eq (3), is the order (m) of the center fringe larger or smaller than that of the edge fringe?

A: It will be smaller. Explanation:In the double slit experiment the order m of the fringe is defined…

Q: Problem 5: The DC motor you used in Lab 3 generates a torque of T = ½-½ (V - kw), where k is the…

A: The torque-speed (T−ω) relation of a DC motor is given as:T=kR(V−kω),where,k is the motor constant,R…

Q: Question: Calculate the time required for the energy stored in the capacitor to reach 10% of its…

A: a) If you find the solution doubtful or doesn't match with your answer provided, or you feel that I…

Q: Statement one When lifting loads, keep the back straight with the load as close to the body as…

A: Two statements are given in the question. We need to tell which of the statements are correct and…

Q: A conductor is moving with a velocity of 10 m/s in the direction shown. The flux density is 0.462 T,…

A: Given figure is,Asked to find the direction of the induced emf.

Q: 1.→ Convert the following voltages to phasors and state the phase sequence. Is the system balanced…

A: The voltages are given by⇒va=188cos(250t+60∘) V.⇒vb=−188cos(250t) V.⇒vc=188cos(250t−60∘) V.We need…

Q: Convert the following hexadecimal numbers to binary, octal, and decimal. a. C1D.9 b. 3F.216 c. 57.3…

A: According to the question, we need to convert the given hexadecimal numbers to binary, octal, and…

Q: For AC circuits (with sinusoidal sources), we use the Phasor notation. Therefore, for passive…

Q: please show clear work

A: FINAL ANSWER: I have provided all the answers in the below steps. Thank YouExplanation:STEP−1 a)…

Q: 7 and 8 please I will like

A: Please see the attached image for an answerExplanation:

Q: 4.45. Three 60-VA, 120/208-V, single-phase transformers are to be used to form a three-phase…

A: (a) phase voltages,(b) phase currents,(c) a-ratio(d) power rating.All four possible connections

Q: Calculate the Thevenin voltage and resistance. From the open circuit voltage and short circuit…

A: Vth = 5 V Rth = 650.3278689 Ω Rth ≈ 650.33 ΩExplanation: Thank you

Q: 5000 G(s) = (1) s(s+75) ⚫ derive closed-loop transfer function what is the overshoot with a unit…

A: All parts of the question are solved below.Explanation:

Q: 6A Iab a 10-2 b F 12 ++ €2 -> find Iab by using Super Position HA

A: Calculation of current Iab using superposition theorem.According to superposition theorem at a time…

Q: Consider a Y-connected AC generator with a number of turns per phase of 60 turns. Find the flux per…

A: In this question, we need to find, Whats flux to induced line voltage= 850VFrequency f= 50…

Q: What kVA rating is required for a transformer that must handle a maximum load current of 8 A with a…

A: GIven the maximum load current and secondary voltage and required to find the kVA rating.

Q: Please solve this question step by step

A: The objective of the question is to draw the three-phase and equivalent single-phase circuits for a…

Q: Needs Complete solution

A: The objective of the question is to determine whether the voltage level at the customer's end is…

Q: 09.6

A: The relation with chosen current I2 with mesh current has been explained in detail. If any doubt…

Q: 8. Consider the (7,3) systematic cyclic code with g(x) = x²+ x³+ a) Code table & min. Hamming…

A: According to the question, consider the (7,3) systematic cyclic code with g(x) = x4 + x3 + x2 + 1.…

Q: R₁ = 1.2 k ww ΚΩ V₁ R₁₁ = 2.2 k w E₁ R₁ = 3.3 knj E2 15 V R₁ = 1.0k 5 V FIG. 14.3

A: For the given circuit it is asked to find the voltage Va using nodal analysis

Q: This is a practice question from the Signal and Systems course of my Electrical Engineering Program.…

A: a) -wb) 7c) 4πd) 5.5e) 38/3f) AttachedExplanation:Since phase of real signal is zero, X(jw) has 0…

Q: please show clear work

A: To solve this problem, we'll need to use semiconductor physics equations and concepts. Given the…

Q: A wire of diameter 0.900 mm and length 50.0 m has a measured resistance of 1.20 2. What is the…

A: The resistivity of the wire based on the given specifications needs to be calculated.

Q: (a) The signal x(n) has a sampling rate of 40 kHz. It is converted into a signal with a bandwidth of…

A: The objective of the first part of the question is to find the normalized cutoff frequencies for a…

Q: The transistor question is included in the uploaded image:

A: By open circuit test we can determine which transistor in ON and OFF. By KVL and KCL we can solve…

Q: Please find R2 VDs and VGs

A: Given Data:Required:

Q: Find the Power by the 4... resistor. 4... 12.00 6A ↑ 2 2 2000 2 12000

Q: Compute the discrete-time Fourier transform of the following signal: x[n]=u[n]—u[n—3]

A: The given signal is,Express the signal in simple form as,

Q: E D AV = 6.00V C R B AV I = 0.300A 5.00V A 3.000 18. ΦΩ F 32.00 G Use the junction rule for currents…

A: The circuit diagram,

Q: 4. For the following circuits, find vi(t), i(t), v2(t), iz(t), v3(1), v4(t). 5cos 7t V₁ (E) 33H…

Q: How does a solenoid actuator work? List two (2) disadvantages of a solenoid actuator.

A: Working of the solenoid actuator and its disadvantages have been explained in detail. If any doubt…

Q: What kVA rating is required for a transformer that must handle a maximum load current of 8 A with a…

A: As it is given that, the maximum load current is 8A on secondary side of transformer. And the…

Q: A 220V, 20kW, PF=0,8 (leading) delta connected 50 Hz synchronous motor has a synchronous reactance…

Q: an inverting op amp circuit has an RF = 5k and Rin = 1k. what is the gain of this circuit?

A: In this question, we need to determine the gain of the circuit. This is the inverting OP amplifier.…

Q: Using mesh analysis, calculate the mesh currents I1 and I2 of the network. Use the resistor values…

A: I1=6.3489mAI2=5.6275mA (values given upto 4 decimal places) Please comment if you have any doubts. I…

Q: Express the following terms in polar notation: 8/11- (a) ei4+e (b) (2+5j)e/10

Q: 4 For the circuit shown in the given figure, V, 8020 V. Determine the load impedance Z for maximum…

A: Determine the load impedence of maximum power transfer and determine the maximum power absorb by…

Q: Please solve step by step to understand it clearly

A: Transfer function H(x) of cascaded system is product of transfer functions H1(x) and H2(x).…

Q: 17. Draw below how to wire a 3-way switch:

A: 3-way switch - Three-way switches are typically used to operate a single light fixture from two…

Q: Please solve this question step by step

A: In both cases, the transformer's windings are represented by their respective connections (star on…

Q: In order to find I, do I have to find ID2 first? Also, is ID2 as simple as using Ohm's law, I = 10V…

A: Yes Id2 is calculated and then I and the complete method is shown & explained Explanation:Step…

Q: 2. a) Use Kirchhoff's current law to solve for the currents 11, 12, I3, I4, Is and I6 For the…

A: “Since you have posted multiple questions, we will provide the solution only to the specified sub…

Question

Please answer in typing format

Part A
A 20.0 uF capacitor initially charged to 30.0 μC is discharged through a 1.20 k2 resistor. How long does it take to reduce the capacitor's charge to 15.0 μC?
Express your answer with the appropriate units.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determination of given parameters,

VIEW

Step 2: Calculation of time,

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 9 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Can current flow through a capacitor?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
4. In what form is the energy of a capacitor stored?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
An air filled parallel-plate capacitor is connected to a 12 Volts battery, the battery is disconnected when it is fully charged to 7.3 nC. The separation distance between the plates is d1= 8 cm. Now, If the plates are moved to a new distance d233 cm. the new energy stored in the capacitor is O a. 13.14 nJ O b. 8.21 nJ O c. 1.64 nJ O d. 10.96 nJ O e. 5.47 nJ O f. 16.42 nJ
Consider the diagram of the following figure: Determine the charge voltage and energy of each of the capacitors. Make and complete your data table, if the voltage is 300 V C UF C₁= 30 C₂=60 C₁=22 C=74 Cs=32 Co=45 q μC V V W E 300 60μF 22HF C2 C3 30MF C1 CA 74 MF C5 32AF :C6 45MF