o.) Find Curmnt Iy and Voltage Vx short -Circuited, b.) if the terminal a-b is Find the hew Current Iy Value

Q: A coil of resistance 50 ohm and inductance 100 mH is connected in parallel with a 30 mF capacitor ac...

A: The impedance of inductive element is given as XL=j2πfL Here, XL=j2πfL is the inductance and XL=j2πf...

Q: Find the unknown currents 'I2' and 'I5' if l1 = 9 A, I3 = 4 A and l4 = 3 A. %3D

A: To solve above problem, we will use Ohm's law and Kirchhoff's law: Ohm's law state that in a current...

Q: 2. Given the BJT amplifier circuit OVcc RC Cc R1 Vo To Cc Rs RL V's R2. RE Cb Ri' Rs 4700, RI-10KO, ...

A: Brief description: In the above given question they have mentioned an electrical circuit which is kn...

Q: 3. A series circuit consists of a (4.7k , 5.6k2 , 9k2 and 10k2 ) resistor. Which resistor has the mo...

A: Given            The series circuit consists of 4.7 kΩ,5.6 kΩ,9kΩ and 10 kΩ    

Q: Derive the truth table for the circuit shown below. A B b) Write the Product-of-Sum (POS) equation f...

A:

Q: Find the efficiency of a 150 kVA transformer at 25 % full load at 0.8 p.f. lag if the copper loss at...

A: efficiency = output power input power ×100=output poweroutput power + iron losses + copper losses×10...

Q: Q5: Draw the graph of y(t)= x(2t+1)?

A: The output signal y(t) can be obtained by first shifting the signal x(t) and then scale the shifted ...

Q: Homework QI/ A porter lifts a luggage of 15 kg from the ground and puts it on his head 1.5 m above t...

A:

Q: 18. A 30 kVA 2400/240 V, 60 Hz transformer has a full load power of unity over the period of 24 hour...

A:

Q: AM transmitter at 27 MHz develops 10W of carrier power into a 50-ohm load. It is modulated by 2-kHz ...

A:

Q: In a three – phase system with balanced loads, total power using one wattmeter method is given by - ...

A: A circuit of power measurement using three wattmeter method is shown

Q: Fill in the VIR chart for the circuit below.  I need to also reduce the original circuit to a single...

A:

Q: Determine all the currents and voltages for the circuit in Fig.6.8. R, R2 60 R,40 R30 E -16.8 V R.60...

A: Brief description : In the above given question they have mentioned an electrical circuit which cons...

Q: Prob.3. The total loss in a sample of sheet steel weighing 10 kg is 20 watts at 50 c/s and 35 watts ...

A:

Q: 1k 5V

A:

Q: +15 V -10 V +12 V 8 mA| 6 mA| Rp Rp 1.5 kN Rp 1.0 k- 1.0 k2 3 mA 10 k2 R2 RG 10 MQ RG Rs 330 2 10 MO...

A: (a) The figure (a) is shown below: It can be observed from the above circuit diagram that:  Vdd=15 ...

Q: Calculate the voltage gain Uout / U1-U2 for adjacent please write down the answer and how you got th...

A:

Q: 3. Solve for the total resistance of the network below. 4Ω

A: In this question we will find total resistance of circuit....

Q: 2.b. Find the unknown currents in the circuits shown below. E 14 15A 20 A 50 A A- 13 120A 15 F40 A

A: Given

Q: THE CIRCUIT IN Flo URE Q.3 CA) It AS A VOLTAGE SOURCE V(t) 2 100 cos (5t + 20°) V. tHE VALUE OF IN D...

A: In this question,  We need to draw the circuit in the frequency domain.  Also find the current and v...

Q: P1-14. The voltage in Fig. P1.14 is v(t) = 2000t V where t is in seconds. For time t = dict the curr...

A: In this question parallel RC circuit is given....We have to find out current through resistance and ...

Q: For an AM transmitter, the carrier frequency is 0.8 MHz, and the modulation frequency varies from 1 ...

A:

Q: b) Consider the object shown in Fig. 1(b). Calculate: i. The length of CD ii. The surface area ABCD ...

A:

Q: St A P1-13. The current in Fig. P1.13 is i(t) where t is in seconds. For time t 5 ms, pre- dict the ...

A: Given  current i(t) = 5t A  Resistor , R = 150 ohm  Inductor , L = 3H  Now find voltage across resis...

Q: QUESTION 2 a) Consider the grain supply bin as shown in Figure Q2a. The control system is to maintai...

A: CLOSED-LOOP SYSTEM    Closed-loop system in which the control action is dependent on the output. The...

Q: Q) By using Suitable diagramn, describe the circuit laus below a) Kircho FF's la) KivchoFf's Current...

A:

Q: If the memory chip below is used in a system with a 16-bit address bus, then address lines A13 – A15...

A: According to the question, we need to find the address range.

Q: a series rlc circuit having values of pure resistance r=40 ohms and pure inductance l = 50.07 mh. th...

A: (1) The impedance of the series RLC circuit is given by the expression as shown below:  I=VR2+XL-XC2...

Q: (a) Figure Ql shows the Zener diode act as a regulator and having variable input, Vin values. Given ...

A:

Q: (i) Construct the Wheatstone bridge circuit to measure the change in resistance of the gage(s) and s...

A:

Q: FIGURE 3.48 Determine the values of Va, Vijoun, and for the following power supply V = It/C 75 1 D D...

A: Given the circuit, as shown below: We need to determine the values of Vdc , Vr(out) and IL. Since f...

Q: Evaluate the following and write it in rectangular form a.) (3-j)/(2+j7) b.) (3)/(9-j) c.) (j8)/(...

A: a.) (3-j)/(2+j7)

Q: 1ms/div Question 3: What did you observe on the output waveform (PR2) compare to the input waveform ...

A: In this question, We need to what did you observe on the output waveform (PR2) compare to the input ...

Q: R(s) 20 C(s) s+ 20

A:

Q: Plot the Q-point of the circuit below. At а. Beta = 90 %3D b. Beta = 150 с. Beta = 250 16V R1 3.9k R...

A: Brief description :  Bipolar junction transistor are having three terminals such as base, emitter an...

Q: Given the above approximate equivalent circuit for a 440VLL, 60 Hz, 3-phase, 1728 rpm, wye- connecte...

A:

Q: Three capacitors C1 C2 and C3 whose values are 10 µF. 5 µF. and 2 µF respectively, have breakdown vo...

A: This question belongs to circuit theory . It is about breakdown voltages of the capacitors when capa...

Q: I. Datermine the megnitude of the Tesaltentt it irsetion augk f the Sysfem of comcutrect fhe fig 30牛...

A: To find the magnitude and direction angle of the resultant of the concurrent forces 

Q: Emitter-Bias Configuration 8. For the emitter-stabilized bias circuit of Fig. 4.122, determine: IBC ...

A:

Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resisto...

A: Please refer the attached images for the complete answer..

Q: a) Is it ON delay (TON) or OFF delay timer (TOF)? b) Timer base value c) Preset value d) Accumulated...

A: Timers are typically used to control a circuit for a set period of time. We can delay the operation ...

Q: Using 8-bit 2's compliment number, add 14 and -29 together, then verify the result.

A: First convert the 14 and -29 into the 8 bit binary form obtain the 2's completement of the -29 perfo...

Q: Using positive logic, determine the logic function 1resented by the diode circuit of figure 1.

A: The given circuit is a three-input diode OR gate with positive logic. The diode will start to conduc...

Q: A 400V, 3-phase Induction motor has input power of 16 KW and operates at power factor of 0.87 laggin...

A: Given: A 400 V, 3 phase induction motor having Input power, Pin=16 kW Power factor, cosϕ=0.87 laggin...

Q: (b) Figure Q.2b shows an RL circuit uses as a filter where v(t) as the input voltage and i(t) is the...

A: Given information: R=5 Ω. L=50 mH. The given transfer function is Gs=IsVs, Gs=20s+100.

Q: Chapter 3, Problem 3.065 Find I, in the network in the figure using mesh analysis. 6 kN 4 kN 6 V 6 k...

A:

Q: Problem 3. Solve the following simultaneous equations using determinants: 3x – 4y = 12 7x +5y = 6.5

A: Given data : 3x-4y=127x+5y=6.5

Q: Will a 6HP power rated equipment work if it is connected to a wire size no. 8? Voltage source= 240 v...

A: Will a 6HP power rated equipment work if it is connected to a wire size no. 8? Given, Voltage source...

Q: a. For the circuit shown below, load resistance is 180 ohm, determine load voltage, the resistance V...

A:

Q: Explain, with reasons, whether the LTIC systems described by the following equations are (i) stable ...

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.