NOTE: 1 J = 1 N.m = 6. Using dimensional analysis, show how 0.082057 mol. K Significant figures note: the last digit on both values has been rounded. 1 kg.m² دی , and L 1 Pa = 1 • atm N m² is equal to 8.3145 or 1 kg m.s J mol - K

Q: T3097.00°C = AHvap (3097.00° C) = 6603 J/g Tm 1495.00°C fus AH (1495.00°C) 262.7 J/g = J Specific…

A: The mass of the solid cobalt sample = The initial temperature of solid cobalt = The final…

Q: Consider the reaction: 2CaH18 +2502- --> 16CO2 + 18H20 MW of C3H18 is 114.26g/mol How many mols of…

A: Given that, Mass of octane = 158.3 g  Moles of O2 = ?

Q: Chlorine is the active ingredient in most household bleach and is one of the most commonly used and…

A: An acid is classified as weak acid or strong acid depending on the dissociation that acid undergoes.…

Q: 4. A particular food contains only fat, carbohydrates and protein and has a total of 388 Calories.…

A: Total calories of food = 388 calories  Percent of carbohydrates = 40%  Percent of proteins = 25 %…

Q: A truck weighing 1869 kg uses natural gas as fuel. Natural gas is mainly methane, CH4, and though it…

A: (a) The combustion of methane occurs as, CH4(g) + 2O2(g) → CO2(g) + 2H2O(g) The maximum amount of…

Q: 6. The plot given below was constructed from data that was collected for the following reaction.…

A:

Q: In part 1 of this lab, you will be calculating A-H by conducting constant-pressure calorimetry…

A: Answer: When a m mass of a system gains Q heat and temperature change is ∆T then relation between…

Q: 1. Calculate the heat of combustion of propanol (C3H8 O) and the percent error in the following…

A: mass of water = density * volume = 1.00 g/ml = 100.0 ml = 100.0g  specific heat of water = 4.184 J/g…

Q: 2H₂O(0) H30¹(aq) + OH(aq) Kw=1.0 x 10-14 at 25 °C Kw = 5.5 x 10-14 at 50 °C Based on this data,…

A: The question is based on the concept of Le-chatlier principle.       It States that when a system at…

Q: The Ostwald process is used commercially to produce nitric acid, which is, in turn, used in many…

A: Given: mass of NH3 = 61.1 g mass of O2 = 61.1 g molar mass of NH3 = 17.031 g/mol molar mass of O2 =…

Q: Complete and balance ---Co2(CO3)3(s)+heat---> ---H2O(l)+---As2O5(s)---> ---NaClO3(s)+heat--->…

A: Introduction :- A chemical equation represents chemical reaction. A balanced chemical equation…

Q: Two of the most abundant noble gases in the Earth's atmosphere are Argon and Neon. Calculate the…

A: Given: The gases are argon (molar mass of 39.95 g/mol) and neon (molar mass of 20.18 g/mol).

Q: ARTING AMOUNT X How many moles of CH₁2 (cyclohexane) must be reacted according to the following…

A: Given: C6H12 l + 9O2 (g)→6CO2 (g) + 6 H2O(g)         ∆H°=-3919.4 kJ

Q: Calculate the theoretical volume yeild (In mL) of oxygen gas produced at STP conditions, when 0.920g…

A: Interpretation - To determine the theoretical volume yield of ( in mL ) of oxygen gas which is…

Q: QUESTION 5 What is the molar mass of a solid solute if 2.00g g of the solute is dissolved into 9.00g…

A:

Q: hp of methanol and 1-propanol are 1.331 and 1.387 respectively. Calculate the mole percentage of…

A: The mole percentage of a compound can be determined by the following relationship between refractive…

Q: The ingredients contained in grape Kool-Aid can be approximated as: water (H2O, density = 1.000…

A: Given: Volume of solution = 500 mL = 0.500 L                         (Since 1 L = 1000 mL) Mass of…

Q: excess

A: Given: Methane + Propane V = 122 mL T =  25⁰C and P = 1.0 atm Flue Gas: CO2 = 0.506 g.

Q: At 1 atm, how many moles of CO₂ are released by raising the temperature of 1 liter of water from…

A: The solubility of any gas in liquid is given by the Henry's law as,=> S = K P where S =…

Q: Which of the following statements is correct about isolated system? It can transfer heat only It can…

A:

Q: What is the sum of coefficients from the following reaction (both products and reactants)? X.5H2O +…

A: Coefficients are the numbers which are  used to balance  a chemical equations. It always placed in…

Q: Choose the incorrect statement Oa. A hygroscopic substance is one that picks up water from the air…

A: Option; b. The composition of the product in gravimetric analysis depends on its pressure.

Q: 2. To the solution at 100°C described in Problem 1d, an additional 15 g of water are added. The…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: B. Heat of neutralization for NaOH (aq) (AH(neut. NaOH(aq)) Mass NaOH = 1.022 g (From part 1) Moles…

A: Given:Part B:Part C:Calculate .The change in enthalpy that occurs when one mole of acid and one one…

Q: STARTING AMOUNT X How many moles of KCIO, solid must be reacted according to the following balanced…

A: Potassium chlorate decomposes into potassium chloride and oxygen. The equation for the balanced…

Q: Three alcohol solutions with varying concentrations were mixed together: Solution 1 is 160mL of…

A:

Q: 1.77 An Olympic-size pool is 50.0 m long and 25.0 m wide. (a) How many gallons of water (d = 1.0…

A: Q.(77) Answer: 1 gallon = 3.785 litre 1 ft = 30.48 cm Given, length of the pull = 50 m = 50 x 100 cm…

Q: Gaseous isobutane + Oxygen react to form carbon monoxide + liqid water.  delta Hr = __? Kj

A:

Q: On a hot day (or during a stressful exam!), your body produces liquid swea which then evaporates…

A: Physical change: In a physical change only the state of matter changes. In this change different…

Q: Gypsum is the hydrate of calcium sulfate, CaSO4 · 2 H2O.  It is the primary material in sheet rock,…

A: Molar mass of CaSO4.2H2O = Atomic mass of Ca + Atomic mass of S + 4 × Atomic mass of Oxygen + 2 [ 2…

Q: On analysis, a coal sample has the following composition by weight; C = 78%, O2 = 4%, S = 5%, and…

A:

Q: The following information is given for silver at 1 atm: Th=2212.00˚C Tm=961.00°C Specific heat solid…

A:

Q: 'cat' represnts HA 'mat' represents H3O+ 'rat' represents A-   Container(i) has 1 cat, 4 mat, 4…

A: Strong acids and strong bases are one which undergo complete dissociation to produce their ions.…

Q: Gypsum is the hydrate of calcium sulfate, CaSO4 · 2 H20. It is the primary material in sheet rock,…

A: Hydrated crystal contains certain number of water molecules. When hydrated crystal is heated these…

Q: Complete the following table. Round each of your answers to 3 significant digits. a small apple food…

A: The conversion of quantity from one unit system to another unit system is known as unit conversion.…

Q: a dry natural gas consists of (60 gm methane, 20gm ethane, 15,gm propane, 8 gm I. Butane, 4 gm…

A:

Q: What is the easiest process to get to the result?

A: To calculate limiting reagent divide the stoichiometry coefficient to the value of mole for each…

Q: 1. A sample containing a mixture of CuCl2(s) and KCl(s) with a mole fraction of 6.90% KCI was…

A: Masses of KCl and CuCl2 can be figure out by finding respective moles by correlated with chloride…

Q: Anna was asked to identify and explain if the equation CO2 (1)-CO2 (g) was an endothermic or…

A: Here in the given reaction, i.e. CO2(l)→CO2(g) The interpretation done by Anna is : The reaction is…

Q: Constanis | Periodic Table AHm =Eproducts nAH{ - Lreactants mAH? f reaction is on of the where m and…

A: We know that  Enthalpy : Enthalpy is sum of internal energy and product of pressure and volume.…

Q: Cyclopropane (CH2)3 was burned to carbon dioxide and liquid water, as represented by the equation…

A: Answer:- This question is answered by using the simple concept of Hess law of constant heat…

Q: What is the sum of coefficients from the following reaction (both products and reactants)? X.5H2O +…

A: Coefficients are  numbers  that  are used to balance chemical equations. It always placed in front…

Q: A fuel is analyzed and found to contain 80% C, 14% H, 5% S and the balance being N. What is the HCV…

A: A numerical problem based on energy that is to be accomplished.

Q: The reaction N2(g) + 3H2(g) 2 2NH3(g) has K, = 6.9 × 105 at 25.0 °C. Calculate AG° for this reaction…

A:

Q: AT water (final - Tinitial) AT 713.087 X metal water p(metal) Approximate molar mass (MM) of metal…

A:

Q: Which equation would correctly calculate the enthalpy for the reaction: 2H₂ + O2(g) → 2H₂O(g)? a. ΔΗ…

A: 2H2 + O2(g) → 2H2O(g)?

Q: Ethylene (CH2CH2) is the starting point for a wide array of industrial chemical syntheses. For…

A:

Q: 714 oC, Keq = 1.78 for the reaction: SO2(g) + 1/2 O2(g)  SO3(g) (a) What is the value of Keq…

A:

Q: b) A 0.15 M aqueous solution of some weak acid (HA) has a pH of 4.55 at 25 °C. What is the AG° for…

A:

Mole Concept

Mole concept is a method to determine the amount of any substance that consists of some elemental particles using a grouping unit called ‘mole’. The mole concept enables one to handle the large amount of small elementary particles. The mole concept can be used in many calculations related to mole calculation, molar amount, mole ratio, and so on, which are significant in chemistry.