= noise power in Watts and dBm.

Q: lve for the Vrms (magnitude only) across the resistance if R2 = 1000 ohms and Xc = 2363 ohms. %3D HE…

A:

Q: The Upward wind and down wind velocity of a wind turbine are 12m/s and 5m/s respectively. What is…

A: Given: Downward wind velocity, Sd=5 m/s Upward wind velocity, Su=12 m/s

Q: 1) Suppose you have a sinusoidal input signal and wish at the output the signal should be same (in…

A:

Q: pothesis an expression for square wave generator with the help of circuit diagram

A: Working:-  The circuit given below is an astable multivibrator also known as a square wave…

Q: compare medium frequency to extremely high frequency include illustration/diagram

A: COMPARISON BETWEEN MEDIUM FREQUENCY AND EXTREMELY HIGH FREQUENCY: Inside a vacuum, all the…

Q: 30 40 IA 20 80 ww 16 40 VAB o Vo Figure 1

A:

Q: QY Anormalizad Simasoidnd Ssigml has a bandwith. I,000KHZ idn auerye Power is lwatH. The Cte' lo Cos…

A: In this question we will find average power of modulated signal..

Q: Does Ohm's Law apply to an AC circuit containing an capacitor?

A: According to ohm's law, current through any passive linear element is proportional to the voltage…

Q: A voltage of 2500 is applied to an inductive circuit of impedance (5+j10)Q Determine circuit current…

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: 4. Design the network in the figure to have the following characteristics: BW - 500 Hz Qp = 30 i. i.…

A: It is Given that:BW=500 HzQP=30VCmax=1.8 V

Q: How to determine the current and the impedance as a function of the frequency?

A: As the circuit is not mentioned, so assume a series RLC circuit. Supply frequency is f. Inductive…

Q: 2. Sketch the waveform of vo. Indicate the maximum, minimum and average values.vipk =15V

A: Solve the problem

Q: In an electrical installation, the active power is 500 kW and the power factor is 65% (lagging). How…

A:

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: VAvg= 2V/pi VRMS=V/sqrt(2) Where V= peak voltage

Q: find apparent power of source.

A: Given circuit is -

Q: If A = 20260° and B= 5230°, find the products AB and BB".

A:

Q: Explain briefly why is the source (total) voltage almost the same as the voltage across the…

A:

Q: for 下e energy FiND Tellowing Synal ン(り- loe もろ0 the -ヒ loe くo

A:

Q: In a frequency modulating system, the frequency deviation constant k = 1 kHz/V. A sinusoidal…

A:

Q: what's the value of magnitude?

A: It is given that:

Q: From the data obtained in steps 6, 12 and 18, draw the voltage phasor diagram. 6- Using the digital…

A:

Q: Formulate Ybus matrix for the power network given in figur The relevant pu line admittances are…

A: We have been asked to formulate Ybus matrix of the power network shown in figure. The network has…

Q: Power factor is the ratio of True or Real power to

A:

Q: A solar panel has Voc = 21.5 V, Isc = 12 A/m“. Fill factor is 70 %. Solar radiation is 900 W/m. Then…

A: solar panel has Voc = 21.5 V, Isc = 12 A/m . Fill factor is 70 %. Solar radiation is 900 W/m^2. Then…

Q: 4. What is ripple factor of the Full-waverectifier? 5. What are the applications of arectifier? 6.…

A: 4.  The ripple factor for a full wave rectifier is= 0.482.

Q: What's RMS and it's average value in AC circuit? Usually which value we measure in AC circuit?

A: RMS: It stands for Root Mean Square. It is a way of expressing an AC quantity of voltage or current…

Q: For a second order system settling time is T, = 7 s and peak time is T, = 3 s. The location of poles…

A: Damping ratio is system parameter. It is represented by Zeta ζ For second order system dynamic…

Q: What is the power factor angle? a. -12 degrees b. 45 degrees c. -30 degrees d. -18 degrees

A: It is given that: p=4Pop=75 kWf=50 HzVl=440 V%η=95%Xs=2.5 ΩPin=78950 W

Q: What is the difference between an inductive load and a capacitive load of an alternating current…

A: The solution is given below

Q: Calculate the electric field intensity in mV/m. 20 km from a 1-kW source. How many decibels down…

A: Given, Range (r) = 20km, Pt = 1kw,  To calculate, Electric field intensity in mV/m, Calculate dB for…

Q: QY Anornalized Sinusoidnd sigm) has a bandlwit 1,000KHZ idn auerage Power is lwatt. The Cma' lo Cos…

A: In this question amplitude modulated signal is given....We have to find bandwidth and total power of…

Q: What is the frequency of the input signal if the measured capacitive reactance is equal to 28 Q.…

A:

Q: Channel 1 and Channel 2 Time (ms) Phase problem. In the above figure the time base is 1 ms/div, what…

A: Given: Time base=1ms/div

Solenoidal Vector Field

In Physics and Mathematics vector calculus attached to each point in a subset of space, there is an assignment of a vector in a field called a vector field.