110 V elleer ooooo found D₁ DA R₁ 10 ΚΩ www

Q: 14.3.22 Find i(t), t > 0, in the network shown in Fig. Pl4.3.22. t = 0 1Ω ig(1) +)12v www 2Ω 4 Ω 1F…

A: In this given circuit , we need to find i0(t). It's a 2nd order RLC circuit . Circuit :

Q: Question 1 Solve for the following. I(t), Vr (t), Vc(t). Ir(t)=Blank 1 A Vr(t)=Blank 2 V Vc(t)=Blank…

A:

Q: 4. If R=5K2 in series with 10ks potentiometer, C=0.0068 μF and Vs = 10V. What are the maximum and…

A:

Q: Vi C R Draw the output voltage waveform. Identify the function of the circuit.

A:

Q: 7. Given the voltage wave form below, plot ux (t) + determine the de value sr +4 53 Vs LA २० 10 Vs…

A:

Q: In regard to using analog signals with PLC's, what is a transmitter? converts physical variables to…

A: answer is A     A transmitter is a device that converts physical variables such as temperature,…

Q: t) = 5 sm (6283t) V + 10 mH 20 Oscilloscope Channel 1 Y(0) 1kQ Figure 2. Circuit with an inductance…

A:

Q: a d -j4 Ω b 20 Ω j60 Ω 10 Ω d 63.2 Ω j2.4 Ω C -j20 Ω

A:

Q: Using loop analysis, find V, in the network in Fig. P3.2.22. - 2 ΚΩ 2 ΚΩ ww 4 mA +)ον Μ 31 ΚΩ 31 ΚΩ…

A:

Q: QUESTION 1 Find the transfer function X(s)/F(s). F(s) + 1 s²+ 18s +80 1 s2+12s 8 1 s2-18s+80 1 s²+12…

A:

Q: A three-phase transmission line is spaced on cross bars as shown. Make the calculations with respect…

A: In  this question We need to determine the GMR, GMD and inductance of the 3 phase.  We know 1mile =…

Q: Find Zal in the four-way power divider circuit in Figure P6 Assume each element is 152. شوه b O 1 w…

A:

Q: How much resistance is required to limit the current to 1.5 mA if the potential drop across the…

A:

Q: Z = -3i  find polar form (in radians)

A: To convert a complex number from rectangular form to polar form, we use the following formulas:…

Q: Convert this RS latch, to a D latch with an enable port, using only NAND gates and NOT gates, do not…

A: Given:

Q: Part b. what is the power consumption of the resistor?  Part c. what is the generated active and…

A:

Q: Which is more dangerous-shock due to AC or DC?

A: Both AC (alternating current) and DC (direct current) can be dangerous and potentially lethal if…

Q: A system is described by the following differential equation: d²x dt² +10- +20x=1 dx dt with the…

A: Given differential equation is as follows.

Q: 1. Determine the peak voltage and the peak power delivered to R, in the following figure: 115 Vrms O…

A:

Q: C R Draw the output voltage waveform. Identify the function of the circuit.

A:

Q: Using the partial fraction expansion method, find the inverse of the following z-transforms: 1 a.…

A: Given: X(z)=1z2-0.3z-0.24, To find: Inverse z-transform using partial fraction expansion method.…

Q: Circuits What is the total resistance if all resistors have 8Ω resistance?

A: In this question we need to find the total resistance of the given circuit across the two terminal .

Q: Why do we use starter for a DC motor?

A:

Q: What capacitance value is required for each of the varactors in the following figure to produce a…

A:

Q: The Fourier Sine transform of f(x) Fs [f](z) = The Fourier Cosine transform of f(x) Fc[f](z) = f(x)…

A:

Q: 3.4 For the signal presented below, find: (a) the half power bandwidth; (b) the half voltage…

A:

Q: ↓ 3 0 3 0 3 -3 -1 0 8. The sequence x[n] is 0 -3 0 -1 (the arrow indicates the position n = = 0) The…

A: Given: A Discrete Time sequence,  x[n]={. . . . . , 0, -3, 0, -1, -1, 3, 0, 3, 0, 3, -3, -1, 0, . .…

Q: Calculate Vth

A:

Q: A three-phase cage induction motor is started by direct-on-line (DOL) switching at the rated…

A: Given: Three phase cage induction motor Started by Direct on line method, Starting current-…

Q: What is the inductive reactance of a single-phase motor if the line voltage is 220 V, the line…

A: Given  Line voltage equal to 220 volts Line current equal to 15 amps Resistance of the motor winding…

Q: Normal telephone cable is a type of ________

A: An electrical cable, or simply cable, is used to transmit electrical power from one point to…

Q: 0 V₁ Vm 72 T t + V₁ Hu R + 19

A:

Q: Consider x(t) to be a periodic signal with a period of 4 seconds described over one period as…

A: Given: A signal x(t) expressed over a period, with T=4,  x(t)=3-t , 0<t<4, To do: To represent…

Q: 2. Given the following circuit: R1 5kQ V1 12V R2 10kQ R3 2KQ Load RL 1kQ A. Solve using Thevenin…

A: For this circuit , new need to find thevenin theorem, Norton theorem and ohms law . In thevenin…

Q: 3. Use many decimal places to get accurate answers. (a) Compute Vour exactly, given that: R₁ R₂ R3 =…

A: In this question We need to calculate the output voltage Vout   We are solving this problems using…

Q: 0 Vm T 2 T + Vi 15 - R +

A: Assuming ideal diode, diode will conduct if vi>v and if vi<v diode will be off.

Q: Point charges q and Q are positioned as shown. If q = -3.0 nC, Q = +4.0 nC, a = 4.0 m, and b = 3.0…

A:

Q: Create the Diode Characteristic Curve for this data values. Diode Voltage (VD) Diode Current (ID)…

A: Given,  Diode voltage, VD (in volts) Diode current, ID (in Amperes) 1.374 8.626 1.279 6.721…

Q: Figure P.4.3-3 4.3-3 For the AM signal with m(t) shown in Fig. P4.3-3 and μ = 0.75: (a) Find the…

A:

Q: Design the power supply using diode components. This power supply sholud have 2 outputs. 12Vdc and…

A: To design: The power supply using diode components. This power supply sholud have 2 outputs. 12Vdc…

Q: Find The RMS Vlaue And average value of the periodic waveform using The laws of integration are…

A: Note: When two or more than two signals are added then to find RMS/ Average of given signal first…

Q: Determine the pull down network of the given circuit and solve for the logic equation.

A: We need to draw the pull down network of the given circuit and need to determine the logic equation.

Q: Determine the impedance of the system and with the value of the impedance of the Zline, calculate…

A: Given a power system diagram To determine the impedance of the system and with the value of the…

Q: Resistors are labeled 100 Ω. In fact, the actual resistances are uniformly distributed on the…

A: In this question We need to determine the standard deviation of the resistance.  We know Standard…

Q: In the circuit shown in (Eigure 1), C₁-1.2 µF, C₂-2.5 μF, C₁-2.5 μF, and a voltage Vos-24 V is…

A:

Q: Q1 (b) (c) Write down Maxwell's equations in differential form. Show how these equations can be…

A:

Q: Your company is considering the installation of a 2 MW wind turbine with a rotor diameter of 90 m in…

A: Given: 2 MW wind turbine with a rotor diameter of 90 m in a location with average wind v = 8.5 m/s.…

Q: Example 3. Determine v for the network of Figure 6. Example 4. Repeat Example 3 using Silicon diode.…

A: As per Bartleby's guidelines, only 1 question can be solved at a time. Please send other questions…

Q: Find the current flowing through each resistor using: KIRCHHOFFS LAWS

A: I am solving the above circuit using KCL technique.voltages are obtained. And then using voltages…

Q: : (a): Find the value of a resistor where the resistivity is 209.m, L-10cm and A-50cm

A: a) In this given question , Given data Resistivity  =20 ohm.m Length L=10cm. Area A=50cm2 We need to…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.