Need asap. Please input the right formulation and solution. Provide explanation thank you. Answer on the book: 1.05 m. Problem:A rectangular channel 6 m wide has a depth of 1 m flowing with a mean velocity of 0.75 m/s. Determine the height of a rectangular suppressed weir that will increase the depth of water in the channel to 1.60 m.

Q: nook gage set to measure water depths between 2.0 and 2.75 m. What

A: Given:- flow rates=2.0 and 6.0m3/s measure water depths=2.0 and 2.75m To find:- Y

Q: A rectangular reservoir with dimensions 3.30m and 2.98 discharges water through a suppressed weir…

A: Given:- Dimensions of rectangular reservoir Length = 3.30 m Breadth = 2.98 m Depth of flow over weir…

Q: Q2(a) A river discharges flow at 2 m^3/s/m at depth of 1.1 m. A 0.25 m high broad-crested weir is…

A: Schematic diagram of the given problem:

Q: Determine the critical depth f

A: Given: A rectangular channel having Discharge, Q=200 m3/s  width, B=10 m   To find Critical depth,…

Q: O A rectangular channel 1.30 wide carries 1.10 m/s of water at a depth of 0.85 m. If a 30-cm wide…

A: Equating specific energy of channel at both section to get elevation of water surface

Q: Water flows uniformly with a flow rate of 10 m'/s in a long rectangular open channel of 3.0 m width,…

A: Q =10m3/s

Q: A full width sharp-crested weir with a weir height of P= 0.54 m was installed in a 0.77-m…

A:

Q: A trapezoidal channel with a bottom width of 10 m carries a flow of 1000 m/s. The side slope z = 2,…

A: Aside from the perplexing number related we do to observe that best cross part of a channel for an…

Q: Q7: A suppressed rectangular weir is to be built across a 4.5 m channel width to measure a flow rate…

A: width of channel =4.5mflow=1.2maximum water depth=1.2mFINDthe

Q: Last two digit 30

A: yn=1m R=yn=1m ( for wide rectangular channel)

Q: This problem refers to the sketch shown in Figure 2. If the discharge in the channel (n = 0.028) is…

A: Manning coefficient (n) = 0.028Discharge (Q) = 6 m3/sec Depth of flow (y) = 1.8m Maximum velocity…

Q: What is the depth of the flow (m) in a circular channel of diameter 2.0 m for the maximum velocity?

A: given dia of circular channel-D= 2 m

Q: d. Depth of water above the weir if P = 1.2m. dc d NSWER: a) Cw= 0.445, Q = 34.95m³/sec b) dc =…

A:

Q: 7. The head of water over a rectangular weir is 26 cm. The length of the crest of the weir end…

A: To find discharge using Francis formula

Q: (B) In a rectangular channel, water flows under the partially opened sluice gate. If the water has…

A: step 1-

Q: End View Water Flow H B H= head or height of water the weir P= height of weir from bottom of channel…

A:

Q: For a rectangular channel with depth 1.2 m and 1.8m wide S=0.002 and n=0.012 ,what would be the…

A:

Q: Water is flowing at a depth of 5 ft with a velocity of 4 ft/s in a triangular channel with…

A: Given :Triangular channel,y = Depth of flow = 5 ftv = Velocity of flow = 4 ft/sn1 = Side slope =…

Q: b) The screw-down vertical gate G of width b installed at a stormwater channel (Figure 2) is…

A: solution: Given: Q=25m3/s b= 4m Yu=6m Fgd=500kN Force by moment Equation: F=γ.Q.Vx The above…

Q: s to discharge 10.125 m3 /s of water onto an open  channel. The weir factor Cw = 1.88. To what…

A: L=7.5mQ=10.125m3sCw=1.88d=1.8

Q: A. Design a trapezoidal channel to carry a discharge of 10.5 m^3/s. The bottom slop of the channel…

A:

Q: 1.Water flows through a rectangular sharp-crested weir with a channel width of 2 m. The channel…

A: The given data is: Width of channel, B=2 m Channel depth, P=1 m (Height of weir plate) Head of…

Q: Question A rectangular, sharp crested weir with end contractions is 1.85m long. How high should it…

A:

Q: 1. Dikes are to be installed on both channel banks of the 1.2 km long river section. The river width…

A: length of river -1.2 km Width of river - 60 m Angle - 10 degrees To determine- numbers of dikes…

Q: A rectangular channel is 4 m wide, and it reduces to 2 m through a hydraulic structure. Assuring the…

A: The specific energy at the constriction is given as 6 m. Assuming choking occurs, we can use the…

Q: A rectangular open channel 6m wide has a depth of 1m of water flowing with a mean velocity of 0.75…

A:

Q: Water flows through a parabolic weir that is 2m deep and 2m wide at the top under a constant head of…

A: Step 1

Q: 1. A channel of width 5m has a sluice gate as shown below, which forces the upstream flow to a deep…

A: step 1-

Q: Answer only that first question thanks. A rectangular canal 3.2 m wide and 1.2 m deep has a full…

A: The objective of the question is to find the slope of the channel bed of a rectangular canal given…

Q: Water flows through a V-notch weir in a channel 2 m wide. The channel depth is 1 m with a weir head…

A:

Q: b) The normal depth of flow in a 5.0 m wide rectangular channel shown in Figure 3 below is 1.0 m.…

A:

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.