n AC generator requires 225J of mechanical energy per second to produce 175W of effective power. a. What is the efficiency of the generator? b. If the total resistance in the wire in the generator is 15.0 Omega, then what is the maximum current produced? If the average power dissipated by an electric light is 150W, what is the maximum power?

Q: onsider a series RC circuit as in the figure below for which R = 8.00 MΩ, C = 3.00 µF, and  = 34.0…

A:

Q: A 72 Ohm Coil of Wire Is Connected in Series with An Adjustable Resistor (rheostat) Whose Resistance…

A: Given that-Resistance, R= 72 ohmVoltage, V= 115 VoltPower, P= 90 WattWe know that-Power of the coil,…

Q: The “power cube” transformer for a portable CD player has an output of 4.5 V and 600 mA (both rms)…

A:

Q: Consider a series RC circuit as in the figure below for which R = 9.00 MQ, C = 9.00 µF, and Ɛ = 28.0…

A:

Q: The generator at a large power plant has an output of 1,800,000 W at 30,000 V. a. If it were a DC…

A:

Q: 6. A resistor with a resistance of 10 ohms is connected in series with a capacitor of 50 microFarad…

A:

Q: n the RC circuit shown in figure 2, the switch is closed at time t = 0. If the resistance and…

A: Given, Resistance R = 1 Ω Capacitance C = 5µF the initial charge on the capacitor is zero.

Q: In a circuit, a parallel combination of two 20-Ω and one 10-Ω resistors is connected in series with…

A: Given: The resistance is parallel is R1=20 Ω. The resistance connected parallel is R2=10 Ω. The…

Q: In the circuit diagram R1 = 5R and R2 = 15R, where R = 24 Ω. The power dissipated in resistor 2 is P…

A: Current in the circuit P2=I2R2I=P2R2=3.7 W15×24 Ω=0.1013 A

Q: 3. In a series RL Circuit, L = 40H, R = 100 ohms, and E = 200V. Assume the initial current is zero.…

A: Kirchhoff's voltage law: According to this law, the total voltage applied across a circuit is equal…

Q: A 200 Ω resistor is connected in series with a 4.00 μF capacitor and an ac source. The voltage…

A: We have a series RC circuit with resistor R=200 ohm and capacitance C=4 uF connected to an AC…

Q: 79. A series RL circuit has two resistors and two inductors. The resistors dissipate 7 W and 12 W.…

A: The objective of the question is to find the current flowing through a series RL circuit given the…

Q: A 90 mH inductor carries a current that varies with time according to… i(t) = t2+6t  (in A with t in…

A: Given that, The inductance of the inductor, L = 90 mH Current, i(t)=t2+6t We need to find the…

Q: Consider following circuit with R1 = 63 Ω, R2 = 12 Ω, R3 = 63 / 10 Ω, R4 = 12/10 Ω and and ξ=12 V…

A:

Q: CH1 (Yellow) Settings Volts/Div: 50V Time/Div: 5ms Probe Setting: X1 Determine: a. CH1 Peak Voltage…

A: Disclaimer: “Since you have asked posted a question with multiple sub-parts, we will solve the first…

Q: a. Find the frequency of oscillation of the circuit. b. What are the maximum values of charge on the…

A: Given data: The emf of the battery is: V = 12 V The inductance is: L = 2.81 mH The capacitance of…

Q: Consider following circuit with R1 = 60 Ω, R2 = 18 Ω, R3 = 60 / 10 Ω, R4 = 18/10 Ω and and ξ=18 V…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: capacitor is innitialy uncharged

A:

Q: 1. For the given circuit in Figure 5.2, find the open circuit voltage VTH and the short circuit…

A: 1. Applying the voltage division rule , The open circuit voltage is given by: Vth=400×200200+50=320…

Q: 1. A small water-heating coil is submerged in a container with 200g of water and 100g of ice,…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: It takes 2.67 ms for the current in an LR circuit to increase from zero to 0.80 its maximum value.…

A:

Q: An ac generator has 12 turns of wire of area 0.08 m2. The loop rotates in a magnetic field of 0.3 T…

A: As per our guidelines, we are supposed to answer only first one question in case of multiple…

Q: a. What is the voltage output (in V) of a transformer used for rechargeable flashlight batteries, if…

A:

Q: Part A An 2200 W arc welder is connected to a 660-Vrms ac line. Calculate the peak voltage. Express…

A:

Q: 14. The average power supplied to the circuit shown passes through a maximum when which one of the…

A: In this problem, it is asking about the average power.

Q: 3.00 12.0V- 6.00 3 6.00 A. The total resistance of the "mini" parallel circuit is Ohms. Ohms. B. The…

A:

Q: a. Consider the current configuration shown below. What is the magnitude of the cur- rent in the…

A:

Q: For the circuit shown,a. What is the resonance frequency?b. At resonance, what is the peak current…

A:

Q: What is the peak current through a 374 W room heater that operates on 170 V AC power?

A:

Q: The generator at a large power plant has an output of 1,800,000 kw at 30,000 v. a. If it were a DC…

A: We know that,P=VICurrent in the DC generator, I=PVGiven, P=1800000 kWattV=30000 Voltput all known…

Q: An electric device with effective power 530 mW is connected to an alternating source which gives…

A: We will answer the question by writing formula relating effective (also called RMS) power to…

Q: Discharging Capacitor: Kirchoff's loop rule applied to the discharging capacitor circuit gives 2- C…

A: The time constant of an RC circuit is the product of the resistance R and capacitance C,…

Q: If the instantaneous current of an AC is given as l(t) = 13A Sin(120nt), then the value of frequency…

A:

Q: In a RC circuit with power supply with an emf of 20 V. capacitance 3 uF, and resistance 1000 Q, the…

A: Given : Emf = 20 VCapacitance = 3 μF =3×10 -6 FResistance =1000 Ω

Q: A circuit consists of a 35 N resistor and a 580 mH inductor connected in series to a 12 V battery.…

A:

Q: A resistor is connected across an ac source as shown. For this circuit, what is the relationship…

A:

Q: The peak current through a capacitor is 2.0 A. What is the peak current ifa. The peak emf ε0 is…

A:

Q: A 15.0-Ω resistor is connected in series to a 120-V generator and two 10.0-Ω resistors that are…

A:

Q: A high intensity desk lamp is rated 28 W but requires on 11 V. It has a transformer which converts…

A:

Q: a. An LC circuit has a maximum current of 8.9 A. Find the current in the circuit when the…

A:

Q: A0.75 uF capacitor is connected across an AC generator that produces a peak voltage of 22 V. Part A…

A: The capacitance of the capacitor is given as The peak voltage of the generator is The frequency in…

Q: What is the maximum instantaneous power dissipated by a 3.0 -hp pump connected to a 240 – Vrms ac…

A:

Q: A transformer is a device that takes an input voltage and produces an output voltage that can be…

A:

Q: A capacitor has a potential difference of V0 = 375 V between the plates. When the switch S is…

A: Given:            V0= 375 V            R= 14.5 kohm             t= 10 sec            Vc= 1V

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.