I need the answer as soon as possible 4-20. An air-filled circular waveguide has a radius of 3 cm and is used as a resonator for TE01mode at 10 GHz by placing two perfectly conducting plates at its two ends. Determinethe minimum distance between the two end plates.bece abg ahoun

Given thatradius=3cmResosant frequency=10GHzTE01mode

Answered: mode at 10 GHz by placing two perfectly…

mode at 10 GHz by placing two perfectly conducting plates at its two ends. Determine the minimum distance between the two end plates.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Find the radiation efficiency of a six-turn small circular loop at f=300 MHz, the radius of the toop…

Q: 1. A 100-turn air-core circular loop of diameter 0.3 m is to be used as an antenna at 5 MHz. For…

Q: A paraboliloid reflector antenna is operating at 4 GHz. Diameter of the antenna aperture is 20m.…

A: For a paraboloid reflector antenna system, the beamwidth can be expressed as

Q: 4. A boat is equipped with a VHF marine radio which it uses to communicate with other nearby boats…

Q: A half-wavelength dipole antenna with antenna gain G=6 dBi is used in a WiFi modem, operating at…

A: An antenna is a piece of wire (straight/bend) through which the power tries to escape when the ends…

Q: Design an air-filled, rectangular wave guide, i.e.determine the width a and height b, for the…

A: For an air-filled rectangular wave guide,The operation conditions are,1. 800GHz frequency in the…

Q: A 150-m antenna, transmitting at 1.2 MHz (and therefore by ground wave), has an antenna current of 8…

A: Given,Transmitting ntenna height, hT=150mFrequency, f=1.2 MHzAntenna current, I=8ADistance,…

Q: For attenuation over reflecting surface environment, let a base station is transmitting to a mobile…

Q: A communication system, operating at 100 MHz, uses two identical 2 vertical s dipole antennas as…

Q: A 5.0 x 2.0 mm? air-filled rectangular waveguide is to operate below 85 GHz. Determine the number of…

A: Number of TE and TM modes are determined as shown below

Q: a) A parallel plate transmission line has plate separation d=1 cm, and is filled with teflon having…

A: (a) To obtain the maximum operating frequency such that only the TEM mode will propagate.…

Q: What is the gain of a Deep Space Network (DSN) 70m antenna at 9 GHz (efficiency of .65)?

A: According to the question we have to find the value of Gain.

Q: Determine the maximum spacing allowed for an equally-spaced linear array such that, for a beam scan…

Q: Q2/ In an air-filled rectangular waveguide, the cutoff frequency of a TE10 mode is 5 GHz, whereas…

Q: Evaluate the width of the frequency band around fo=29 GHz within which the reflectance of the radome…

A: General introduction of Radome and Reflectance. Radome is basically defined as the protective…

Q: Skample 1: Consider an antenna transmitting a power of low at goOMHz. Calculate the received signal…

Q: 8. What is the far-field of an antenna? a) The region where the shape of the antenna pattern is…

A: Far field The field is which is far from the antenna is known as a far-field. It is also known as…

Q: 4.59. A half-wavelength dipole is placed vertically on an infinite electric ground plane. Assuming…

A: Given that, A half-wavelength dipole is placed vertically on an infinite electric ground plane.…

Q: If the material between the ground plates of a 100 ohm strip line to be used at 12 GHz has a…

A: Attenuation constant of wave is given as α=ωμε21+σωε2-1 The wave number of wave is given as…

Q: Find the monostatic radar cross section of the following conducting objects in m² and dBsm at 5GHZ…

A: (a) Given frequency is = Diameter and radius of sphere is =

Q: 2.16 In an air-filled rectangular waveguide, a TE mode operating at 6 GHz has E, = 5 sin ) cos ()…

Q: An isotropic antenna is radiating evenly in the r–direction in free space. The total electric field…

A: Given information: The value of the electric field at 139 m,

Q: What will be the power gain of a parabolic antenna with 10 m diameter dish and a feed of 10 GHz?

A: The expression of power gain Gp for a parabolic antenna having a dish diameter of D is given as

Q: In an air-filled rectangular waveguide, a TE mode operating at 6 GHz has E, = 5 sin(2rx/a) cos(ry/b)…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: A rectugular air-filled copper waveguide with demension 2.28 cm x 1.01 cross section and 30.48 cm…

Q: If the critical frequency of ionosphere for vertical incidence is 20 MHz, then estimate the value of…

A: Given data: The value of the critical frequency of the ionosphere for vertical incidence is fc=20…

Q: b) Determine the length of quarter-wave printed monopole antenna for 2.4 GHz, 5.8 GHz and 10 GHz.…

A: A message signal is transferred from the sender to the receiver end. The signal is transmitted…

Q: Q3) A parabolic reflector antenna with 2 meters diameter is used as receiving antenna at 4 GHz.…

A: According to the question we have to calculate the diameter (D2) of another antenna in meter. Given…

Q: What is the free space loss, in dB, between two microwave parabolic antennas 38.0 kilometer apart…

A: Given: Two microwave parabolic antennasd=38 kmf=5 GHz

Q: :A rectangular waveguide dimension of a =2 cm and b= 1 cm with dielectric u, = 1, e, = 81 operates…

Q: AGILA satellite is located 36000 km above the earth’s surface. Assuming free space condition, what…

Q: Estimate the diameter of a paraboloidal reflector antenna required to produce null beamwidth of 10o…

A: In this case, the frequency of operation is 3 GHz. So, the value of the corresponding wavelength…

Q: 9. Ferromagnetic sphere with saturation magnetization M;=0.6 is placed in resonant cavity tuned to…

A: Given: Saturation magnetization of a Ferromagnetic sphere=0.6 Field at which resonant absorption is…

Q: A 37.4W transmitter at 86.7 MHz will be used to establish VHF communication. Determine the maximum…

Q: A grounded vertical antenna, fed at the bottom with an RF current of 32 Ampere at 1 MHz, produces a…

A: Given parameters are as follows Value of current I=32 A . Frequency f=1 MHz=1×106Hz Distance from…

Q: 5) Calculate the radiation resistance of λ/2, λ/4, λ/8 dipole in free space.

A: Given, Length of dipole antenna1 (L1)= λ/2 Length of dipole antenna1 (L2)= λ /4 Length of dipole…

Q: What will be first null beam width of a paraboloidal reflector antenna operating at a frequency of 4…

A: The frequency of the signal is given as:

Q: Please show all steps A parabolic dish antenna has a diameter of 5 meter, operating at 30 GHz…

A: Given, Parabolic dish antenna has Diameter (D) = 5 meter Operating frequency (f) = 30 GHz

Q: 1. Determine the following; (a) What is the wavelength of an 800-MHz signal? (b) What is the…

Q: b. Calculate power delivered to a receiver in a communication system consisting of two lossless…

A: Communication systems play a major role in connecting people. The transmitter is a device where…

Q: Determine the beamwidth and transmit and receive power gains of a parabolic antenna with the…

A: Given: Dish diameter D=2.5 mFrequency of operation f=4GHzEfficiency η=55%

Q: Q2 A parabolic dish antenna has a diameter of 5 meter, operating at 30 GHz frequency. a) What is the…

A: We need to find out effective area and power gain for given antenna

Q: A centre fed linear dipole antenna, three and half wavelength long, has a feed current of 15 A RMS.…

A: The rms electric field at some distance away from an antenna can be expressed as

Q: Q₁: Answer the following sentences with (True) or (False) then correct the false sentences: 1- 2 3-…

A: We need to tell about whether the given statement is true or false .

Q: 12.13 AK-band waveguide (1.067 cm X 0.533 cm) is filled by a dielectric material with ɛ, = 6.8. If…

A: We need to find out cut off frequency and phase velocity and waveguide wavelength

Q: 3.8 An earth station antenna has a circular aperture with a diameter of 6.5 m and an aperture…

Q: A hollow rectangular waveguide with cut-off frequency of 2.66 GHz is used at 3.7 GHz. Calculate the…

A: We need to find out guide wavelength phase velocity and guide propagation velocity.

Q: • An air-filled circular waveguide has a radius of 2 cm and is to carry and TMnp modes energy at a…

A: we have given An air−filled circular waveguide has a radius of 1.5 cmenergy at a frequency of 10…

Q: 5. Assume that the maximum skip distance for f=30 MHz is 3400 km. determine the virtual height and…

A: Given data, f = 30 MHz Maximum skip distance d= 3400 km αp=8500 km

Q: A parallel-plate waveguide is known to have a cutoff wavelength for the m= 1 TE and TM modes of 1 =…

A: Consider the wavelength for the m=1 For TM mode the first cut is, λcut-1=4.1 mm The operating…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

I need the answer as soon as possible

4-20. An air-filled circular waveguide has a radius of 3 cm and is used as a resonator for TE01
mode at 10 GHz by placing two perfectly conducting plates at its two ends. Determine
the minimum distance between the two end plates.
bece ab
g ahoun

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the cut-off wavelength of the TE03 mode in a rectangular waveguide filled with air and with a small side of 3 cm?
(a) A 1 MHz carrier with an amplitude of 1V is modulated by a 1 kHz signal with m=0.5. Sketch the voltage spectrum. (b) An additional 2 kHz signal modulates the carrier with m=0.2. Sketch the new spectrum.
Problem 4 to separate ITU channel 59 using a fiber Bragg grating (FBG) and an optical circulator. The FBG is made from a fiber with an effective index of refraction of the core of 1.48 at You are to implement a simple one-channel demultiplexer ITU channel 59. a.) Draw a diagram of the demultiplexer b.) Calculate the periodicity of the index of refraction modulation in the core of the FBG fiber
A 1-MHz carrier with an amplitude of 1 volt peak is modulated by a 1-kHz signal with m=0.5. Sketch the voltage spectrum. An additional 2-kHz signal modulates the carrier with m = 0.2. Sketch the voltage spectrum.
Estimate the grating period of a second-order DBR for a guided wave at 1.55 µm in a symmetric slab semiconductor waveguide where n = = 3.5 and n2 = 3.45.
Find the VSWR, if the reflection coefficient is 0.8
The TM11 mode propagates in a hollow circular waveguide with a radius of 1 cm. If the inside of the waveguide is filled with a material with a dielectric constant of εr=4, what radius must be in mm so that the cutoff frequency remains the same?
Calculate the TE10 cutoff frequency for a rectangular waveguide if the longer dimension of its cross section is 5 cm
A rectangular waveguide has a dimension of 3cm by 2 cm is used to transmit a signal of 8 GHz. Determine cutoff frequency under dominant mode.
Determine the minimum electron densities corresponding to critical frequencies of 2.5 MHz and 8.5 MHz.
Problem 5. We are transmitting our 12/4 APSK waveform with outer ring voltage 5 Volts and inner ring voltage = 2 Volts. The constellation ring ratio in dB is? a) 6.25 b) 7.959 c) 9.875 d) 9.945 e) 19.891
A rectangular waveguide has a dimension of (3X2) cm is used to transmit a signal of 9 GHz. Determine cutoff wavelength for dominant mode.