For attenuation over reflecting surface environment, let a base station is transmitting to a mobile station in free space, and let the distance between base station and mobile station is equal to 4Km, antenna gains are 6 dB and 0 dB for the base station and mobile station, respectively, antenna heights at the base station and mobile station are 2000 cm and 200 cm, respectively, and transmitter wavelength A is equal to 0.4 m. The free nath Iori ce nath loss in dR will be

For attenuation over reflecting surface environment, let a base station is transmitting to a mobile station in free space, and let the distance between base station and mobile station is equal to 4Km, antenna gains are 6 dB and 0 dB for the base station and mobile station, respectively, antenna heights at the base station and mobile station are 2000 cm and 200 cm, respectively, and transmitter wavelength A is equal to 0.4 m. The free nath Iori ce nath loss in dR will be

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

a rectangular air-filled copper waveguide with dimension 2.28 cm x 1.01 cm across section and 30.48 cm length is operated at 9.2 GHz with a dominant mode. Find a) cut off frequency b)guide wavelength c)phase velocity d) characteries impedance e) attenuattion in dB
b) A particular antenna has a VSWR of 2.4. Determine the following and, in each case, show full working: i) Reflection coefficient. Please transpose the equation for VSWR and show your working. ii) Calculate the mismatch efficiency of the antenna. Show your working.
Orientation of victim and electromagnetic-wave EMI. The rule that an antenna must be a few percent of a wavelength long to operate effectively becomes a problem with long-wave signals (below 3 MHz), where the wavelengths exceed 100 m. As a result, some radios receive only the magnetic field associ- ated with the radiated wave, because magnetic-field pickup devices can be much smaller than a wavelength and still operate reasonably well. One way this is done is with a type of antenna called a loopstick, which is basically a long cylindrical magnetic core inside a coil of wire. The loopstick antenna is sensitive only to the component of the magnetic field that is parallel to the axis
Q2. A circular copper waveguide has a radius of 0.6 cm and is filled with a Teflon having & 2.25 and tan 8-0.0002. Identify the first four propagating modes and their cutoff frequencies. For the dominant mode, calculate the total attenuation at 12 GHz.
Since b=2a=1 cm in a hollow rectangular waveguide, the operating frequency of the waveguide must be ........ GHz<f<......GHz for only the dominant mode to propagate?
1.) What is the reflection coefficient at the spectral point of reflection in the near- earth propagation model? 2.) When determining the best estimate of the power received in the near-earth model, when the free-space and near-earth received powers are nearly equal, what do you do to determine the best estimate of the received power? 3.) In the LOS propagation model how would you determine the geometric distance to the horizon from the transmit antenna? 4.) How much power (in mW) is received when a 1 GHz signal with a power density of 5 mW/m² is intercepted by an antenna having a gain of 10 dB? step by step and clear thanks
An attenuator can be made using a section of waveguide operating below cutoff, as shown in theaccompanying figure. If a = 2.286 cm and the operating frequency is 12 GHz, determine the requiredlength of the below-cutoff section of waveguide to achieve an attenuation of 100 dB between the inputand output guides. Ignore the effect of reflections at the step discontinuities.
3) Solve the cutoff frequency for the first mode and third mode of WR137 waveguide. TABLE 7.1 Some Standard Rectangular Waveguides Waveguide designation a (in) b (in) t (in) Seo (GHz) Frequency range (GHz) WR975 9.750 4.875 0.125 0.605 0.75-1.12 WR650 6.500 3.250 0.080 0.908 1.12-1.70 WR430 4.300 2.150 0.080 1.375 1.70-2.60 WR284 2.840 1.340 0.080 2.08 2.60-3.95 WR187 1.872 0.872 0.064 3.16 3.95-5.85 WR137 1.372 0.622 0.064 4.29 5.85-8.20 WR90 0.900 0.450 0.050 6.56 8.2-12.4 WR62 0.622 0.311 0.040 9.49 12.4-18
Calculate the guided intrinsic impedance at 20 GHz for the lowest-order mode of the rectangular waveguide with dimensions a=0.7 in and b=0.3 in. Take relative permittivity as 2.76. (a) 243.16 (b) 234.61 (c) 117.3 (d) 352
10. A piece of quarter wavelength transmission line is inserted between a load of 100ohm and another transmission line of Zo=50. Then, the characteristic impedance and length of the quarter wavelength transmission line at 1GHz are 70.71 ohm and 300mm 70.71 ohm and 50mm 70.71 ohm and 75mm None of them 50ohm and 75mm
An air filled rectangular waveguide with dimension a = 8.636 cm b=4.318 cm is fed by a 4 GHz carrier from a coaxial cable. Determine TM11 mode will propagate or not. If so, find phase velocity.
1GHz satellite antenna has an E-plane beam-width of 12º and on H-plane beam-width of 10°. The antenna conductivity and mismatch total loss -3db. Estimate the gain of antenna.