Inside the streamtube, the air has pressure of 1 atm, desity of 1.225 kg/m^3, and temperature of 288K. The velocity at the initial state is 230 m/s. What is the local pressure where the velocity is 350 m/s? The area at first state is 2 m^2 and the second state has an area of 1.5 m^2. NOTE: - Compressible Bernoulli's equation - Complete Solution and Units UP VOTING

Inside the streamtube, the air has pressure of 1 atm, desity of 1.225 kg/m^3, and temperature of 288K. The velocity at the initial state is 230 m/s. What is the local pressure where the velocity is 350 m/s? The area at first state is 2 m^2 and the second state has an area of 1.5 m^2. NOTE: - Compressible Bernoulli's equation - Complete Solution and Units UP VOTING

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Solution A 10 ft^3 tank contains gas at a pressure of 500 psia, temperature of 85℉ and a weight of 25 pounds. A part of the gas was discharged, and the temperature and pressure changed to 70℉ and 300 psia, respectively. Heat was applied and the temperature was back to 85℉. Find the volume in ft^3.
A piston moves with constant velocity U0 in a cylinder having radius R. A liquid having density leaves the open end with conical velocity proÖle V~ = V0(1-r/R)^k.Figure for problem 1.(a) If the exhaust port is closed, find the value of V0 in terms of U0. Be sure to define an appropriate control volume for solving this problem.(b) If V0 = U0, find the volume áow rate leaving through the exhaust port (in terms of U0 and R)
Q4: Water at 150C and 476.16 kPa has an internal energy (AU) of 631.66 kJ kg' and a specific volume (v) of 1.091 em'g". What is its enthalpy (AH)?
AN AUTOMOBILE TIRE CONTAINS 3730 cu. in. OF AIR AT 32 psig AND 800f. (a) What mass of air is in the tire? (b) In operation, the air temperature increases to 1450F. If the tire is inflexible, what is the resulting percentage increase in gage pressure? ( c) What mass of the 1450F air must be bled off to reduce the pressure back to its original value?
04/13/2021 For this exercise Study and Derive the Bernoulli equation starting with the application of Newton’s second law to a fluid particle.
In a car lift used in a service station, pressure is transmitted by an incompressible liquid from a small piston of circular cross section with a radius of r1 = 5.00 cm to a second piston of radius r2 = 15.0 cm. Calculate the minimum force that must be exerted on the smaller piston to lift a car weighing 13300 N. Solution Relevant givens (check as many as possible):
An incompressible and Newtonian fluid is confined between two horizontal plates separated by a distance h. The top plate is moving on the right side with a velocity ul and the bottom plate is moving in the left side with a velocity u2 (u1>u2). Find the velocity profile of the fluid by using NSE. Properly reduce the NSE and use appropriate boundary conditions. Ignore pressure drop.
3. A 0.8-lbm object travelling at 200 ft/sec enters a viscous liquid and is essentially brought to rest before it strikes the bottom. What is the increase in internal energy, taking the object and the liquid as the system? Neglect the potential energy change. Derive with the formula below, show the cancellation, explain the step by step and draw a free body diagram/figure. refer with this: PE1 + KE1 + U1 + WF1 + Q1 + W1 = PE2 + KE2 + U2 + WF2 + Q2 + W2 + E losses.
A Closed tank of water with Length, I = 20 ft Height, h = 10.45 ft %3D Width, w = 5.6 ft Pgage = 0 kPa at the top before acceleration is accelerating at an angle of 38° with respect to the horizontal, where the x component of the acceleration is parallel to that of the length of the tank at a rate of 6.35 ft/s² . If the tank is 76% %3D full, calculate the pressure at the bottom of the left side of the tank and the force acting at the top of the tank during acceleration. Take note that the tank is fixed such that it remains parallel to the horizontal during acceleration
Create the simulation model of the 3-tank system shown in Figure. S= 0,25 m2 SO=0,00065 m2 H=0,2 m Q1=0,008 m/s Q2-0,005m/s Simulate the course of the liquid level positions for different initial conditions and evaluate the steady state values. Case a: Case c: h10=1,2m h20=1m h30-0,7m Case b: h10-0,8m h20=1m h10-1,2m h20-1m h30=0,7m h30-0,1m
Consider a geyser that shoots water to a height of 28 m into the air.Density of water, rho = 1000 kg m-3, acceleration due to gravity, g = 9.81 ms-1, atmospheric pressure, Patm = 101250 Pa. How fast is the water traveling when it emerges from the ground, If the water originates in a chamber 44 m below the ground, what isthe pressure there (consider there is NO friction within the chamberand that the water can be considered to be stationary)?
A fluid changes state from p1 = 105 kPaa, V1 = 0.558 m3 to p2 = 690 kPaa, V2 = 0.057 m3; the internal energy U is the same for both states. Find the change in enthalpy. (whole number)