Q2- Once it has been started by sufficient suction, the siphon in the Fig. will run continuously as long as reservoir fluid available. Using Bernoulli's equation with no losses, show (a) that the exit velocity V2 depends only on gravity and the distance H and (b) that the lowest vacuum pressure occurs at point 3 and depends on the distance L+H

Q2- Once it has been started by sufficient suction, the siphon in the Fig. will run continuously as long as reservoir fluid available. Using Bernoulli's equation with no losses, show (a) that the exit velocity V2 depends only on gravity and the distance H and (b) that the lowest vacuum pressure occurs at point 3 and depends on the distance L+H

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

kg Water (p = 1000- -) flows through the elbow below. The diameter of both the inlet and outlet is 1.1 cm, and the velocity through the nozzle is V =4.5 m/s. The outlet m³ has an angle of 0 =15 degrees. The water is at a pressure of 29 kPa (gauge). Find the magnitude of the force on the elbow. 0 V
. Indiana Jones needs to ascend a high-rise building. There is a large hose filled with pressurized water hanging down from the building top. He builds a square platform and mounts four 4-cm-diamter nozzles pointing down at each corner. By connecting hose branches, a water jet can be produced from each nozzle. Jones, the platform, and the nozzles have a combined mass of 150 kg. Determine the minimum water jet velocity needed to raise the system.
setup a Bernoulli's equation in head form that can be used to determine the pump power requirement. Which two locations are you selecting to set up the Bernoulli's equation? What are the state (elevation h, pressure P, velocity u) as the two locations?
solve below
Make it Simple.
Q4. Water flows steadily through 45° reducing elbow, located on a horizontal plane. V1 = 1.5 m/s, P1 = 4.6 m2. Determine the flow rate. Determine the flow velocity at the narrow section. Determine the dynamic force of the water flow on the elbow. 1.5 m/s 30 сm 20 cm
4
Water with density 1000 kg/s enters a lawn sprinkler which is rotating at 500 RPM through its base at the steady rate of 1 L/s as shown. The exit area of each of the two nozzles is 30 mm^2 and the flow leaving each nozzle is in the tangential direction. The radius, r, from the axis of rotation to the centerline of each nozzle is 157 mm. The absolute velocity out of each nozzle in m/s is: Select one: a. 25.11 Nozzle exit area = 30 mm² Control volume b. 8.45 c. 83.33 Flow out Flow out Tshaft
Find the location of the stagnation point for the flow due to a vortex +I at (2a, 0) and a vortex -25 at (-2a, 0).
A jet of air having velocity V₁ and cross-sectional area A₁ strikes an inclined plate as shown in the figure. Neglect any effects of viscosity. V₁ (a) Find V₂ and V3 in terms of V₁. Note that the pressure is patm everywhere. (b) Because viscous effects are negligible, there is no way for the air to exert a force on the plate in the tangential (z) direction. Using the coordinate system in the figure, find A₂ and A3 in terms of A₁ and 0. (c) For V₁ = 50 m/s, A₁ = 5 x 10-4 m², and 0 = 60°, find the force required to hold the plate in place. Neglect the weight of the plate. Recall that pair = 1.225 kg/m³.
Referring to the image of the dam, assume that the resulting flow through the pipe is 1000 ft/min and that the head loss in the pipe is 5 ft. (a) What is the drop in the head at the turbine? (b) 550 ft-lb/s. (a) What is the power consumed by the turbine? Keep in mind that 1 hp: (c) supplied to the system? To convert to relevant units, use 1 hp = 746 W. (b) If the efficiency of the turbine is 60%, what is the resulting power