2) Aşağıdaki şekilde hat gerilimi 50 Hz'de 34.5 kV rms’dir. Toplam yük 0.98 ileri güç katsayısınasahip olacak şekilde C kondansatör değerlerini hesaplayınız.(In the figure below, the line voltage is 34.5 kV rms at 50 Hz. Calculate the values of capacitor C sothat the total charge has a leading power factor of 0.98.)3 faz dengelikaynak20 MVA0.75 geri

The solution can be achieved as follows.

Answered: (In the figure below, the line voltage…

(In the figure below, the line voltage is 34.5 kV rms at 50 Hz. Calculate the values of capacitor C so that the total charge has a leading power factor of 0.98.)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 2. Find the rms value of Hhe current wareform vhown below. i, A 10 T- 88- 4 t, s 14

Q: An inductor and a resistor are connected in series with a function generator. The voltage across the…

A: In series circuit of resistor and inductor, the expression for magnitude of RMS voltage supplied…

Q: The voltage waveform during the first half cycle are from t = 0 to t = 0.01 increases linearly from…

Q: Determine the rms current I as shown in figure 1. Source voltage is eady in RMS value (Answer must…

Q: A supply voltage has a mean value of 150V. Determine its maximum value and its rms value.

A: Given, Mean voltage of a supply, Vavg=150 V.

Q: A voltage of 2500 is applied to an inductive circuit of impedance (5+j10)Q Determine circuit current…

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: Find the RMS value of V-100 sin(377t+76) V

A: Equation of voltage is given as, vt=100sin377t+760 V.

Q: The current that varies sinusoidally with time. Blank 1

A: Current is defined as rate of flow of electron in a conductor.

Q: Mean value of an AC supply is 270 volts. The value of RMS voltage is:

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: VAvg= 2V/pi VRMS=V/sqrt(2) Where V= peak voltage

Q: FIND THAT A SINUSOIDAL ALTERNATIVE VOLTAGE WITH A-350 VOLT AVERAGE VALUE WILL Reach 250 VOLT INSTANT…

Q: what will be the power factor, if the inductive reactance is equal to the capacitive reactance of 20…

A: Given: Inductive reactance is equal to capacitive reactance of 20 Ω XL=XC=20 Ω The resistance is 20…

Q: v(t)' +20V A1 12 6. 10 11 -5v

Q: Calculate the rms value of a sinusoidal current of maximum value 20A.

Q: Find the RMS current from 30⁰ to 180⁰ at Im = 10 Amperes

Q: Draw rough sketches showing the following: a. A current which lags the voltage by 60°. b. A current…

A: Phasors rotates in anti clockwise. Current lags the voltage means current comes after voltage.

Q: A sinusoidal voltage has a peak value of 340 V. Calculate its mean and r.m.s. values, correct to 3…

A: Given information is shown below:

Q: Problem 3 Compute the average and rms voltage of the waveform shown in the figure below. 6 V 4 ms 4…

A: The given waveform is:

Q: What is value of RMS current if voltage is 10sin(100t) Volt and load is 10mH inductor.

A: v(t)= 10sin (100t) Volt XL=jωL XL=j(100)(0.01) Ω XL=j1 Ω

Q: The source in the circuit shown is a sinusoidal source. The supply voltages across various elements…

A: Given a series RLC circuit, Voltages across each elements are as, Resistance voltage, VR=3 V…

Q: If there is reactive power associated with a circuit element we can say a) That said element is…

A: Real Power: The power dissipated from the supply is utilized by the resistive nature of the circuit.…

Q: iii) A sine waveform with following specifications. RMS voltage 161.4V Time for ten cycles 0.02s…

A: Given values are =

Q: A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and…

Q: What is the difference between an inductive load and a capacitive load of an alternating current…

A: The solution is given below

Q: 6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll

A: In this question, We need to determine the peak voltage Across the load and average power P? We…

Q: A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power…

A: The power factor for series RL circuit can be written as, p.f=cosθwhere…

Q: Please draw the voltage and current curves versus ωt for capacitor with sinusoidal AC power supply.…

A: Consider that V=IR follows for every circuit at every frequency. The ratio of the voltage and the…

Q: 244. The apparent power drawn by an a.c. circuit is 20 kVA and reactive power is 12 kVA. The real…

A: Given, Apparent power, S=20 kVA. Reactive power, Q=12 kVAR. Real power, P=?

Q: Find the rms value of the given waveform

A: Given waveform,

Q: Tor F AC voltages and current listed on ac products are generally rms values.

A: We need to about the given statement is true or false.

Q: The below figure shows the waveform of the voltage and current in a purcly inductive AC circuit.…

A: Consider the given waveform.

Q: A series circuit consisting of 17ohm resistance and 20mH inductane is connected across a 220V(RMS)…

A: The solution is given below

Q: Reactive Power Compensation Regulation, capacitive reactive power should not exceed what percent of…

A: Reactive Power Compensation Since the major load in power systems is an inductive load that…

Q: An ac voltage represents by a sinusoidal waveform as shown in Figure 6 below. a) Define: i. The…

A: In this question we will find time period and frequency...

Q: QUESTION 2 The peak-to-peak voltage is 40V, its rms voltage is 14.1 V 11.4V 13.3V 12.3 V

A: The peak-to-peak voltage, VP-P=40 V

Q: 5.) Calculate the inductance or capacitance in series for the impedance 502-60° ohms. Assume the…

A: We need to find out the value of capacitor

Question

2) Aşağıdaki şekilde hat gerilimi 50 Hz'de 34.5 kV rms’dir. Toplam yük 0.98 ileri güç katsayısına
sahip olacak şekilde C kondansatör değerlerini hesaplayınız.
(In the figure below, the line voltage is 34.5 kV rms at 50 Hz. Calculate the values of capacitor C so
that the total charge has a leading power factor of 0.98.)
3 faz dengeli
kaynak
20 MVA
0.75 geri

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the average and rms value of the waveform shown in Figure-2. Em 3x ot- Figure-2
6. Determine the rms current I as shown in figure 1. Source voltage is already in RMS value (Answer must be in polar form and should be in 4 decimal places). -j4 N j1.5 A B 4 0 A 200/30° V -j2 N: jIN Figure 1.
Get the RMS and average value of the voltage. Frequency is 60 Hz. Please write properly the solution. Make sure to recheck.
Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average and RMS for both currents. ot io Vs = 220V a = 220° + ot 1002
What is the ripple factor of a DC signal having ripple voltage of 2 V and a DC voltage of 50 V? Answer in percentage % O 8% O 1.2% O 2.83% O 4.0%
The capacitance between the two conductor is 255 Farad per meter, then the Capacitance between line to ground in farad per meter is Numerical formula
Supply voltage has an average value of 200 V. Its RMS value is RMS value, Vrms = %3D
Design a circuit limit a 25 V rms sinusoidal voltage to a maximum positive amplitude of 18 V of using 12 V dc source.
Draw roughly the arc characteristics in alternating currents with a frequency of 50 Hz and 500 Hz, explain briefly
Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average and RMS for both currents. a = 50° T1 50 2 ot Vs = 300 sin 100rt T2 ot
Computed Rms value (V) 100 E1:A to B E2:A to C 1502 E3:A to D 220. E4:A to F 220 Vac E5:A to G 330 E6:F to G E7:B to C 470 E8:C to D 6802 E9:D to E E10:E to F
Identify the following on the blank