In the figure below determine the water level over the pipe (H) that should be keep in the tank in order to produce a volumetric flow rate of 40 L/s. Consider a total length of 45m of 100 mm internal diameter commercial steel (new) pipe. Elbows are threaded and the water is being discharged to the atmosphere. Take water density as 1000 kg/m3 and water viscosity as 10-3kg/m.s H. valve, k,-5 15m

In the figure below determine the water level over the pipe (H) that should be keep in the tank in order to produce a volumetric flow rate of 40 L/s. Consider a total length of 45m of 100 mm internal diameter commercial steel (new) pipe. Elbows are threaded and the water is being discharged to the atmosphere. Take water density as 1000 kg/m3 and water viscosity as 10-3kg/m.s H. valve, k,-5 15m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A column has the cross section shown in Fig. P.14.25 and carries a compressive load P parallel to its longitudinal axis. If the failure stresses of the material of the column are 4 and 22 N/mm² in simple tension and compression, respectively, determine the maximum allowable value of P using the maximum normal stress theory. Ans. 634.9 kN.
! Fill the blanks with correct answer for each of the following: 4- Any member with two nodes subjected to many types of loads can be classified as 5- Roof thickness specified at dialog box to define the material properties is available under element. button. ......
Please show your solution on a paper with FBD
Identify the types of rudders
Calculate the polar second moment of inertia, J of the steel column with cross-section given in Figure Q4 (b).
Q- To complement the construction of a wall or to connect a wall to be constructed with a previously constructed wall specially If the wall is to be connected vertically when It is left without completion, and each row is an apostate from the row under of it about a quarter or half a brick. The wall is left before it is completed, it is left in the place where each brick stops on the length. It stands out by a quarter of its length from the brick on the head at the bottom, and thus the wall is saw-toothed. The previously built wall each brick is left on the head so that it will down away from the face of the wall about quarter brick and this works done between row and row. The thickness of an existing wall is to be exceed, it will be drilled with dimensions of 1/2x2x2 bricks per square meter of the wall. Non of them
Determine the y-coordinate of the centroid of the shaded area. y h 0.28h $57 V 57° Answer: ỹ = i
Please show complete solution thank you.
Determine the centroid of the shaded area
Who instructs change under NEC?
Which British Standard outlines the BIM Level 3 maturity level? BS 1088 BS 1192 (now ISO 19650) BS 1881 BS 6008 49°F Sunny
subtract the numbers 557 -125