In the experiment performed for the determination of cholesterol, the function of the calibration curve obtained using 25-400mg/dL standard cholesterol solutions was determined as y= 0.0009x. If the amount of cholesterol in the serum sample is determined as 3.11 g/L, what is the absorbance value of the sample?  A. 0,280  B. 0.028  C. 0.208  D. 0.82

Q: In the experiment performed for the determination of cholesterol, the function of the calibration…

A: Clinical chemistry mainly makes use of chemical processes that helps in measuring the chemical…

Q: A technician at a clinical laboratory received a blood serum sample for cholesterol analysis. In…

A: Total cholesterol in blood serum sample for observation was recorded as : 157 154 155 152 155 The…

Q: How do you find the serum albumin levels in a healthy human, in a human disease state with below…

A: More than fifty percent of the total protein in the serum of human blood is albumin. Albumin is…

Q: An IV bag of NS containing 30 g KCl is being administered at a rate of 80 mL/hr using a macrodrip…

A: A drug or medicine is a chemical molecule that, when consumed, has a biological effect on the human…

Q: 11. ● Possible methods for the quantitative determination of sodium bicarbonate for injection are:…

A: We'll answer the first question since the exact one wasn't specified. Please submit a new question…

Q: You have a mixture of the three molecules shown below that you are using Gas Chromatography to…

A: Gas chromatography-mass spectroscopy is actually two techniques that are combined to form a single…

Q: xplain why each of the following measurements is or is not the result of a Bernoulli trial: (a) The…

A: Bernoulli's trial is generally an experiment that leads to two outcomes for samples are success and…

Q: Explain why serum is preferred over plasma in most clinical chemistry assays.

A: Since you have asked multiple questions, we will answer only first question for you. In order to get…

Q: For the Motrin® dose, calculate how much (in mg) did Erthy consume for all three doses. To do that,…

A: Mrs Ab presented in the emergency with her 4 year old daughter Erthy .  Both feeling sick.  Erthy…

Q: BSA (mg/ml) Absorbancy 595nm 0 0.225 1 0.310 2 0.420 3 0.510 4 0.610 5 0.720 6 0.810 7 0.915 8 0.950…

A: The Bradford assay is quick and requires roughly the same quantity of protein as the Lowry assay.…

Q: 4 mL of 10% TCA solution was added to 1 mL of serum and after mixing, it was waited for two minutes…

A: Calibration graphs are used to estimate the concentration of unknown sample by plotting it against…

Q: constructing

A: NORMALITY ASSUMPTION : The normality is a property of random variable that is distributed according…

Q: From the following data, find the % (w/w) cream of tartar (KHC4H406, MM=188): Wt of sample = 1.4160…

A: Given: Mass of sample = 1.4160 g  NaOH used = 20.87 mL  = 0.02087 L   HCl used in back titration  =…

Q: You obtained the following raw data when setting up a Bradford standard curve:   BSA (mg/ml)…

A: Proteins are composed of twenty standard amino acids that differ from each other in their side-chain…

Q: A 26y female patient suffered from Ⅱ° and Ⅲ° burn of bilateral upper limbs, trunk and perineum,and…

A: Crystalloids have small molecules, are inexpensive and simple to administer, and give quick fluid…

Q: Please discuss the value of international normalized ratio (INR) as a test. Why do you think this is…

A: PT test is the normal blood test conducted to record the time taken for blood to clot.

Q: Recommend an appropriate dosage of digoxin for this patient given a trough digoxin concentration of…

A: Recommended appropriate level of digoxin is 0.5 to 2.0 ng/ml

Q: SOMOGYI-NELSON Method(clinical chemistry) a. What is the type of blood sample used and how much of…

A: Reducing sugars are sugars having reducing capabilities (due to the presence of a possible aldehyde…

Q: in basic spectrophotometer technique, 1. Calculate the concentration of bovine serum albumin (BSA)…

A: UV-visible spectroscopy is a fast and simple technique that finds the analyte concentration of a…

Q: A) how to explain that a venous blood looks purplish blue and an arterial blood appears bright red…

A: The color of the blood is primarily due to the presence of hemoglobin. Hemoglobin consists of…

Q: The drug dosage for the patient is calculated using a BSA of 1.9m2. If the order is 15mg per m2, how…

A: The drug dose refers to the quantity of a drug prescribed by the physician to be consumed at any one…

Q: For the TylenolTM dose, calculate how much (in mg) did Erthy consume for all six doses. To do that,…

A: Drug computations practice will help caregivers build better and more assured arithmetic abilities.…

Q: The amount of calcium in physiologic fluids can be determined by a complexometric titration with…

A: Titration is a common laboratory method of quantitative chemical analysis to deter mine the…

Q: explain what the results of this experiment are and the purpose Table 2   Absorbance vs CoCl2…

A: The Beer-Lambert Rule:  The concentration of the absorbing species and the route length of light…

Q: If the differences between the expected and observed values are large, the chi-square value will be…

A: Chi-square is a statistical method that examines the disparities between categorical data from a…

Q: How much NS was diluted? b. How much Gentamicin was diluted? c what is the desired concentration?

A: Question is related to drug calculation.  Available gentamicin dose is - 20 mg/ 2 ml Desired dose is…

Q: You are to prepare capsules that contain 0.125 g of a drug. You have four partial containers of…

A: The accuracy of the weighing is hundredth of a gram meaning the accuracy is 0.01 g. This scale can…

Q: Given the following data set, which cuvettes could be used to make a standard curve for absorption…

A: A standard curve is made using known quantities and it can be used to estimate unknown quantities.…

Q: You are administering tramadol to your patient. The order is for 600 mg. There are (3)…

A: Drugs are defined as the type of chemical substances of known structure. These substances are mainly…

Q: When determining CFUs for a dilution of the same sample at 10-2 and 10-3 which of the following…

A: CFU/mL means the number of colony forming units present per mL of the sample. In the above case, two…

Q: 6, If Mr. Strong is admitted to the hospital and administered Buprenex, how much will you draw up in…

A: Dose : It is defined as the amount of medicines that has to be taken orally or intravenously is…

Q: For the development of a new method in determining the glucose content of blood serum, you have…

A: Glucose present in our body provides us energy. Glucose is broken down into pyruvic acid by a…

Q: A technician at a clinical laboratory received a blood serum sample for cholesterol analysis. In…

A: Total cholesterol is the amount of low-density lipoprotein (LDL), high-density lipoprotein (HDL),…

Q: Using 25 uL of a patient's serum, how much diluent would be needed to create a 1:2 dilution? ______…

A: Blood is found in the human body's capillaries/veins/arteries, which are blood vessels that flow…

Q: u have a 0.75 mg/mL solution of bovine serum albumin (BSA).                               You add…

A: Bovine Serum Albumin or BSA is a standard protein used to plot standard curve for measuring the…

Q: Determine the type of acid-base imbalance and the corresponding compensation according to the…

A: Acid base imbalances in blood result in Respiratory and metabolic acidosis and alkalosis. Acidosis…

Q: After 1000 mL of solution is given to a patient via an IV, then 20 mL per minute was given. This…

A: A variable is a characteristic that can be assigned different values. There are two kinds on…

Q: You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml)…

A: In Bradford assay when the Coomassie Brilliant Blue G-25 dye is bound to the protein there is a…

Q: In a titration experiment, potassium iodate serves as the primary standard. Potassium iodate (KIO3)…

A: Potassium iodate (KIO3) - with 99.4% purity, weight 0.1498 g in 100 mL solution Molarity = number of…

Q: KCI for injection contains 40 mEq in 20 mL. An order requires 15 mEq, how many mL are needed?

A: KCI for injection is a drug which is used to treat patients with a deficiency of  potassium. This…

Q: B) A 45-ycars-old man has the following biochemical test in plasma: TSH <C05 mL 0.20-5.0) Free T4…

A: Thyroid Gland  Two lobed, butterfly-shaped endocrine gland that is present in the neck. It releases…

Q: In order to improve contract during X-ray diagnostics of soft tissues, contrast agents are used. For…

A: The mass attenuation coefficient is a measure of ease of penetration of a substance by light, sound,…

Q: Two students independently determine the volume of water delivered by a 10.00-mL pipet. Each student…

A: Given:The average value of student A= 10.4 mLThe standard deviation of student A= ±0.07 mLThe…

Q: A1 gm sample containing CaCO3 was burned so that all C03 was released from the model. If the…

A: Total sample = 1gm  Weight after firing = 0.560 gm Amount of calcium carbonate present in 1gm = 1-…

Q: The Kjeldahl method is commonly applied to food samples for the determination of total protein…

A: NOTE: Since you have asked multiple question, we will solve the first question for you. If you…

Q: Four lab groups completed the experiment listed in the lab diluting lul of FCF dye into 1ml of…

A: Brilliant blue FCF (Blue 1) is a synthetic organic compound used mainly as a blue dye for processed…

Q: Which of the following may be used to slow the heart rate?  A) Actose B) HCTZ C) Nifedipine D)…

A: This is multiple choice question.  Detailed solution in step 2.

Osmosis

In simple words, osmosis is the slow, gradual movement of a liquid through a membrane. But there are nuances to this process. For instance, there has to be an imbalance in the distribution of solute in the liquid on either side of the membrane, which has to be semipermeable. The liquid in the region with a lower solute concentration moves to the region with a higher concentration, thereby displacing the solution in the process. The objective is to equalize the concentration of molecules on both sides of the membrane; the displacement of liquid can be viewed as a byproduct of this equalization. Since there is no energy required to carry osmosis, it is considered a passive process.