In parallel RLC circuit if the circuit resistance is (60) Ohm and Inductor reactance is (95) ohm and the capacitor reactance is (6) Ohm, calculate the total circuit impedance. Add your answer
Q: Two signals mi(t) and m₂(t) with are given by m, (t)=3 cos (27171) m₂(t)=5cos(27271) The two signals…
A:
Q: How can you tell that a hologram is a true three dimensional image and that those in 3-D movies are…
A: A hologram is a true three-dimensional image because when the image is viewed from different angles…
Q: Find the average power delivered by the ide- al current source in the circuit in Fig. P10.7 if = 40…
A: Given circuit, Current, igt=40 cos 1250t mA Resistance, R=5 kΩ Capacitance, C=80 nF Inductance, L =…
Q: A magnetic circuit consists of two materials as shown in Fig. 3.48. The core has uniform…
A: We have an magnetic circuit as shown in figure with, lA = 80 cm = 0.8 m lB = 50 cm = 0.5 m a = 6…
Q: The bandwidth of a receiver with a 75-V input resistance is 6 MHz.The temperature is 29°C. What is…
A:
Q: Which of the following is true regarding the relative permittivity of the dielectric used for the…
A:
Q: An AC source with ΔVrms = 120 V is connected between points a and d as shown. At what frequency will…
A: The impedance of the given RLC series circuit is, Z=R+jXL+jXCZ=R2+ωL-1ωC2R=40 ΩL=185 mHc=65…
Q: If the absorption coefficient of silicon is 0.05 pm-1 at 860 nm, find the penetration depth at which…
A: Given, The absorption coefficient of silicon, α=0.05 μm-1 At wavelength, λ=860 nm And,…
Q: What does OS X has?
A: The solution is provided in the following section.
Q: 2) For a given short-circuit calculation utilizing the per unit method, a base voltage of 480 V and…
A:
Q: Draw the graph of the voltage across the 12K resistor in the circuit of Fig. No. 2, knowing that the…
A: Here, D1 and D2 are zener diode. So this circuit is worked as a double slicer i.e. combination of…
Q: Let xa(t) = sin (21000t). This signal is sampled with w, = 28000 and we have x[n] = xa (nTs), n = 0,…
A: Given: xa(t) = sin(2pi1000t) for this signal, we have to plot Fourier transform. then, convert…
Q: What should be installed to power the DC water pump, from [stream-turbine-motor-________- water…
A: It is asked to suggest an idea what should be installed to power the DC water pump.
Q: A 240-volt shunt motor takes 5 amperes on no-load. The armature resistance is 0.25 ohm and the field…
A: For a DC shunt motor: V=240 VoltNo load current :I0=5 AArmature resistance: Ra=0.25 ΩField…
Q: Determine the Fourier Series representation of the periodic signal whose period is defined by f(t) =…
A: Given: an expression for a periodic signal f(t) = 3 , -0.1+≤t≤0.1--2 , 0.1+≤t≤0.4- We…
Q: V = 36 V Refer to the figure at the right. iz What is the potential of point a with respect to point…
A: The given circuit diagram is shown below:
Q: What would be the inducesd voltage for a conductor moving at a speed of 25 km/h and having a length…
A: Given data, Speed of conductor, v=25 km/h Length, L=1 m Magnetic flux density, B=0.6 T
Q: Part 1. Determine the inverse z-transform using partial fraction expansion that results to a causal…
A: Note: We are authorized to answer one question at a time since you have not mentioned which question…
Q: Determine the value of the current i2 being supplied from the 2A source alone. Put your answer in…
A:
Q: question: Find the value of V
A: It is given that:
Q: A dc shunt motor runs at 900 rpm from a 460 V supply when taking an armature current of 25 A.…
A:
Q: If feedback resistor R₁ = 15k and input resistor R₁ = 5k. Then, The voltage gain of the…
A:
Q: Q5. Design Problem: Q5. Design a Voltage-divider D-MOSFET circuit that produces a voltage gain of -…
A: Given, R1=11×R2 , ID(Q)=7.6mA=7.6×10-3A VGS(Q)=0.35V , VDD=18V V1=1.5mv=1.5×10-3V, rd=30kΩ=30×103Ω…
Q: B) Show that the system shown in Figure (3) is equivalent to
A:
Q: Which of the following is equal to x₂ (n)? - 6. A. x₂ (n) = 2√5(0.4419) cos(1.1071 +2.3562n) u(n −…
A: 6) The function X(z) is given as Xz=5z-21-5z-1+11z-2-15z-3Xz=5z21-5z+11z2-15z3Xz=5z2-5z+11-15z
Q: 2. The variable resistor R in the circuit is adjusted until it absorbs the maximum average power.…
A: In order to find the value of R and maximum average power Find the Thevenin's equivalent voltage…
Q: Consider the sinusoidal voltage v(t) = 80 cos (1000nt -30°) V. A. What is the maximum amplitude of…
A: Given data, Voltage equation is given, vt=80cos1000πt-300 V Standard equation is given by,…
Q: Q.32 Find V, in the network shown 5Ω www. 5A (1) A 5Ω 101₁ 5Ω www 5Ω 10V(+)
A:
Q: A dc machine is connected across 230 V supply and runs at 1200 rpm generating as emf f 210V with an…
A:
Q: Electrostatics Two bidirectionally infinite line charges exist in vacuum. One has a charge density…
A:
Q: If the absorption coefficient of silicon is 0.05 pm-1 at 860 nm, find the penetration depth at which…
A:
Q: What is the z-transform of: x(n) = n7nu(-n-1)
A:
Q: Using sum-by-column method, solve the following problem: a) An finite impulse response (FIR) filter…
A:
Q: conductivity
A: Given :- Conductivity of material. To find :- Factor not affecting the Conductivity of material.…
Q: Design an 8-4-2-1 BCD code converter to drive a seven-segment indicator. The four inputs to the…
A:
Q: Develop the graph of the network shown infigure given obtain the (i) incidence matrix. (ii) reduced…
A: Since you have asked multiple questions in a single request, we will be answering only the first…
Q: Problem 2) Determine the output time function. y(t), from the convolution integral y(t) =…
A: According to Laplace transforms
Q: 8 + 12.5 Ω www Camuto 2011 και άλλοι 15 Ω -j25 Ω The voltage V₂ is 360 at angle 0° Vrms (360 Vrms at…
A: Given circuit: Vg=360∠0° V
Q: 0 2230 + 5490 v(e) U (P)? 2 0 240° ] 16-20° 3/45° 1690° (2+3690) J T10L0"
A:
Q: 17. If the insulation resistance of a cable of length 10 km is 1 MQ, its insulation resis- tance for…
A: Given: Insulation resistance of cable, R1=1 MΩ For length, l1=10 km Insulation resistance of cable,…
Q: Determine the output time function, y(t), from the convolution integral y(t)=√ h{t=t\r{t}dt where…
A:
Q: NMOS transistor are given below. What are the values of Kn and VTN for this transistor? Is this an…
A:
Q: To access the services of the operating system, the interface is provided by the a) Library b)…
A: The correct option along with the explanation is provided in the following section.
Q: A proton travels with a speed of 5.0x106 m/s in a direction that makes an angle of 60.0° with the…
A: Given data, Velocity of proton v=5×106 m/s Angle θ=600 Magnetic field B=7.5 T Charge on proton…
Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.
A:
Q: To access the services of the operating system, the interface is provided by the
A: The correct option along with the explanation is provided in the following section.
Q: Two generators, each having no-load voltage of 500 V, are connected in parallel to a constant…
A:
Q: Vact) Question: + √x 1052 ja(t) 5mH ron 2mH roood v(t) 55 use 10 MF It Va (t) = 100 cos ( lowt - 30…
A:
Q: 14.3.1 - What external circuitry needs to be connected to an 12C bus due to the nature of its…
A: NMOS transistors needs to be connected to I2C bus due to it's open drain transmitter architecture .…
Q: A series RLC circuit has a resistance of 7.5 , a capacitance of 10-2 F, an inductance of 1/6 H, and…
A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.
Step by step
Solved in 2 steps with 1 images
- An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
- A 500 V dc source is impressed across two capacitors, 25 microfarad and 12.5 microfarad in series. How much energy is stored in the 25 microfarad capacitor? Draw the diagram.A series RC circuit contains two resistors and two capacitors. The resistors are 39 ohms and 68 ohms. The capacitors have capacitive reactances of 60 ohms and 50 ohms. The applied voltage is 240 V. What is the voltage drop on the capacitor that has 60 ohms of reactance?a capacitor and a resistor are connected in parellel to a 120 v 60 hz line the resistor has a resistance of 40 ohms and the capacitor has a capacitance of 132.6 uf what is the total current flow through the circuit. what is the impedence and the power factor and how many degrees out of phase are the current and voltage out phase with eachother.
- A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.QUESTION 6 A resistor, a capacitor, and an inductor are connected in series with a mystery component. The resistor has a resistance of 1000, the capacitor has a reactance of 5000, and the inductor has a reactance of 2000. The total impedance of the circuit is 100-j4000. What is the mystery component? O there is no mystery component O inductor O resistor O capacitorA resistor with a resistance of 50 2 is connected in parallel with an inductor with an inductance of 0.175 henry. The power source is 60 Hz. What is the impedance of the cir- cuit? Letod ed
- Question 4 A boost converter has an input of 5V and an output of 20W at 15V. The minimum inductor current must be no less than 50% of the average. The output voltage ripple must be less than 1%. The switching frequency is 30kHz. Determine the duty ratio, minimum inductor value, and minimum capacitor value. Verify your answers using Matlab, show the inductor current is continues and its minimum is no less than 50% of its average. Furthermore, the output voltage ripple is less than 1%.Please solve fast ,Have very less time. Do correctly . What is the total inductance in the circuit in Figure 13-1? A) 2600 uH B) 2100 mH C) 602 mH D) 800 mH5. A Series RLC circuit consists of a 25-ohm resistor, a 0.221-henry inductor and a 66.3 microfarad capacitor. What should the voltage be if the current flowing through the series circuit is 2.5 Amperes?