In designing a signal-switching circuit (RC circuit), it was found that a 100-µF capacitor was needed for a time constant of 3 ms. What value resistor is necessary for the circuit? The resonant circuit for a radio broadcast consists of a 120-pF capacitor in series with a 240-µH inductor and a resistance of 400 2, what is the resonant frequency of the circuit? What would be the resonant frequency if the resistance were reduced to 40

In designing a signal-switching circuit (RC circuit), it was found that a 100-µF capacitor was needed for a time constant of 3 ms. What value resistor is necessary for the circuit? The resonant circuit for a radio broadcast consists of a 120-pF capacitor in series with a 240-µH inductor and a resistance of 400 2, what is the resonant frequency of the circuit? What would be the resonant frequency if the resistance were reduced to 40

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Similar questions

A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277 V is connected to the circuit. What is the total circuit current at the resonant frequency?
Calculate the bandwidth in kHz Blank 1 and an inductor's Q Blank 2 at100MHz. It has an inductance of 6mH and a series resistance of 1.2k2.
At what frequencies will the output waveform be half-wave rectified? A full-wave rectified?
In a series resonant circuit, the resonant frequency is to be reduced. If only capacitance can be changed, then how the capacitance should be altered? Increaased or decreased?
Calculate the parallel resonant frequency of the crystal if a 2-pF capacitor is placed in parallel with the crystal. Repeat for a 20-pF capacitor.
Describe what happens to the current in this RC series circuit as the frequency increases. Explain in general terms why the observed change should occur.
In a series RLC circuit, the applied voltage is 120V. At resonance, the frequency is 200rad/sec, and the circuit current is 6.26 A. What is the resistance of the circuit (in Ohms)? (Use 2 decimal places. Unit is not required.)
In a series RLC circuit, the applied voltage is 108V. At resonance, the frequency is 200rad/sec, and the circuit current is 8.38 A. What is the resistance of the circuit (in Ohms)?
H.W: A resistor of resistance R-1000 2 is maintained at 17 °C and it shunted by 100 uH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x109 volt ii) iii) Ans: 9.22 x10-8 volt Ans: 2.34 x10-6 volt 159 kHz 1590 kHz
100 used to compand A companding system with u from 0V to 10 V sinusoid signal. Draw the characteristic of the typical system.
Find DFT values of x-[6 87 4] and plot amplitude and phase spectrum. Write axis labels.
A full-wave rectified voltage of 18 V peak is connected to a 400micro F filter capacitor. What are the ripple and dc voltages across the capacitor at a load of 100 mA?