In cross circuits, how do i know the resistances are in parallel or in series connection?

Q: An unbonded strain gauge shown in figure 1 is used to measure pressure. As the pressure is applied…

A:

Q: (Note that VO=V01+V02, where Vo1 is due to V1 and Vo2 is due to 11) V02 (in volt) due to 11 only= O…

A:

Q: RL IL b 1.5 kN R3 6.8 kN R21.2 kN E+ 8 V R3 1.0 kN figure d

A:

Q: How are Kirchhoff's laws of voltage and current, and the series and parallel circuit analysis…

A: Krichhoff's law of Current :-  It is defined as the sum of the current entering the node is equal to…

Q: E,=? R₁=552 V₁ = 2V in R3=1532 For this DC series circuit, what is the value of Etotal? 12V 30V 0.4V…

A: In this question, we need to determine the voltage Etotal  as shown in circuit.

Q: For given value of the circuit, Vsupply = 120 V, and with R₁= 2002, R₂=30.0, R3=75, R4=3052, R5=…

A: Given: Circuit diagram with the voltage source and the resistances.

Q: Briefly describe the effect of putting an infinite number of resistors in parallel

A:

Q: Explain what is a parallel circuit

A: In parallel circuit two or more elements connected in parallel

Q: Consider four resistors in parallel connection: R1 = 3520.45 Q, R2 = 33.09 Q, R3 = 1484.22 Q and R4…

A: We know that whatever 3 resistors are connected in parallel there equivalent resistance is given as…

Q: 9. What resistance must be connected in parallel with a 20-N and a 600 resistor in parallel in order…

A: The solution is given below

Q: Q5 On a common set of axes, plot the v-i characteristics for resistors R₁ = 4.7k²2, R₂ = 47k52, R₂ =…

A: Resistor The resistor is the behavior of the material or a substance due to which it tries to resist…

Q: Three resistance of 6 , 12 and 16 are connected in star connection. Find its equivalent delta…

A: We have been given three resistance with, R1 = 6 Ω R2 = 12 Ω R3 = 16 Ω   This three resistance are…

Q: What is the total conductance of 4-, 10-, 16-, 20-, and 24-S resistors connected in series?

A: Given conductance values are - G1=4SG2=10SG3=16SG4=20SG5=24S Given that all resistance are connected…

Q: 6- What is the total resistance of the mixed circuits shown in the following Figure? Note that each…

A:

Q: 1. Using Series-Parallel concept, Find the following for the given circuit. The value of "I" is…

A: Given, The circuit diagram, R1=16 KΩR2=20 KΩR3=32 KΩR4=20 KΩR5=32 KΩ Value of current I=4 mA

Q: For R1=9, R2=1, R3=1, R4=1 and 15-13.5 A in the shown circuit, use current divider to find the…

A: CURRENT DIVISION Parallel circuits in which the source or supply current divides into a number of…

Q: find the three resistance

A:

Q: Now, double the value of R1 and R2. Disconnect the load and make sure that VNL (No Load) is the same…

A: Take the following actions to find out if the loaded voltage divider with doubled R1 and R2 values…

Q: Use Multisim Schematics to create the voltage divider circuit in Figure 2. Run the simulation to…

A: The given circuit isWe need to measure the voltage across each resistor (i.e V1, V2 and V3) and the…

Q: A conductor has a resistance of R. It was cut into twelve even pieces. Six of them are connected in…

A: Given a conductor has a resistance of R, it was cut into twelve even pieces, Six of them are…

Q: Q6 In following circuit a resistor of 10k Q and inductor 2 mH is connected across 240 V and 50HZ…

A: If a sinusoidal signal is given as input to a circuit with only passive elements (R,L,C), then the…

Q: in +1 Find sensitivity of voltage divider of R2 can be changed. Nominal value of R₁-2002 and R2-100…

A: Given circuit: Vin=10 VR1=200 ΩR2=100 Ω

Q: A circuit has a resistance of 200 and resctance of 30-ohms. What is the power factor of the circuit

A:

Q: Resistors are said to be connected in series when two circuit elements connect at a single loop.…

A:

Q: Soru 4) Yukandaki devrede R1=59, R2=5 ohm, C1=0.1F, C2=0.2F olduğuna göre transfer fonksiyonu H(s) =…

A: The transfer function of the given circuit across the circuit element needs to be obtained.

Q: What are the number of branches, notes and loops in the below figur 10 V 20

A:

Q: From the given figure, the current in resistance 6 is i6 = 1.40 A and the resistances are R1 = R2 R3…

A: We need to find out current for given circuit

Q: For the circuit in the figure, find the ones requested in the questions by using the following…

A: In the question, MOSFET is given  Given data VT =2.99 V, ID(on) =5.54 mA, VGS(ON) =5.3 V Find the…

Q: State Kirchoff's current Law. O None of these sum of all powers in a circuit O sum of all emfs in a…

A: Kirchhoff's Laws: Kirchhoff's current law, Kirchhoff's voltage law Kirchhoff's current law:…

Q: n resistors each of resistance R when connected in series offer an equivalent resistance of 50 ohm…

A: Given, n resistors each of resistance R when connected in series offer an equivalent resistance of…

Q: Task 2 i. What are choices to make a voltage divider circuit to step down the source voltage from…

A: PART (1): To make a voltage divider circuit which steps down the source voltage is show in the…

Q: Consider three resistors in the figure: R1 = 29.270, R2 = 33.090, R3 = 42.972 and R4 = 3.60. What is…

A: The solution is given below

Q: How do I go about solving this problem?  To solve thus problem, I know there needs to be 5 equations…

A: Using junction ruleAt node A

Q: Fill in the blanks: (a) Connect the 5.6 kohms, 4.7 kohms and 1.2 Mohms in series. The measured total…

A: Given: Three resistors are 5.6kΩ, 4.7kΩ and 1.2MΩ. Need to calculate equivalent resistance if…

Q: 1X= 3 X2= -3 X3= 12

A: Given circuit is - Given values are - X1=3AX2=-3AX3=12A

Q: why is the total parallel resistance less than the smallest resistance

A:

Q: MAKE ONE ORIGINAL WORDED PROBLEM WITH DIAGRAM AND ITS FREE BODY DIAGRAM FOR OHMS IN SERIES…

A:

Q: From the figures, why does a parallel circuit/connection have more current?  What does this mean?…

A: In series circuit: 1.All the resistors are connected in series to the supply voltage.  2.Current…

Q: *** *** *** . V1 9 V. . R1 -W 1.0KQ R3 W 1.0KQ *** R5 >1.0KQ **** *** R2 1,0KQ R4 -W 1,0KQ **…

A:

Q: A secondary cell having an e.m.f. of 7V and an internal resistance of 2.5 is connected in series…

A: For the given primary and secondary voltages and internal resistances, Voltmeter reading and current…

Q: Draw circuit consisting of two resistors in parallel and one resistor connecting with their…

A: when two resistors starting and finishing terminals are connected together than resistors are said…

Current Division Method

The generalized current divider formula is given by the following relation below,