6- What is the total resistance of the mixed circuits shown in the following Figure? Note that each resistor has resistance 6.00. (a) R₁ R5 R₂ R3 R₁ (b) R₁ Em Em R₂ R3 R₁ R₂ سرت www

6. The main difference between resistance R and capacitive reactance X, is that (a) Xc is the same for both DC and AC signals, where R depends on frequency of the AC signal (b) R is the same for both DC and AC signals, where X depends on the frequency of an AC signal (c) R is measured in ohms and X is measured in farads (d) None of the above

If the frequency of the input voltage in the figure below is increased, the frequency of the output signal will be: (a) increases (b) decreases (c) does not change

Help with proper measurement of current through all resistors in the parrallel cirucit below, in multisim.

C2 The next two questions refer to the following figure. The switch is initially open and both capacitors are initially uncharged. All resistors have the same value R, and both capacitors have the same value C. R2 R3 bat R1 ww (f) 1 pt. Immediately after the switch is closed, which resistor has the most current through it? (i) R1 (ii) R2 (iii) R3 (iv) Rị and R2 (v) R2 and R3 (vi) All have the same current (g) 1 pt. A long time after the switch is closed, which resistor has the most current through it? (i) R1 (ii) R2 (iii) R3 (iv) R1 and R2 (v) R2 and R3 (vi) None have current

Fill in the blanks for Ampacity, Voltage, Power and Resistance.