Can I get help with this homework question, please?In an RLC circuit, L = 0.1; H,; R = 0.6; Omega,; C = 0.4; F, and E (t) = 60; V. Find the charge at time t . Assume the initial charge on the capacitor is 0 C and the initial current is 7.25 A. In an RLC circuit, L=0.1; H₂; R=0.6; 2₁; C=0.4;F, and E(1) = 60; V. Find the charge at time 1. Assume the initial charge onthe capacitor is 0 C and the initial current is 7.5 A.ABq (t) = - 16.125e-³% sin(4x) - 24e-³% cos(4x)-3x-3xq(1) = -16.125e "sin(4x) - 24e cos(4x) +24-3xq(1) = e "sin(4x) - 24e-³* cos(4x) +243xq (1)=e³ sin(4x) - 24e 3* cos(4x) +24

Given dataInitial charge, Initial current, To find outExpression for the charge

In an RLC circuit, L = 0.1; H₁; R=0.6; 22,; C=0.4;F, and E(1) = 60; V. Find the charge at time 1. Assume the initial charge on the capacitor is 0 C and the initial current is 7.5 A. Aq(t)=-16.125e-3% sin(4x) - 24e-3% cos(4x) Bq(1)-16.125e-3 sin(4x) - 24e-3% cos(4x) +24 q (1)=e-³ sin(4x) - 24e-3% cos(4x) +24 q(t)=e³ sin(4x) - 24e3 cos(4x) +24

In an RLC circuit, L = 0.1; H₁; R=0.6; 22,; C=0.4;F, and E(1) = 60; V. Find the charge at time 1. Assume the initial charge on the capacitor is 0 C and the initial current is 7.5 A. Aq(t)=-16.125e-3% sin(4x) - 24e-3% cos(4x) Bq(1)-16.125e-3 sin(4x) - 24e-3% cos(4x) +24 q (1)=e-³ sin(4x) - 24e-3% cos(4x) +24 q(t)=e³ sin(4x) - 24e3 cos(4x) +24

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Consider the circuit in figure given below: A B The capacitor C is initially charged. At time 0, the switch is connected from A to B and the voltage across the capacitor is measured. The following data are recorded by a data acquisition system: t(s) 0.0 0.1 0.2 0.3 0.4 0.5 V(V) 4.98 1.84 0.68 0.25 0.09 0.03 (a) Determine the linear correlation coefficient betweent and V. (b) Determine the linear correlation coefficient between t and In(V).
A 10-9.F capacitor (1 nanofarad) is charged to 50 V and then disconnected. One can model the charge leakage of the capacitor with a RC circuit with no voltage source and the resistance of the air between the capacitor plates. On a cold dry day, the resistance of the air gap is 3× 1018 2, on a humid day, the resistance is 6 × 10° 2. How long will it take the capacitor voltage to dissipate to half its original value on each day? ... On the dry day, it will take seconds.
A parallel plate capacitor has an electrode area of 100 mm2 , with spacing of 0.1 mm between the electrodes. The dielectric between the plates is air with a permittivity of 8.85*10-12 F/m. The voltage on the capacitor is 100 V. The stored energy in the capacitor is ?
The current in a 20 mH inductor has the waveform shown in Figure Q1(c). Draw the waveform for the inductor voltage. i(t) (mA) 20 – 2 t (ms) Figure Q1(c)
A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads
Find the equivalent circuit of the given circuit. Voltage across inductor at t=39micro second. Also find the equation for the current and the voltage. Time constant of the circuit?
A paralel-plate capacitor is constructed using a dielectric material whose dielectric constant is 2.40 and whose dielectric strength is 3.00 x 10" wm. The desired capacitance is 0.100 g, and the capacitor must withstand a maximum potential difference of 4.00 kv. Find the minimum area of the capacitor plates. Jm²
Please draw the problem and answer, thank you. A capacitor is made of 2 rectangular metal plates with side length of 3 cm x 6 cm separated by a distance of 2.36 cm with water in between the plates. The capacitor has a voltage of 110 v and is not connected to a battery. Calculate the capacitance. What is the new capacitance if we replace water with a new dielectric material with a constant of 3.75 in between the plates? What is the new voltage? What is the charge on each plate?
1. Find the voltages across the following components (a and b) after 1 second. The Capacitor is initially charged at 10V while the voltage source is 1V. Resistor R is 103 ohm while capacitor C is 1mF. a. Capacitor C b. Resistor R c. What is the best 1st order DE Method applicable to this problem?